Wacker Neuson BS 50-4 Bedienungsanleitung

www.wackergroup.com

Rammer

BS 50-4

BS 50-4s

OPERATOR’S MANUAL

0158431en 006

1106

0158431EN

BS 50-4 Table of Contents

wc_bo0158431en_006TOC.fm 1

1. Foreword 3

2. Emission Control System Information 4

3. Safety Information 11

3.1 Operating Safety ................................................................................ 12

3.2 Operator Safety while using Internal Combustion Engines ................ 14

3.3 Service Safety .................................................................................... 15

3.4 Label Locations .................................................................................. 16

3.5 Safety Labels ...................................................................................... 17

3.6 Operating Labels ................................................................................ 20

4. Technical Data 22

4.1 Rammer .............................................................................................. 22

4.2 Sound Measurements ........................................................................ 23

4.3 Vibration Measurements .................................................................... 23

4.4 Dimensions ......................................................................................... 23

5. Operation 24

5.1 Application .......................................................................................... 24

5.2 Recommended Fuel ........................................................................... 24

5.3 Before Starting ................................................................................... 24

5.4 To Start ............................................................................................... 24

5.5 To Stop ............................................................................................... 25

5.6 Low Oil Shutoff Switch (if equipped) .................................................. 26

5.7 Proper Operation ................................................................................ 27

5.8 Proper Compaction ............................................................................ 28

Table of Contents BS 50-4

wc_bo0158431en_006TOC.fm 2

6. Maintenance 29

6.1 Periodic Maintenance Schedule ..........................................................29

6.2 Servicing Air Cleaner ...........................................................................30

6.3 Engine Oil ............................................................................................31

6.4 Lubrication ...........................................................................................32

6.5 Shoe Hardware ...................................................................................33

6.6 Long-Term Storage .............................................................................33

6.7 Transportation .....................................................................................34

6.8 Troubleshooting ...................................................................................35

wc_tx000001gb.fm 3

CALIFORNIA

Proposition 65 Warning:

Engine exhaust, some of its constituents, and certain vehicle

components, contain or emit chemicals known to the State of

California to cause cancer and birth defects or other reproductive

harm.

1. Foreword

This manual provides information and procedures to safely operate

and maintain this Wacker model. For your own safety and protection

from injury, carefully read, understand and observe the safety

instructions described in this manual.

Keep this manual or a copy of it with the machine. If you lose this

manual or need an additional copy, please contact Wacker

Corporation. This machine is built with user safety in mind; however,

it can present hazards if improperly operated and serviced. Follow

operating instructions carefully! If you have questions about operating

or servicing this equipment, please contact Wacker Corporation.

The information contained in this manual was based on machines in

production at the time of publication. Wacker Corporation reserves the

right to change any portion of this information without notice.

All rights, especially copying and distribution rights, are reserved.

No part of this publication may be reproduced in any form or by any

means, electronic or mechanical, including photocopying, without

express written permission from Wacker Corporation.

Any type of reproduction or distribution not authorized by Wacker

Corporation represents an infringement of valid copyrights and will be

prosecuted. We expressly reserve the right to make technical

modifications, even without due notice, which aim at improving our

machines or their safety standards.

WARNING

Emission Control System Information WM 90

wc_tx000369gb.fm 4

2. Emission Control System Information

Source of Emissions

The combustion process produces carbon monoxide, oxides of

nitrogen, and hydrocarbons. Control of hydrocarbons and oxides of

nitrogen is very important because, under certain conditions, they

react to form photochemical smog when subjected to sunlight. Carbon

monoxide does not react in the same way, but it is toxic.

Wacker utilizes lean carburetor settings and other systems to reduce

the emissions of carbon monoxide, oxides of nitrogen, and

hydrocarbons.

The U.S. and California Clean Air Acts

EPA and California regulations require all manufacturers to furnish

written instructions describing the operation and maintenance of

emission control systems.

The following instructions and procedures must be followed in order to

keep the emissions from your Wacker engine within the emissions

standards.

