Vortex RAZOR AMG UH-1 Bedienungsanleitung

2 3

Shockproof Housing

Windage

Adjustment

Elevation Adjustment

Micro USB Port

Shatterproof Sight

Window

Snag Free Battery Cap

Integrated Quick

Release Mount

On/Off Buttons

The incredible features of the Razor®AMG™UH-1™are

matched only by its tough, tenacious performance. Absolute

zero image distortion and an impressive sight picture with un-

obstructed view ensure rapid, instinctual target acquisition.

The shatterproof XR plus fully multi-coated windows and holo-

graphic elements are incredibly durable and promote optimal

light transmission. All sensitive components are protected in

the base of the sight, increasing durability, while eliminating

the need for an obstructive secondary shroud.

4 5

Powering Up

To turn the UH-1 on press either button. It is set to the middle

illumination setting. Use the plus and minus buttons to switch

brightness levels. There are 15 brightness settings for extreme

low light to daytime bright.

To turn off, simultaneously press both buttons.

Auto Shut Off

The UH-1 will automatically shut off after 14 hours if no button

is pressed. The 14-hour Auto Shut Off feature can be disabled.

To disable the Auto Shut Off feature, press the minus button (-)

for 5 seconds. The reticle will blink twice to conﬁrm. To re-en-

able the feature, press the plus button (+) for 5 seconds. The

reticle will blink three times to conﬁrm.

Please note, when the auto shut off feature is disabled, you

must remember to manually turn off the sight, otherwise the

sight will stay on until the battery runs completely out.

Operating the UH-1™

Power Off:

Press both buttons

simultaneously.

Power On:

Press either

button.

6 7

Windage Adjustment

Elevation Adjustment

Windage and Elevation Adjustments

Use a coin or other ﬂat head item to turn the knobs to adjust for

point of aim. For both adjustment knobs, one click will change

the point of aim approximately ½ MOA when zeroing.

One full rotation of either knob will change the point of aim

approximately 16.5 MOA—8.25” at 50 yards or 16.5” at 100

yards when zeroing.

Please note:

When adjusting, you may encounter increased resistance. This

means the end of the adjustment range has been reached

and you should not turn the knob any further.

One click yields ½ MOA of adjustments

¹/8-inch (3.18mm) at 25-yds (23.75 meters)

¼-inch (6.35mm) at 50-yds (47.5 meters)

8 9

Using the EBR-CQB Holographic Reticle

The EBR-CQB is designed to take full advantage of both the

center dot and the bottom triangle for targeting.

Use the center dot for zeroing your riﬂe and as the point of aim

for targets at 25 to 400 yards/meters.

The bottom triangle will be your point of impact for close quar-

ters distances of 10 yards/meters or less.

See trajectory charts on next page.

10 11

Trajectory and Ballistics Examples

This example is based on M855 ammunition. This example is based on M855 ammunition.

12 13

One CR123A battery powers the UH-1. The UH-1 also runs on the

LFP123A, the high-end rechargeable version of the CR123A. Charge

the battery using the Micro USB port and it will recharge while in the

sight. This LFP123A rechargeable battery does not have as long of life

for continuous use as a standard CR123A, but does provide the advan-

tage of recharging.

Please note:

If the reticle begins to pulse, the battery should be changed

or recharged.

Replacing the Battery

To remove the snag-free battery cap, insert a nickel into the slot and

turn the cap counterclockwise. A - symbol on the unit shows battery

direction. Special threads hold the cap in place, it will not back out

with recoil.

Battery Information

Charging the Battery

While charging a LFP 123A battery in the sight, the reticle will

pulse back and forth between dim/bright. The actual brightness

values for the pulsing will be one setting above the “on” setting

and one setting below the “on” setting.

During a low battery condition in the sight:

When you turn on the sight it goes straight to the “puls-

ing” function, as described above. The sight will continue

to pulse for 5 seconds no matter what, and will continue

pulsing unless the user cancels by cycling between two

brightness settings.

The above low battery condition will occur when using

the CR 123A when there are 25 hours of battery life left.

When using the LFP 123A battery pulsing will occur

when there is about one hour of battery life left. These es-

timates are based on 70° F. The exact amount of battery

life will vary due to the ambient conditions.

14 15

VIP Warranty

Vortex Optics

2120 West Greenview Drive

Middleton, WI 53562

[email protected]

We build optics based on our commitment to your absolute

satisfaction. That’s why Vortex products are unconditionally

guaranteed and we make this Very Important Promise to you—a

Very Important Person.

Rest assured that in the event your optic becomes damaged or

defective, Vortex Optics will repair or replace it at no charge

to you. If we cannot repair your optic, we will replace it with a

product in perfect working order and in equal or better physical

condition. Call Vortex Optics at 800-426-0048 for prompt,

professional, and friendly service.

Visit www.vortexoptics.com for more information.

Note: The VIP Warranty does not cover loss, theft, deliberate

damage, or cosmetic damage that does not hinder the perfor-

mance of the product.

Maintenance

The UH-1™will require virtually no maintenance other than

periodically cleaning the exterior lenses. If desired, the exterior

lens may be cleaned by wiping with a soft, dry cloth.

• When cleaning the lenses, be sure to use products speciﬁcally designed

for use on coated optical lenses such as the Vortex Lens Pen, the Fog Free

Cleaning kits, or the included microﬁber cloth.

• Be sure to blow away any dust or grit on the lens prior to wiping the surface.

• Using your breath, or a very small amount of water or pure alcohol, can help

remove stubborn things like dried water spots.

CAUTION - Use of controls, adjustments or performance of procedures other than those speciﬁed herein may result

in hazardous laser radiation exposure.

Laser safety

CLASS 1 LASER PRODUCT

THIS PRODUCT COMPLIES WITH IEC 60825-1:2014-05 Ed.3.0

and IEC 60825-1:2007-03 Ed. 2.0

Sheltered Wings, Inc., 2120 West Greenview Drive,

Middleton, WI 53562

Sheltered Wings, Inc., 2120 West Greenview Drive,

Middleton, WI 53562

Manufactured: January 2017

THIS PRODUCT COMPLIES WITH

21CFR SUBCHAPTER J PARTS

1040.10 AND 1040.11 EXCEPT FOR

DEVIATIONS PURSUANT TO LASER

NOTICE NO. 50 DATED JUNE 24, 2007.

rd_RZR-AMG-UH-1_2016_V1

Inhaltsverzeichnis

Andere Vortex Beleuchtungsausrüstung Handbücher

Vortex

Vortex S.R.Smith Gebrauchsanweisung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung