Vivitar Vivicam 3826 Bedienungsanleitung
V3826
User Manual
English
040507TP
E
1
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation
Note:
This equipment has been tested and found to comply with the limits for Class B digital
devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However,there is no guarantee that interference will not occur in a
particular installation.If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
E
2
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the
FCC rules.
Do not make any changes or modifications to the equipment unless otherwise
specified in the manual. If such changes or modifications should be made,
you could be required to stop operation of the equipment.
E
3
TRADEMARK INFORMATION
Microsoft®and Windows®are U.S. registered trademarks of Microsoft Corporation.
Pentium®is a registered trademark of Intel Corporation.
Macintosh is a trademark of Apple Computer, Inc.
SDTM is a trademark.
PhotoSuite, PhotoVista are trademarks.
Other names and products may be trademarks or registered trademarks of their respective
owners.
READ THIS FIRST
Please start by reading the important messages below first.
1. The bundled driver, software, design, specifications and user's manual that were packaged
with the camera are subject to change without notice.
2. The accessories that come with the ViviCam 3826 may vary between regions.
3. For driver updates, refer to our website or contact your dealer.
4. We are not liable whatsoever for any compensation arising from errors in descriptions in
this user's manual.
E
4
WARNINGS
Do not use the camera if it is emitting smoke, unusual odor or noise, becoming unusually
hot to be touched, or if it is in any other abnormal state. Operating the camera in any of these
circumstances may cause a fire or an electrical shock. Stop using the camera immediately,
turn the camera off, and then disconnect the power source (batteries or AC power adapter).
(If you are using the AC power adapter from the AC power outlet after you have disconnected
the camera.) After checking that smoke is no longer being emitted, contact your dealer or
authorized service facility for repairs.Never attempt to repair this camera by yourself, as this
is dangerous.
Do not use the camera if any foreign objects have entered the camera. Turn the camera off,
remove the batteries, and then disconnect the power source (batteries or an AC power
adapter.) (If you are using the AC power adapter, unplug the adapter from the AC power
outlet after you have disconnected the camera.) Later on contact your dealer or authorized
service facility. Do not continue to use the camera as this may cause a fire or an electrical
shock.
Do not place the camera in any unstable locations such as on a wobbly table or slopping
surface where the camera may fall or tip over and cause damage.
E
5
If the camera has been dropped or if the camera case has been damaged, turn the camera
off, and then disconnect the power source (batteries or AC power adapter.) (If you are using
the AC power adapter, unplug the adapter form the AC power outlet after you have
disconnected the camera.) Then contact to your dealer or authorized service facility. Do not
continue to use the camera as this may cause a fire or an electrical shock.
Do not expose the camera to moisture and avoid water gets into the camera. Take particular
care when using the camera under extreme weather conditions, such as rain or snow, or
when operating the camera at the beach or near water. Water in the camera may cause a
fire or an electrical shock.
Do not touch the power plug during a thunderstorm if you are using the AC power adapter.
This may cause an electrical shock.
Do not attempt to modify the camera. This may cause a fire or an electrical shock.
Do not remove the camera casing. This may cause an electrical shock. Internal inspection,
maintenance and repairs should only be carried out by our authorized service facility.
Do not touch the power plug during a thunderstorm if you are using the AC power adapter.
This may cause an electrical shock.
E
6
CAUTIONS
Do not place the camera in damp or dusty locations. This may cause a fire or an electrical
shock.
Do not place the camera in a location affected by oil fumes or steam, such as near a
cooking stove or humidifier. This may cause a fire or an electrical shock.
Do not cover or wrap the camera or the AC power adapter with a cloth or quilt. This may
cause heat to build up, distort the case and cause a fire. Always use the camera and its
accessories in well-ventilated locations.
Handle the camera carefully and do not bump the camera into any hard object. Handling the
camera roughly may cause a malfunction.
Do not move the camera while it is switched on. (If you are using the AC power adapter,
unplug the adapter from the AC power outlet after you have switched off the camera.)
Ensure that any connector cords or cables to other devices are disconnected before moving
the camera. Failure to do so may damage the cords or cables and cause a fire or an
electrical shock.