Tampering and Altering

Tampering with or altering the emission control system may increase

emissions beyond the legal limit. Among those acts that constitute

tampering are:

•Removal or alteration of any part of the intake, fuel, or exhaust

systems.

•Altering or defeating the speed-adjusting mechanism to cause the

engine to operate outside its design parameters.

Problems That May Affect Emissions

If you are aware of any of the following symptoms, have your engine

inspected and repaired by your servicing dealer.

•Hard starting or stalling after starting.

•Rough idle.

•Misfiring or backfiring under load.

•Afterburning (backfiring).

•Black exhaust smoke or high fuel consumption.

WM 90 Emission Control System Information

wc_tx000369gb.fm 5

Replacement Parts

The emission control systems on your Wacker engine were designed,

built, and certified to conform with EPA and California emissions

regulations. We recommend the use of genuine Wacker parts

whenever you have maintenance done. These original-design

replacement parts are manufactured to the same standards as the

original parts, so you can be confident of their performance. The use

of replacement parts that are not of the original design and quality may

impair the effectiveness of your emission control system.

A manufacturer of an aftermarket part assumes the responsibility that

the part will not adversely affect emission performance. The

manufacturer or rebuilder of the part must certify that use of the part

will not result in a failure of the engine to comply with emission

regulations.

Maintenance

Follow the maintenance schedule. Remember that this schedule is

based on the assumption that your machine will be used for its

designed purpose. Sustained high-load or high-temperature operation,

or use in unusually wet or dusty conditions, will require more frequent

service.

OXYGENATED FUELS

Some conventional gasolines are being blended with alcohol or an

ether compound. These gasolines are collectively referred to as

oxygenated fuels. To meet clean air standards, some areas of the

United States and Canada use oxygenated fuels to help reduce

emissions.

If you use an oxygenated fuel, be sure it is unleaded and meets the

minimum octane rating requirement.

Before using an oxygenated fuel, try to confirm the fuel’s contents.

Some States / Provinces require this information to be posted on the

pump.

The following are EPA-approved percentages of oxygenates:

ETHANOL - (ethyl or grain alcohol) 10% by volume. You may use

gasoline containing up to 10% ethanol by volume. Gasoline containing

ethanol may be marketed under the name “Gasohol”.

MTBE - (methyl tertiary butyl ether) 15% by volume. You may use

gasoline containing up to 15% MTBE by volume.

Emission Control System Information WM 90

wc_tx000369gb.fm 6

METHANOL - (methyl or wood alcohol) 5% by volume. You may use

gasoline containing up to 5% methanol by volume, as long as it

contains cosolvents and corrosion inhibitors to protect the fuel system.

Gasoline containing more than 5% methanol by volume may cause

starting and/or performance problems. It may also damage metal,

rubber, and plastic parts of your fuel system.

If you notice any undesirable operating symptoms, try another service

station, or switch to another brand of gasoline.

Fuel system damage or performance problems resulting from the use

of an oxygenated fuel containing more than the percentages of

oxygenates mentioned above are not covered under warranty.

WM 90 Emission Control System Information

wc_tx000369gb.fm 7

EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE

This emission warranty is applicable in all States.

Wacker Corporation, N92 W15000 Anthony Avenue, Menomonee

Falls, WI 53051-1504, (herein "Wacker") warrant(“s”) to the initial retail

purchaser and each subsequent owner, that this non-road engine

(herein "engine") has been designed, built, and equipped to conform

at the time of initial sale to all applicable regulations of the U.S.

Environmental Protection Agency (EPA), and that the engine is free of

defects in materials and workmanship which would cause this engine

to fail to conform with EPA regulations during its warranty period.

For the components listed under PARTS COVERED, the service

dealer authorized by Wacker will, at no cost to you, make the

necessary diagnosis, repair, or replacement necessary to ensure that

the engine complies with applicable U.S. EPA regulations.

EMISSISON COMPONENT DEFECT WARRANTY PERIOD

The warranty period for this engine begins on the date of sale to the

initial purchaser and continues for a period of 2 years.

