Vioguard Cubby Bedienungsanleitung

Vioguard

Cubby / Cubby+

User Manual

Trademark Vioguard Inc. 110-00257-01 Rev. A

Thank you for purchasing the Vioguard Cubby / Cubby+. This user manual contains important safety and

device information that should be read prior to use.

The above symbol indicates safety and device use messages in this manual. Failure to properly set up,

use and care for the Cubby / Cubby+ can increase the risk of serious injury or death, or damage to the

unit. Read this manual for important safety and health information. Keep this manual for future

reference. For a replacement user manual, or to see the most updated version, go to

vioguard.com/manuals, or contact Vioguard customer support at 425-318-7900. Read the complete

manual for important safety and device use information.

TABLE OF CONTENTS

1. Product Specifications

2. Product Warnings

3. Safety Instructions

4. Setup Instructions

5. Getting Started and Initiating a Disinfection Cycle

6. LCD Panel Indications

7. Cleaning Procedures

8. Limited One Year Warranty

9. No Other Warranties

10.Warranty Service

11.How to Obtain Warranty Service

12.Changes to Warranty Service

13.Limitations on Warranty Service

14.Limitation of Remedies

15.Limitation of Liability

PRODUCT SPECIFICATIONS

Weight: 15.6 lbs., excluding cables.

Dimensions: 4”H x 21”W x 12”D

Slide Extension: 6.5” (the distance the keyboard slides out of the unit).

UV-C Disinfection Lamp Life: 10,000 cycles.

Power Input: 100-240 Vac, 50-60hz.

Power Consumption: 50w maximum during disinfection cycles.

Includes: Enclosure with shelf, AC power cable, user manual.

Disinfection Cycle Time: 20 to 120 seconds, depending on dosage

Product Warnings

Ultraviolet (UV-C) Radiation Hazard. Any exposure to the UV-C will cause significant eye damage and may

cause skin damage. If direct light from the UV-C lamps inside the enclosure is visible, remove power and

stop using immediately, and contact Vioguard for assistance.

Product contains Mercury. Manage properly

Safety Instructions

WARNING: To guard against injury, basic safety precautions should be observed, including the following:

1. Read and save all notices, warnings and safety instructions received with equipment.

2. Avoid exposure to direct or reflected germicidal ultraviolet

rays. Germicidal ultraviolet rays are harmful to the eyes and skin.

3. Always disconnect power to the equipment and unplug before

performing any service or maintenance.

4. Do not operate without proper electrical ground.

5. To prevent the risk of severe or fatal electrical shock, special

precautions must be taken. Equipment should be plugged into an approved Ground Fault Circuit

Interrupt (GFCI) receptacle.

6. Most equipment is intended for indoor use only.

7. Do not alter the construction or design. Do not remove safety labels or devices

8. Do not use equipment for other than its intended purpose, as described in the equipment

manual.

9. On equipment with blowers keep inlet and outlet vents, clean and clear of objects.

10. Germicidal ultraviolet rays may break down plastic, rubber, or other non-

metallic materials, can fade colors, and can be damaging to plant life over time.

11. Do not operate equipment if the power cord and/or plug are damaged, or if any other damage

to the unit is visible or suspected.

12. Utility power must match power requirements listed on the unit label.

13. Equipment should be protected from the elements and from temperatures below freezing.

14. Equipment should be used in a stable location that is dry and free from liquid incursion.

15. Do not exceed equipment’s maximum rated flow capacity and/or operating pressure.

SETUP INSTRUCTIONS

1. Open the Vioguard Cubby / Cubby+ packaging and inspect the product visually to make sure there is

no damage.

2. Read the user manual carefully to avoid harm to the product or to yourself and to understand how

to use the product properly.

3. Unpack the main Cubby / Cubby+ Unit.

4. Unpack the provided AC power cord.

5. Plug the AC power cord into the back-panel AC power socket of the unit and then plug the other end

into an AC power source. The unit will power on automatically.

6. The enclosure of the Vioguard Cubby / Cubby+ is designed to support up to 50lbs.

7. Wait for the LCD to illuminate and sequence through its startup icons.

8. The unit will be ready to use once “READY” is displayed on the LCD Screen.

GETTING STARTED AND INITIATING A DISINFECTION CYCLE

1. After completing the setup instructions, the Vioguard Cubby / Cubby+ is ready for use.

2. Open the front door.

3. Pull out the tray.

4. Place your item on the tray.

a. For the Cubby, if you desire to use the pass-through USB port, plug your USB cable into the

connector port located to the rear left of the tray. Connect the unit via a USB A-B cable to a

computer or power supply depending on the device needs.

b. Please note that the Cubby+ does not have USB pass-through and the rear USB port is non-

functional.

5. Push the tray back into the unit.

6. Close the door to begin the disinfection process.

7. The LCD will indicate the start of the cleaning process.

8. Please refer to the LCD Panel Indications for more information regarding the Disinfection Cycles.

9. Please note that there is a 1-second delay in startup to prevent surges to the power supply if the

door is opened and closed rapidly. The door needs to be open for at least 1 second for the unit to

begin the disinfection cycle.

2. 3.

4. 6.

LCD PANEL INDICATIONS

1. Ready: Indicates chamber is ready to disinfect or the device is ready after disinfection. The UVC

lights are off.

2. Quick Clean: Quick Clean Cycle in progress. Averages 15-20 seconds from start of process at door

closure. Once the Quick Clean Cycle is completed, you can safely remove the device from the

chamber at your discretion. UVC lights are on during the Quick Clean Cycle and will continue to

remain on through the following Deep Clean Cycle.

