Viking Professional VEWD173 Bedienungsanleitung

SMC-0016

April 2010

VEWD173

VEWD103

VEWD163

DEWD102

DFWD171

DFWD101

This Base Manual covers general and

specific information including, but not

limited to the following models:

Service

Manual

This manual is to be used by qualified appliance technicians only. VIKING

does not assume any responsibility for property damage or personal injury

for improper service procedures done by an unqualified person.

Safety Information

SAVE THESE INSTRUCTIONS

REVIEW ALL SERVICE INFORMATION IN THE APPROPRIATE SERVICE MANUAL AND TECHNICAL SHEETS

BEFORE BEGINNING REPAIRS.

Pride and workmanship go into every product to provide our customers with quality appliances. It is possible,

however, that during the lifetime of a product service maybe require. Products should be serviced only by a qualified

authorized service technician who is familiar with the safety procedures required to perform the repair and is equipped

with the proper tools, parts, testing instruments, and the appropriate service manual.

Safety Information

We have provided many important safety messages

throughout this manual and on the product. Always

read and obey all safety statements. To properly

identify a safety statements look for the following

safety alert symbol.

This symbol alerts personnel to hazards that can

many different types of altering messages. All safety

messages will be preceded by a safety alert symbol

and the word “DANGER”, “WARNING” or

“CAUTION”.

DANGER

Immediate hazards which WILL result in severe

personal injury or death.

WARNING

Hazards or unsafe practices which COULD result

in severe personal injury or death.

CAUTION

Hazards or unsafe practices which COULD result

in minor personal injury, product or property

damage.

All safety messages will identify the hazard, tell you

how to reduce the chance of injury, and inform you

what can happen if the instructions are not followed.

WARNING

To avoid risk of serious injury or death, repairs

should not be attempted by unauthorized

personnel.

CAUTION

VIKING will not be responsible for any injury or

property damage from improper service

procedures. If performing service on your own

product, you must assume responsibility for any

personal injury or property damage which may

result.

Table of Contents

Description Page

GENERAL INFORMATION

Safety Information………………...................... 2

Table of Contents………………..................... 3

DISASSEMBLY

Control Location and access ….…………........ 4

Terminal Block and Control access …….…..... 5

Drawer removal ….......…………………….….. 6

Thermostat and heating element location.....….. 7

Model and Serial location…………………………7

Element and Thermostat removal……………….. 8

ELECTRICAL

Wiring Diagram……………………………………. 9

PARTS BREAKDOWNS

Control Area .................................................... 10

Drawer Area .................................................... 11

Lower Unit Area .............................................. 12

Exterior Area ................................................... 13

Door Area ....................................................... 14

DISASSEMBLY

VEWD / DEWD / DFWD –Warming Drawer

The 30"Built-In warming drawer is shown below (FIG 1) with the front door assembly removed. When the

drawer is extended out you will have access to the temperature control (FIG 2 inset)

The temperature range of the warming drawer is between 90°F(Min) to 250"F(Max) The

temperature is control by the thermostat. In order to gain access to the thermostat and power

connections, removed the unit from the cabinet to expose the right side access panel. FIG 3

shows the cover installed (Outlined with dotted red line)

Remove the 3 Phillips Head screws to access the main terminal block. In FIG 3 we see the

opening in the rear of the warming drawer for the Romex power supply line (Supplied by

electrician).

FIG 1

FIG 3

FIG 4

FIG 2

Romex cable

inlet

DISASSEMBLY

With the side panel removed, access to the main terminal block is possible. FIG 5 shows the main

terminal block. The Romex cable is feed through the cable hold down clamp (Circled), and then

the power connections are made at the terminal block.

FIG 6 shows the Component compartment where the thermostat control is housed. The Capillary

tube of the thermostat is routed through the side wall to the sensor. In this same location is where

the heating element connections are located. One side is wired directly to Neutral. The other to

the Thermostat. The indicator lamp is directly above the thermostat (Not shown)

FIG 5

Line Ground Neutral

Heating

Element

connections

Thermostat

bulb

FIG 6

Thermostat

connections

DISASSEMBLY

To gain access to the heating element and thermostat sensor bulb, it will be necessary to remove

the draw assembly. With drawer fully extended, release the draw by lifting up on the locking tabs

(one on each side) FIG 7shows the location of the locking tabs.

FIG 8 shows the draw being lifted away from the drawer tracks. Remove and place on a protected surface.

Lift up on

each side

FIG 7

FIG 8

DISASSEMBLY

With the drawer removed we now have access to the thermostat bulb and heating element. FIG 9 shows the

location of the Model and Serial number location, thermostat senor bulb and the left and right rear door catch

assemblies (Circled in red).

Fig 10 shows a close-up of the thermostat cap tube routed through the hold down clamp and the senor bulb in

its mounting bracket.

