Waeco RAPS 36 Bedienungsanleitung

COOLPOWER 36

Operating Instructions

Model: RAPS 36

M_41102

CoolPower36_41102 30/10/04 11:54 AM Page 1

Instructions CoolPower 36

Please read instructions carefully before using your CoolPower36.

Keep instructions in a safe place for future reference.

Index

1 Before ﬁrst use………...…………………………….……………………….. 3

2 Installation and operation………………………………………...………... 3

3 Fridge running time………………………………………………………….. 3

4 Testing…………………………………………………………….……………. 4

5 Charging……………………………………………………………………….. 4

6 Depth of discharge v’s battery life……………………………….……….. 5

7 Storage…………………………………………………………….…………… 5

8 Troubleshooting…………………………………………………..………….. 6

9 Technical information…………………………………………….…………. 6

CoolPower36_41102 30/10/04 11:54 AM Page 3

Instructions CoolPower 36

1. Before ﬁrst use

Before using for the ﬁrst time, charge your CoolPower36 using one of

the methods described in 5. Charging.

2. Installation and operation

Your CoolPower36 is designed to run standing upright for stability and

convenient access to sockets and voltage display. However operation at

any angle, from sideways to upside down is permissible. The internal cells

are completely sealed and leak proof.

2.1 In vehicle

- Fit the charge lead screw terminal to the battery ‘CHARGE’ socket

and plug the other end into the vehicle cigarette socket.

- If the WAECO Fast Charge Kit, RAPS12R-U has been ﬁtted to the

vehicle (recommended), connect the charge lead from the battery

to Fast Charge Kit socket.

- Plug your WAECO kompressor fridge or other 12V appliance into

one of the front CoolPower sockets.

2.2 Stand alone

Connect your WAECO kompressor fridge or other 12V appliance into

one of the Front CoolPower sockets. To run your fridge for the longest

possible time, make sure your CoolPower is fully charged ﬁrst

(see 5. Charging).

3. Fridge running time

Your CoolPower36 is designed to run Kompressor CDF and CF models

from CF18 up to CF60, but will also run the larger CF models for a limited

time. Approximate run times are as follows:

Models Approx. Run Time*, Operating As:

Fridge Only Freezer Only Fridge/Freezer

CDF / CF18 to CF60 27 – 30 hrs 10 – 14 hrs n/a

CF80 / CF110 n/a n/a 9 – 11 hrs

(* @32oC ambient)

Your fridge will run for longer than stated times in cooler ambient

conditions.

CoolPower36_41102 30/10/04 11:55 AM Page 4

Instructions CoolPower 36

4. Testing

Disconnect the charge lead and press the button on your CoolPower

front panel whilst your fridge is running.

4.1 Voltage

Your battery voltage will appear on the digital display. The precise

remaining capacity will vary depending on conditions such as ambient

temperature, but as a general guide will be as follows:

Voltage Capacity

12.8V or more 80% - 100%

12.3V to 12.7V 40% - 80%

11.3V to 12.2V 20% - 40%

4.2 LED’s (on front panel)

A quick visual indication of the condition of your CoolPower can be

obtained at a glance. After disconnecting charging leads and pressing

the test button:

LED Condition (Voltage) Action Required

‘FULL’ (green) ON (12.8V or more) None

Both OFF (11.4V to 12.7V) Charging optional

‘LOW’ (red) ON (11.3V or less) Must Charge

5. Charging

5.1 In-car (12V)

- Plug the charge lead 2-pin screw connector into the ‘CHARGE’

socket on the left hand side of your CoolPower. Then plug the

cigarette plug on the other end of the charge lead either directly

into your vehicle cigarette socket, or (recommended) into the

WAECO RAPS12R-U fast charge kit socket pre-ﬁtted to your

vehicle.

- When the CoolPower is accepting charge from your vehicle battery,

the green LED adjacent to the ‘CHARGE’ socket will illuminate.

5.2 240V mains

- The speciﬁed maximum charging current is 12A, however a 6A or

8A charger (WAECO models MBC600 and MBC800) is recommended

as adequate for your CoolPower36.

-An automatic cutout charger must be used, otherwise

irreparable damage will occur and your warranty voided.

- Disconnect your fridge and DC charging lead from the battery.

CoolPower36_41102 30/10/04 11:55 AM Page 5

Instructions CoolPower 36

- Before turning the battery charger on, connect the alligator clamps

to the + and – posts at the top of the CoolPower36, ensuring good

contact. Now turn the charger on.

- Charging times will vary depending on depth of battery discharge

prior to charging, but as a guide, assuming 80% discharge it will

take the following times:

Charger Charge Time

MBC600 (6A RMS) Approx. 12 hrs

MBC800 (8A RMS) Approx. 11 hrs

- To test your battery after charging, disconnect the charger, wait 30

minutes and then follow the procedure outlined in 4. Testing.

6. Depth of discharge v’s battery life

- The depth of discharge (DOD) is the amount the battery is drained

without charging. For example a remaining capacity of 20% equates

to an 80% DOD.

