2 DE5926
5. WIRING
PC
for upload /
download
Alternative cable
GSM
unit
Verify that pin-to-pin
connection exists
between GSM unit and
PowerMax+ (pin 1 to pin
1, pin 2 to pin 2, etc.)
Insert the socket into
its male connector,
until a click is heard
RJ-45 or
RJ-31X (USA)
PowerMax+
Transformer
220/110 VAC
(when to use -
see note below)
9
VAC
1
8
234567
1
2
3
4
5
6
7
8
SIM card
(For card insertion,
refer to figure 2)
Figure 4 - Wiring
Note
For UL approved installations, transformer for GSM unit is always required. For other installations, transformer is required in the following cases:
A. During GSM unit installation, only if the GSM unit's backup battery voltage is low (initial battery charge time is 48 hours).
B. After GSM unit installation, if any load whose current consumption exceeds 100 mA is connected to the PowerMax+.
6. MOUNTING
Fasten bracket
to GSM unit
3
Mark and drill 3 holes (or 4 holes if Tamper
protection is desired) in mounting surface.
Fasten the bracket to the mounting surface
with the screws.
1
2
Locate the GSM unit on
the bracket and push
downward as shown
until a klick is heard.
Figure 5 - Mounting
Note: It is recommended that the GSM unit will be installed at a distance
of 1 to 12 meters (3.2 – 40 ft) from the alarm system control panel to
increase the system reliability.
Warning! To comply with FCC Section1.307 (b)(1) for human exposure
to radio frequency electromagnetic fields, a distance of at least 20 cm
between the equipment and all persons should be aintained during
operation of the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference that may
be received, including interference that may cause undesired operation.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must
contact the company from which you orignially purchased it. If you
are discarding this product and not returning it for repair then you
must ensure that it is returned as identified by your supplier. This
product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
WARRANTY
Visonic Ltd. and/or its subsidiaries and its affiliates ("the Manufacturer") warrants its
products hereinafter referred to as "the Product" or "Products" to be in conformance with
its own plans and specifications and to be free of defects in materials and workmanship
under normal use and service for a period of twelve months from the date of shipment by
the Manufacturer. The Manufacturer's obligations shall be limited within the warranty
period, at its option, to repair or replace the product or any part thereof. The Manufacturer
shall not be responsible for dismantling and/or reinstallation charges. To exercise the
warranty the product must be returned to the Manufacturer freight prepaid and insured.
This warranty does not apply in the following cases: improper installation, misuse,
failure to follow installation and operating instructions, alteration, abuse, accident or
tampering, and repair by anyone other than the Manufacturer.
This warranty is exclusive and expressly in lieu of all other warranties, obligations or
liabilities, whether written, oral, express or implied, including any warranty of
merchantability or fitness for a particular purpose, or otherwise. In no case shall the
Manufacturer be liable to anyone for any consequential or incidental damages for breach
of this warranty or any other warranties whatsoever, as aforesaid.
This warranty shall not be modified, varied or extended, and the Manufacturer does not
authorize any person to act on its behalf in the modification, variation or extension of this
warranty. This warranty shall apply to the Product only. All products, accessories or
attachments of others used in conjunction with the Product, including batteries, shall be
covered solely by their own warranty, if any. The Manufacturer shall not be liable for any
damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or
otherwise, caused by the malfunction of the Product due to products, accessories, or
attachments of others, including batteries, used in conjunction with the Products.
The Manufacturer does not represent that its Product may not be compromised and/or
circumvented, or that the Product will prevent any death, personal and/or bodily injury
and/or damage to property resulting from burglary, robbery, fire or otherwise, or that the
Product will in all cases provide adequate warning or protection. User understands that a
properly installed and maintained alarm may only reduce the risk of events such as
burglary, robbery, and fire without warning, but it is not insurance or a guarantee that
such will not occur or that there will be no death, personal damage and/or damage to
property as a result.
The Manufacturer shall have no liability for any death, personal and/or bodily injury
and/or damage to property or other loss whether direct, indirect, incidental,
consequential or otherwise, based on a claim that the Product failed to function.
However, if the Manufacturer is held liable, whether directly or indirectly, for any loss or
damage arising under this limited warranty or otherwise, regardless of cause or origin, the
Manufacturer's maximum liability shall not in any case exceed the purchase price of the
Product, which shall be fixed as liquidated damages and not as a penalty, and shall be
the complete and exclusive remedy against the Manufacturer.
Warning: The user should follow the installation and operation instructions and among
other things test the Product and the whole system at least once a week. For various
reasons, including, but not limited to, changes in environmental conditions, electric or
electronic disruptions and tampering, the Product may not perform as expected. The user
is advised to take all necessary precautions for his /her safety and the protection of
his/her property.
6/91
VISONIC LTD. (ISRAEL): P.O.B 22020 TEL-AVIV 61220 ISRAEL. PHONE: (972-3) 645-6789, FAX: (972-3) 645-6788
VISONIC INC. (U.S.A.):
65 WEST DUDLEY TOWN ROAD, BLOOMFIELD CT. 06002-1376. PHONE: (860) 243-0833, (800) 223-0020 FAX: (860) 242-8094
VISONIC LTD. (UK): FRASER ROAD, PRIORY BUSINESS PARK, BEDFORD MK44 3WH. PHONE: (0870) 7300800 FAX: (0870) 7300801
INTERNET: www.visonic.com
