VIGO VG06061 Bedienungsanleitung

VIGO INDUSTRIES INSTALLATION GUIDE FOR

STANDING SHOWER CABIN (MODEL VG06061)

SAFETY PRECAUTIONS

This Installation Guide uses the following symbols to indicate important information.

Always observe the instructions indicated by these symbols.

WARNING

Instructions that, if ignored, could result in death or serious personal injury caused by

incorrect handling or installation of the product. These instructions must be observed for

safe installation.

CAUTION

Instructions that, if ignored, could result in personal injury or material damage caused by

improper handling or installation of the product. These instructions must be observed for

safe installation.

IMPORTANT

Maintenance and other important non-personal injury and non-material damage instructions

or statements that should be observed.

MODEL VG06061 2

VIGO INDUSTRIES INSTALLATI ON GUIDE FOR

STANDING SHOWER CABIN (MODEL VG06061)

PACKING LIST:

1. Wall connector (2pc)

2. Structural arm (2pc)

3. Support assembly (2pc)

4. Side glass panel (with

hinge slots, 1pc)

5. Side glass panel (without

hinge slots, 1pc)

6. Side seal strip (2pc)

7. Glass support (4pc)

8. Hinge (2pc)

9. Bottom rail (3pc)

10.Door magnetic seal strip

(2pc)

11.Bottom corner joint (2pc)

12.Handle assembly (1pc)

13.Door (1pc)

14.Door side seal strip (2pc)

15.Door bottom seal strip (2pc)

16.Phillips screw 1-1/8” (4pc)

17.Phillips screw 2” (8pc)

18.Phillips screw 3/4” (4pc)

19.Plastic anchors (16pc)

MODEL VG06061 3

MODEL VG06061 4

WARNING

WE STRONGLY RECOMMEND THAT A LICENSED PLUMBER INSTALL THIS STANDING SHOWER

CABIN AND INCLUDE THE ASSISTANCE OF A SECOND PERSON TO INSTALL THE DOOR UNIT.

INSTALLATION OF THE SHOWER DOORS BY AN INEXPERIENCED PERSON MAY RESULT IN

GLASS BREAKAGE AND, CONSEQUENTLY, CAUSE PERSONAL INJURY OR DEATH.

BEFORE STARTING

Compare items on your invoice with what you have received. Carefully review the Packing List on page 2.

If any item is missing, please call Vigo Industries at 1-866-591-7792.

REQUIRED TOOLS

oSquare and/or Phillips #1 and #2 screwdriver

oFlat head screwdriver

oElectric drill plus a 1/8”, 3/16”, or 7/32” drill bit (depending on wall)

oLevel

oMeasuring Tape

oPencil (non-permanent; HB)

oClear silicone caulking

oUtility knife

WARNING

•Handle fragile items with care to prevent personal injury or material damage.

•Glass on panels and doors is tempered glass and must never be cut to prevent personal injury.

IMPORTANT

•Fiberglass or acrylic construction might not be sufficiently strong enough to support the shower door

enclosure. You should use the wood framing from behind the face edge of the stall to provide a secure

mounting to the door. Apply a bead of silicone between the walls and base of the stall.

•For optimum performance, you should install the shower door perfectly level on a level surface.

MODEL VG06061 HAS A REVERSIBLE DOOR AND CAN THEREFORE BE INSTALLED TO EITHER

THE RIGHT OR LEFT SIDE (SEE CONFIGURATION DIAGRAM BELOW)

MODEL VG06061 5

PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION

1. Remove the plastic layer from the base border (if needed). Do NOT remove the plastic layer

off the plastic platform of the base.

2. Properly apply silicone to the wall and base joints.

IMPORTANT

•To prevent damage to the finish, you should protect the shower

cabin bottom with a cardboard protector before beginning the

installation.

•Ensure that there is sufficient structural support behind the

shower wall to hold the weight of the shower door. If there is not

sufficient enough support, then reinforce the shower walls with

wooden studs prior to shower door installation. [SEE FIG.1]

INSTALLATION STEPS

A. INSTALLING THE BOTTOM RAIL

CAUTION

OUTSIDE EDGE OF THE BOTTOM RAIL IS HIGHER THAN THE INSIDE EDGE

1. Slide the bottom corner joint (#11) onto the bottom rail (#9). [SEE FIG.2]

2. Align the bottom rail and corner joint to the desired position on the shower base. Make

sure that the A and B distances are correct (see pg. 2 for A and B distances).

3. Seal the bottom rail with clear silicone caulk and center its sides to the base.

4. Apply silicone to the 3/4” screw (#18) threads. [SEE

FIG.2A]

5. Screw the bottom rail to the base with the screws.

6. Clip the aluminum cover on to the center piece of the

bottom rail.

MODEL VG06061 6

B. INSTALLING THE SIDE GLASS PANEL

1. Arrange the glass panel to the preferred configuration (see diagram on pg. 3).

2. Select the door opening location on the shower cabin.

3. Install the side seal strip (#6) to the wall side of the hinged side glass panel (#4). [SEE

FIG.3]

4. Screw the glass support (#7) to the side glass panel using the hex key (supplied). Use a

washer on each side of the side glass panel.

5. Place the side glass panel on the bottom rail (#9). Use the level to accurately position

the panel.

6. Mark holes on the wall for the mounting screws.

7. Remove the side glass panel. Drill holes into respective marks and insert plastic

anchors (#19) inside them.

8. Place the side glass panel back onto the bottom rail and screw it to the wall with 2”

screws (#17).

9. Repeat Steps 1 through 8 for the unhinged side glass panel (#5).

MODEL VG06061 7

C. INSTALLING THE HANDLE

Assemble the door handles (#12) to the door (#13).

[SEE FIG.5]

D. INSTALLING THE HINGE

1. Clean the glass surfaces on the side glass panel (#4) where the

hinges (#8) are to be installed with rubbing alcohol.

2. Position hinges on the side glass panel. [SEE FIG.6]

3. Place washers on each side of the side glass panel. Screw the hinges to the side glass

panel with the hex key (supplied).

MODEL VG06061 8

E. INSTALLING THE WATER SEAL STRIP

1. Clean the side glass panel (#4) edges where the door side seal strip (#14) and the door

bottom seal strip (#15) are to be installed with rubbing alcohol.

2. Cut the seal strips according to the diagram. [SEE FIG.7]

3. Verify that the lips of both seal strips face toward the inside of the shower cabin before

seal strip installation.

4. Install the seal strips according to the diagram.

MODEL VG06061 9

F. INSTALLING THE DOOR P AN E L

WARNING

DOOR PANEL INSTALLATION REQUIRES TWO OR MORE PEOPLE TO ASSIST

1. Clean the door (#13) glass surfaces where the hinges (#8) are to be installed with

rubbing alcohol.

2. Position the door onto the hinges. Hold securely in place.

3. Place a thin gasket (supplied) on each side of the door between the glass and hinge

while holding the door in place.

4. Install the hinges as illustrated (FIG.8). Use the hex key supplied.

G. INSTALLING THE SIDE & FRONT PANEL SUPPORT

1. Install the support assembly (#3) onto the side glass panel (#4) approximately two-thirds

away from the wall. Use hex key to tighten the screws. [SEE FIG.9]

2. Install the support assembly to the structural arm (#2) and wall connector (#1).

3. Mark holes on the wall for the mounting screws.

4. Remove the support assembly. Drill holes into respective marks and put plastic anchors

(#19) in them.

5. Replace wall connector to proper position. Screw it in to the wall with 1-1/8” screws

(#16).

6. Tighten all screws.

MODEL VG06061 10

7. Repeat Steps 1 through 6 to install the other support assembly to the other side glass

panel.

H. APPLYING THE SILICONE

1. Apply silicone caulk from the inside between the wall and side seal strips.

2. Apply silicone caulk from the inside between the bottom of side glass panels (#4, #5)

and bottom rail.

3. Apply silicone caulk around the inside perimeter of the bottom rail.

IMPORTANT

•WAIT 24 HOURS BEFORE USING

SHOWER.

•DO NOT ALLOW WATER TO DIRECTLY

HIT DOOR SEAL STRIP.

Inhaltsverzeichnis

Andere VIGO Badezimmerarmatur Handbücher

VIGO

VIGO VG07049 Bedienungsanleitung

VIGO

VIGO VGO1028 Bedienungsanleitung

VIGO

VIGO VG15800 Bedienungsanleitung

VIGO

VIGO VG08007 Bedienungsanleitung

VIGO

VIGO VGRA3618BLFL Bedienungsanleitung

VIGO

VIGO VG07047 Bedienungsanleitung

VIGO

VIGO NOMA V601009 Bedienungsanleitung

VIGO

VIGO VG030002 Bedienungsanleitung

VIGO

VIGO VG06041 Bedienungsanleitung

VIGO

VIGO VGRA3318BL Bedienungsanleitung

VIGO

VIGO VGR3620BL Bedienungsanleitung

VIGO

VIGO VG030002 Bedienungsanleitung

VIGO

VIGO VG08006 Bedienungsanleitung

VIGO

VIGO VG04013 Bedienungsanleitung

VIGO

VIGO Cass VG6044 Bedienungsanleitung

VIGO

VIGO VG08001 Bedienungsanleitung

VIGO

VIGO Farmhouse VGR3320C Bedienungsanleitung

VIGO

VIGO VG04052 Bedienungsanleitung

VIGO

VIGO VG08005 Bedienungsanleitung

VIGO

VIGO Niko VG03024CH Bedienungsanleitung

VIGO

VIGO VG151029 Bedienungsanleitung

VIGO

VIGO VG06045 Series Bedienungsanleitung

VIGO

VIGO VG06046 Bedienungsanleitung

VIGO

VIGO VG01015 Bedienungsanleitung

Beliebte Badezimmerarmatur Handbücher anderer Marken

DURAVIT

DURAVIT C.1 C15240 0090 Handbuch

Heatstore

Heatstore HSTRL500WTN Bedienungsanleitung

Sunshower

Sunshower PURE SOLO Bedienungsanleitung

Delabie

Delabie Delabie Sporting 714700 Bedienungsanleitung

Kohler

Kohler K-13056 Montageanleitung

ESS

ESS Container TCL-11 Bedienungsanleitung

Mustee

Mustee 22C Bedienungsanleitung

VITRA

VITRA V-Flow Bedienungsanleitung

baliv

baliv DUK-80.30 T Bedienungsanleitung

Malmet

Malmet B105BT Bedienungsanleitung

bathstore

bathstore Transition H1690MM Leitfaden

BELLOSTA

BELLOSTA Edward 0800/M Bedienungsanleitung

baliv

baliv DU-5160 Bedienungsanleitung

Franke

Franke PRTR0006 Bedienungsanleitung

Gessi

Gessi RILIEVO 59011 Bedienungsanleitung

noken

noken VITAE 100188525-N299998810 Bedienungsanleitung

Allen + Roth

Allen + Roth 1142VA-30-201 Bedienungsanleitung

Britex

Britex HBDA Bedienungsanleitung