3. Deep Clean: Deep Clean Cycle in progress. Immediately follows Quick Clean Cycle. Averages a

total time of 90-180 seconds from start of process at door closure. Once the Deep Clean Cycle is

completed, you can safely remove the device from the chamber at your discretion. UVC lights are

on during the Deep Clean Cycle but will turn off upon completion.

4. Status Bar: The Status Bar tracks the UVC Disinfecting Cycle. The bar will fill from left to right, with

a designation line defining the end of the Quick Clean Cycle and the beginning of the Deep Clean

Cycle. It will remain filled until the door is opened, where the bar will then be cleared to show the

unit is ready to start another disinfection cycle.

5. Error: Error indicates an issue has occurred with the unit. Please contact support via email or by

phone.

CLEANING PROCEDURES

The Vioguard Cubby / Cubby+ should be cleaned when visibly dirty.

1. Turn the Cubby / Cubby+ off by unplugging the unit from AC power.

2. Clean the outer surface of the Vioguard Cubby / Cubby+ and the internal tray by wiping or brushing.

Note: Use pre-moistened wipes, soft cloths, sponges or a soft bristle brush only.

3. Wipe with a dry cloth or allow to air dry.

4. Reconnect the Cubby / Cubby+ to A/C power.

DO NOT pour any liquid cleaner or disinfectant directly on any surface of the Vioguard Cubby / Cubby+.

Recommended Cleaners/Disinfectants: Chlorine-based (max 10% solution), alcohol-based, quaternary

ammonium, soap and warm water. Note: Use manufacturers’ recommendations for concentrations.

DO NOT use the following: Petroleum-based cleaning ﬂuids (such as gasoline, turpentine or oil),

acetone, bleach solutions with over 10% bleach, temperature or pressure sterilization, buffing or

scrubbing pads.

LIMITED ONE YEAR WARRANTY

Limited Warranty: Vioguard warrants the Vioguard Cubby / Cubby+ will be free from faulty

workmanship or defective materials and conform to Vioguard’s applicable specifications or data sheets

provided with the product for a period of one year from the date of purchase. Note: Disinfection lamps

used in the Vioguard Cubby / Cubby+ are excluded from warranty due to their variable life expectancy.

Exclusions: The limited warranty is given only to the original purchaser of the Vioguard Cubby / Cubby+

and may not be transferred.

The warranty does not cover any cosmetic defects, problems or malfunctions not caused by the

manufacturer. This includes issues stemming from power surge, misuse (including outdoor use), abuse,

negligence, accidents, wear and tear, mishandling, misapplication, unreasonable intrusion or exposure

to liquids, shipping or transit, improper or faulty installation, operation in a manner contrary to

documentation provided to you with the Vioguard Cubby / Cubby+, operation on incorrect power

supplies, third party products, modification, alteration, improper servicing or tampering. The warranty

does not cover wear from the use of disinfection lamps in the Vioguard Cubby / Cubby+. In addition, the

limited warranty will not apply for any Vioguard Cubby / Cubby+: that is opened, disassembled,

maintained (other than routine maintenance done by or in behalf of the user as described in this

manual) or modified by anyone other than Vioguard or any Vioguard-authorized third-party without

Vioguard’s prior written approval; or whose serial number is defaced, altered or removed.

NO OTHER WARRANTIES

The above warranty is exclusive and in lieu of all other representations or warranties, whether written

or oral, express, implied or statutory, except where such limitation of warranties is prohibited by law

and can be amended only by written instrument signed by an officer of Vioguard. Except where such

limitation of warranties is prohibited by law, Vioguard disclaims all other warranties to the maximum

extent permitted by warranty information-applicable law, including, but not limited to, any implied

representations or warranties of merchantability or fitness for a particular purpose, title or non-

infringement, quiet enjoyment, and any other representation or warranty obligation on the part of

Vioguard. Any implied warranties that cannot be disclaimed by law, shall only be in effect for a period of

three months from the date and time of purchase. The above warranty gives you specific legal rights and

you may have other rights which vary by jurisdiction. Some jurisdictions do not allow waiver of implied

warranties, so the above limitation may not apply to you. Where any term of this Limited Warranty is

prohibited by such laws, it shall be null and void, but the remainder of the Limited Warranty shall remain

in full-force and effect.

Andere Handbücher für Cubby

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere vioguard Sterilisator Handbücher

vioguard

vioguard Cubby Bedienungsanleitung

Beliebte Sterilisator Handbücher anderer Marken

Dust Free

Dust Free LightStick Bedienungsanleitung

Euronda

Euronda E9 Next 18L Bedienungsanleitung

UVPLUS

UVPLUS ALS UVP201R Bedienungsanleitung

SterileLight

SterileLight Illumicide SL-UVC-IDC-01-B Bedienungsanleitung

Norka

Norka BUENOS AIRES UV-C 997 100 02 Series Bedienungsanleitung

CertoClav

CertoClav Vacuum Pro 45 Bedienungsanleitung

Chicco

Chicco SterilNatural 2in1 Bedienungsanleitung

Market Forge Industries

Market Forge Industries Sterilmatic Bedienungsanleitung

Philips AVENT

Philips AVENT SCF271/20 Bedienungsanleitung

Easypix

Easypix SteriBox SB1 Bedienungsanleitung

ASP

ASP sterrad NX Bedienungsanleitung

Vital Baby

Vital Baby NURTURE advanced pro UV mini Bedienungsanleitung

NUK

NUK 10.256.444 Bedienungsanleitung

Chicco

Chicco SterilNatural Bedienungsanleitung

Philips

Philips SCF276/01 Bedienungsanleitung

Reverberi

Reverberi BABY S Bedienungsanleitung

Technaxx

Technaxx TX-151 Bedienungsanleitung

Memmert

Memmert SF PLUS Series Bedienungsanleitung