E
7
When leaving the camera unused for long periods, such as during a vacation, always
unplug the camera from the power source (batteries or AC power adapter) for safety. (If you
are using the AC power adapter, unplug the adapter from the AC power outlet after you have
disconnected the camera.) Failure to do so could result in a fire.
Do not use batteries other than those specified for use with the camera. The use of unsuitable
batteries may result in the batteries splitting or leaking and causing a fire, injury, or soiling
of the battery compartment.
When fitting batteries into the camera, check the polarity markings on the battery (- and +) to
ensure that you insert the battery correctly. Incorrect battery polarity may result in the batteries
splitting or leaking and causing a fire, injury, or soiling of the battery compartment.
Remove the batteries if the camera will not be used for an extended period of time. The
batteries may leak and cause a fire, injury or soiling of the battery compartment. If the
batteries leak, clean and wipe the battery compartment carefully and install new batteries.
Wash your hands carefully if you touch the battery fluid.
WARNING: Handling the USB and AV cables on this product may expose you to lead, a
chemical known to the State of California to cause birth defects or other reproductive harm.
Wash hands after handling.
E
8
CONTENTS
INTRODUCTION ...................................................................................................... 12
Overview .......................................................................................................... 12
Package Contents ........................................................................................... 13
GETTING TO KNOW YOUR VIVICAM 3826 ........................................................... 14
Front View ...................................................................................................... 14
Rear View ....................................................................................................... 15
Mode Dial ........................................................................................................ 16
LED Indicators ................................................................................................. 17
LCD Monitor Information .................................................................................. 18
GETTING STARTED ............................................................................................... 21
Installing the Batteries .................................................................................... 21
Using an AC Power Adapter (Optional Accessory) .......................................... 22
Loading an SD Memory Card (Optional Accessory) ......................................... 23
Attaching the Camera Strap ............................................................................. 24
Attaching the Lens Strap...............................................................................24
E
9
Choosing the OSD Language ........................................................................... 25
Setting the Date and the Time ......................................................................... 25
Setting the Image Resolution and Quality ........................................................ 26
CAPTURING IMAGES ......................................................................................... 28
Basic Settings................................................................................................. 28
Viewfinder ........................................................................................................... 28
LCD Monitor ........................................................................................................ 29
Zoom Functions ................................................................................................. 30
Self-Timer ........................................................................................................... 31
Flash ................................................................................................................... 32
Photography Modes ....................................................................................... 34
Manual Mode ...................................................................................................... 35
Automatic Mode .................................................................................................. 36
Macro Mode ........................................................................................................ 37
Portrait Mode ...................................................................................................... 38
Landscape Mode ................................................................................................ 39
Night Scene Mode .............................................................................................. 40
Sports Mode ....................................................................................................... 41
Inhaltsverzeichnis
Andere Vivitar Digitalkamera Handbücher
Vivitar
Vivitar VIVICAM 5118V2 Bedienungsanleitung
Vivitar
Vivitar Vivicam 3000 Bedienungsanleitung
Vivitar
Vivitar V69379M Bedienungsanleitung
Vivitar
Vivitar 35ES Bedienungsanleitung
Vivitar
Vivitar ViviCam 8324 Bedienungsanleitung
Vivitar
Vivitar Vivicam 25 Bedienungsanleitung
Vivitar
Vivitar Vivicam 8400 Bedienungsanleitung
Vivitar
Vivitar Vivicam 2010 Bedienungsanleitung
Vivitar
Vivitar Vivicam 3665 Bedienungsanleitung
Vivitar
Vivitar ViviCam F126 Bedienungsanleitung
Vivitar
Vivitar ViviCam 8690v2 Bedienungsanleitung
Vivitar
Vivitar ViviCam V8426v2 for 10MP Bedienungsanleitung
Vivitar
Vivitar DSC350 Bedienungsanleitung
Vivitar
Vivitar ViviCam 7330 Bedienungsanleitung
Vivitar
Vivitar ViviCam T127 Bedienungsanleitung
Vivitar
Vivitar Vivicam 3815 Bedienungsanleitung
Vivitar
Vivitar ViviCam T329 Bedienungsanleitung
Vivitar
Vivitar Vivicam 3632 Bedienungsanleitung
Vivitar
Vivitar Vivicam 5399 Bedienungsanleitung
Vivitar
Vivitar Vivicam 2795 Bedienungsanleitung
