4
Internet - For VSSL to function properly, a high speed wired internet connection (such as
cable, fiberm or DSL) is required.
Wi-Fi router - For VSSL to work with your wireless phone, tablet, laptop or comuter, you
must have a wireless router or wireless access point installed.
Access point controller - In home with access points, it is recommended that an AP
controller be present.
Network Topography - When hardwiring, the VSSL should be placed as far downstream
from the router, switch, and access points as possible. In homes with a switch, ensure the
switch is placed downstream from the router.
•
•
•
•
GETTING STARTED
1. PREP YOUR NETWORK
Network Topography Suggestions
Ensure the router has the most up-to-date firmware installed.
Avoid Double NAT when using 3rd party router/mesh system by placing the ISP router in
“Bridge Mode” (e.g., Google, eero).
Ensure that the ethernet (patch) cable is fully functional. Note: ethernet cables commonly
degrade over time.
Separate the 2.4GHz and 5GHz WiFi bands and ensure that they maintain dierent SSID’s.
Enable “UPnP” (Universal Plug and Play).
When using access points, disable “AP Isolation” or “Client Isolation”.
Enable “Multicasting” (multicast terminology diers between manufacturers).
Disable “IPv6” and only use “IPv4”.
Enable “IGMP” (Internet Group Management Protocol).
When using Apple devices, enable “Bonjour” or “ZeroConf Discovery”.
Ensure managed switches and access point controllers follow the same network
topography suggestions as detailed above.
See more router-specific suggestions at vssl.com/support.
Every router is dierent and might require settings adjustments in order for VSSL’s streaming
services to function correctly and eciently. To configure your router, it’s important to consult
the manual that corresponds with your exact router model. Most modern routers provide an
administration control panel that can be accessed through your web browser. Once any
settings have been changed within the network, ensure that the network is fully powered
down and restarted. Also, ensure that your SX product has been restarted after any of the
following network setting suggestions have been applied:
•
•
•
•
•
•
•
•
•
•
•
•
General Router Settings
VSSL SX SPEAKER
