QA Maintenance and Inspection ViZion DR+ Detector Guide v2.0
Opal
1.800.366.5343 –support@viztek.net
VZDR-UG-QA Maintenance and Inspection ViZion DR+ Detector Guide-D-20141012-2.0
II. Power Supply
The instrument’s cables are long, do not tangled during use.
Be careful not to get your feet caught in the cabling.
Always connect the three-core power cord plug to a grounded AC power outlet.
III. Handling
Do not spill liquid or chemicals onto the instrument.
In cases where the patient is injured, do not allow the instrument to become wet with blood or
other body fluids, as doing so may result in fire or electric shock. In such situation, protect the
instrument with disposable covering as necessary.
Wipe the CFRP plate of the sensor unit with ethanol or glutaraldehyde solution to disinfect it each
time a different patient uses the instrument, in order to prevent infection.
For safety reasons turn off the power of each instrument when not in use.
IV. Maintenance and Inspection
For safety reasons, be sure to inspect the instrument before using it. In addition, carry out a
regular inspection at least once a year.
The instrument must be repaired by a qualified engineer only. If it is not repaired properly, it may
cause fire, electric shock or accident.
V. Maintenance
Maintenance should be done by service provider
If the Detector Panel is defective, the detector will be returned as is to the manufacturer for repair
Clean the equipment with a dry soft cloth, or a soft cloth lightly moistened with mild detergent
solution. Do not use any type of solvent, such as benzene
This equipment and accessories are to be disposed of safely after the life span of them and
national regulation must be observed.
For safety reasons, be sure to inspect the instrument before using it. In addition, carry out a
regular inspection at least once a year.
Arrange the detector and power supply link cable to prevent the damage of the cable’s rubber
tube. For example, do not press the cable under the legs of the table or the people.