Model / Serial

information

Thermostat

bulb

Model –Serial

location

Door Catch Door Catch

Draw track -

LT Draw track -

FIG 9

Thermostat

bulb

Thermostat bulb

mounting bracket

FIG 10

Capillary tube hold

down clamp

DISASSEMBLY

In order to remove and replace the heating element, you will need to remove (10) Phillips head screws. Each

hold down bracket shown in FIG 11 (Circled in Red) is held in place with (2) screws each.

FIG 12 shows the right side entrance where the thermostat and heating element enter the

chamber of the warming drawer. Remove the (2) screws shown to pull the heating element from the unit.

FIG 11

FIG 12

WIRING DIAGRAM

Heating Element

Volts: 120

Amps: 4

Watts: 475

Ohms: 30.3

Thermostat

90°-250°Fahrenheit

Supply Volt

age

120

WIRING DIAGRAM -VEWD / DEWD / DFWD

PARTS BREAKDOWN

ITEM PART NUMBER PART DESCRIPTION QTY

1PE070147 TERMINAL BLOCK (VDSC) 1

2NON SERVICEABLE 10 X 1 PH. HD. PAN HD. SMS 4

3NON SERVICEABLE 10 X 1/2 PAN PH. TEK ZINC 4

4NON SERVICEABLE POWER CORD MOUNTING BRKT (VDSC) 1

5A1002457 POWER CORD MOUNTING STRAP (VDSC) 1

6NON SERVICEABLE DISGN WD TSTAT SPACER (DEWD170/100) 1

7NON SERVICEABLE 6-32 X 3/8" PHILL PAN MS 1

8PB010167 THERMOSTAT - (VEWD) 1

9021270-000 DEWD102 CONTROL PANEL 1

10 017211-000 INDICATOR LIGHT XL SNAP IN CLEAR LIGHT 1

11 020766-000 DESIGNER WD KNOB 1

Control Area

VEWD / DEWD / DFWD

Andere Handbücher für Professional VEWD173

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Viking Wärmeschublade Handbücher

Viking

Viking DEWD102SS Bedienungsanleitung

Viking

Viking 5 Series Gebrauchsanweisung

Viking

Viking CVWD527 Bedienungsanleitung

Viking

Viking Built-In Electric Warming Drawers Bedienungsanleitung

Viking

Viking EVEWD530 Bedienungsanleitung

Viking

Viking RVEWD330SS Bedienungsanleitung

Viking

Viking DEWD171 DEWD101 Bedienungsanleitung

Viking

Viking RVEWD330 Bedienungsanleitung

Viking

Viking RDEWD103SS Bedienungsanleitung

Viking

Viking F1614G Bedienungsanleitung

Viking

Viking DFWD101 Benutzerhandbuch

Viking

Viking VWD530 Bedienungsanleitung

Viking

Viking CVEWD527 Bedienungsanleitung

Viking

Viking RVEWD330 Bedienungsanleitung

Viking

Viking VEWD527 Bedienungsanleitung

Viking

Viking Brigade CRVEWD330SS Bedienungsanleitung

Viking

Viking F1614H Bedienungsanleitung

Viking

Viking Professional VEWD103T Bedienungsanleitung

Viking

Viking MVWD630BG Bedienungsanleitung

Viking

Viking Professional VEWD173 Bedienungsanleitung

Viking

Viking Built-In Bedienungsanleitung

Viking

Viking RDEWD103SS Bedienungsanleitung

Viking

Viking D30FTW Bedienungsanleitung

Viking

Viking DEWD171 DEWD101 Bedienungsanleitung

Beliebte Wärmeschublade Handbücher anderer Marken

Siemens

Siemens HW 290 Series Bedienungsanleitung

APW Wyott

APW Wyott WD-2CMF Bedienungsanleitung

Miele

Miele ESW 6229 Bedienungsanleitung

Brandt

Brandt WD1014X Bedienungsanleitung

KitchenAid

KitchenAid KOWT107ESS Bedienungsanleitung

Gaggenau

Gaggenau WSP 222 Bedienungsanleitung

DCS

DCS WDI Bedienungsanleitung

Fisher & Paykel

Fisher & Paykel OR90SCG6R1 Bedienungsanleitung

Electrolux

Electrolux EED21600X Bedienungsanleitung

Fisher

Fisher PROFESSIONAL WB76SPEX1 Bedienungsanleitung

Hanseatic

Hanseatic TCN14J6D-S Bedienungsanleitung

Electrolux

Electrolux EW30WD55GS Bedienungsanleitung

Jenn-Air

Jenn-Air JWD6030CDX Bedienungsanleitung

Gaggenau

Gaggenau WS482710 Bedienungsanleitung

Bosch

Bosch HWD2720UC Bedienungsanleitung

NEFF

NEFF N29HA11Y2 Bedienungs- und Wartungsanleitung

Fisher & Paykel

Fisher & Paykel WB60SMTB1-SET Bedienungsanleitung

Bull

Bull W85747 Bedienungsanleitung