Emission Control System Information WM 90

wc_tx000369gb.fm 8

PARTS COVERED

Listed below are the parts covered by the Emission Components

Defect Warranty. Some of the parts listed below may require

scheduled maintenance and are warranted up to the first scheduled

replacement point for that part.

(1) Fuel Metering System

(i) Carburetor and internal parts (and/or pressure regulator or fuel

injection system).

(ii) Air/fuel ratio feedback and control system, if applicable.

(iii) Cold start enrichment system, if applicable.

(iv) Regulator assembly (gaseous fuel, if applicable) .

(2) Air Induction System

(i) Intake manifold, if applicable.

(ii) Air filter.

(3) Ignition System

(i) Spark plugs.

(ii) Magneto or electronic ignition system.

(iii) Spark advance/retard system, if applicable.

(4) Exhaust manifold, if applicable

(5) Miscellaneous Items Used in Above Systems

(i) Electronic controls, if applicable.

(ii) Hoses, belts, connectors, and assemblies.

(iii) Filter lock assembly (gaseous fuel, if applicable).

Andere Handbücher für BS 50-4

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Wacker Neuson Elektrowerkzeuge Handbücher

Wacker Neuson

Wacker Neuson VP2050A US Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 6555 Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 7060SC Bedienungsanleitung

Wacker Neuson

Wacker Neuson P 35A Bedienungsanleitung

Wacker Neuson

Wacker Neuson WP Bedienungsanleitung

Wacker Neuson

Wacker Neuson EH 25 Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 100-70 Bedienungsanleitung

Wacker Neuson

Wacker Neuson BPU 3050A Bedienungsanleitung

Wacker Neuson

Wacker Neuson PV 35A Bedienungsanleitung

Wacker Neuson

Wacker Neuson BH 65 Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 4045 Bedienungsanleitung

Wacker Neuson

Wacker Neuson BS 65-V Bedienungsanleitung

Wacker Neuson

Wacker Neuson BS 60-2i Bedienungsanleitung

Wacker Neuson

Wacker Neuson BS 50 Betriebsanleitung

Wacker Neuson

Wacker Neuson DPU 2440F WGB Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 5545He Bedienungsanleitung

Wacker Neuson

Wacker Neuson BPU 2950A Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 6055 Bedienungsanleitung

Wacker Neuson

Wacker Neuson BS 50-2 Bedienungsanleitung

Wacker Neuson

Wacker Neuson BS 60-4s Bedienungsanleitung

Wacker Neuson

Wacker Neuson DPU 100-70Les Bedienungsanleitung

Wacker Neuson

Wacker Neuson BS 50-2 Bedienungsanleitung

Wacker Neuson

Wacker Neuson BPS Series Bedienungsanleitung

Wacker Neuson

Wacker Neuson WP 1550A Bedienungsanleitung

Beliebte Elektrowerkzeuge Handbücher anderer Marken

AEG

AEG OMNI-JS Bedienungsanleitung

SIP

SIP 01533 Bedienungsanleitung

Ribimex

Ribimex PRS499 Bedienungsanleitung

3M Fiber Optic Connector Crimp Tool Bedienungsanleitung

Ryobi

Ryobi P524 Bedienungsanleitung

ROJEK

ROJEK FSN 300A Bedienungsanleitung

Kemper

Kemper 1740PRO Bedienungsanleitung

WABCO

WABCO OptiTire Bedienungsanleitung

EINHELL

EINHELL TE-MS 18/210 Li Bedienungsanleitung

Orgapack

Orgapack OR-T 85 Kurzanleitung

TOUGHCUT

TOUGHCUT Diamond 400 Bedienungsanleitung

Yaros

Yaros PB-3603 Bedienungsanleitung

Fein

Fein BSS 2.0 E Einrichtungshandbuch

Baileigh Industrial

Baileigh Industrial SS-2725 Bedienungsanleitung

Milwaukee

Milwaukee 2674-20 Bedienungsanleitung

Fein

Fein BLs 1.6 Bedienungsanleitung

Princess

Princess Electric Multi Sharpener Bedienungsanleitung

FOREDOM

FOREDOM K.1050 Handbuch