- The cycle service life is the number of times the battery will cycle from

fully charged to a given DOD. For a battery in continuous use

approximate service life ﬁgures are as follows:

DOD Service Life (# Cycles)

80 % 300

50 % 580

30 % 1,350

- Total battery life is a combination of service life and storage

conditions when not in use and is inﬂuenced by other variables.

However as a general guideline you can increase the life of your

battery by not discharging any further than necessary before

charging.

7. Storage

All batteries beneﬁt from periodic charging when not in use. Following

this advice will ensure optimum life from your CoolPower36.

Self-discharge characteristics vary with ambient temperature and age,

but as a general guideline the battery should be fully charged every

3-4 months.

CoolPower36_41102 30/10/04 11:55 AM Page 6

Instructions CoolPower 36

8. Troubleshooting

a) Battery charge OK, no power to fridge

i) Check all connections – ensure they are secure and clean

ii) Check fuse located at rear of battery directly behind the socket

powering your fridge. If blown, replace with 15A 3AG fuse

b) Not fully charging in-car

i) Check connections – ensure they are secure and clean

ii) Is the WAECO RAPS12R-U Fast Charge Kit ﬁtted? If not, the vehicle

wiring may not be heavy enough to deliver adequate charging

current. Fit RAPS12R-U to vehicle.

For further assistance call WAECO Technical (07) 55076040

9. Technical Information (RAPS 36):

Output sockets: 1 x 10A cigarette, 1 x 15A ‘hella’ style (fused separately)

Fuses: 2 x 15A 3AG

Input sockets: 1 x 2-pin screw type (small) for DC charging

1 x 2-pin screw type (large) for 72Ah connection

to second RAPS36 (not supplied – must be purchased

separately)

Voltage test: Push button digital volts display

‘FULL’ LED (green) = 12.8V or more

‘LOW’ LED (red) = 11.3V or less

DC Charging Lead: 2.4m long, 2 pin screw connection battery end, cigarette

plug other end

Charge LED (green): Adjacent to screw socket. On when battery connected to

in-car system and accepting 12V charge from vehicle

battery

AC Charging: Max. charging current = 12A

Connection via + and – post terminals

Battery Cells: 2 x 12V 18Ah(20hr) deep cycle Absorbent Glass Mat (AGM)

Operating temp. range -20 to +60oC

Operation upside down acceptable

Weight: 13.6kg

Dimensions: W230 x H245 x D227mm

CoolPower36_41102 30/10/04 11:55 AM Page 7

Instructions CoolPower 36

FIN

WAECO Finland OY

FIN-00880 Helsinki

Pulttitie 17

phone: +3 58-42/4 59 22 00

fax: +3 58-9/7 59 37 00

WAECO Italcold SRL

I-61015 Novafeltria

Zona Industriale Sartiano, 298/9

phone: +39-05 41/92 08 27

fax: +39-05 41/92 02 37

WAECO Norge AS

N-3208 Sandefjord • Leif

Weldingsvei 16

phone: +47-33 42 84 50

fax: +47-33 42 84 59

WAECO Benelux B. V.

NL-4700 BL Roosendaal

Postbus 1461 • Ettenseweg 60

phone: +31-1 65/58 67 00

fax: +31-1 65/55 55 62

WAECO Svenska AB

S-42131 Västra Frölunda

(Göteborg)

Gustaf Melins gata 7

phone: +46-31/7 34 11 00

fax: +46-31/7 34 11 01

WAECO UK Ltd.

UK-Broadmayne • Dorset DT2 8LY

Unit G1 • Roman Hill Business

Park

phone: +44-13 05/85 40 00

fax: +44-13 05/85 42 88

www.waeco.com.au

AUS

WAECO Pacific Pty. Ltd.

21 Taree Street

Burleigh Heads QLD 4220

phone: (07) 5507 6000

fax: (07) 5522 1003

e-mail: [email protected]

WAECO International GmbH

D-48282 Emsdetten •

Hollefeldstraße 63-48282

phone: +49-25 72/8 79-0

fax: +49-25 72/8 79-3 00

E-Mail: [email protected]

WAECO (Schweiz) AG

CH-8153 Rümlang (Zürich)

Riedackerstrasse 7a

phone: +41-1-8 18 71 71

fax: +41-1-8 18 71 91

WAECO Danmark A/S

DK-6640 Lunderskov • Tværvej 2

phone: +45-75 58 59 66

fax: +45-75 58 63 07

WAECO Ibérica S. A.

E-08340 Vilassar de Mar

(Barcelona)

Torrent de Ca l’Amat, 85

phone: +34-93/7 50 22 77

fax: +34-93/7 50 05 52

WAECO Distribution SARL

F-60240 Chambly (France)

ZAC 2 – Les Portes de l’Oise

Rue Isaac Newton • BP 59

phone: +33-1/30 28 20 20

fax: +33-1/30 28 20 10

CoolPower36_41102 30/10/04 11:55 AM Page 8

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Waeco Kamerazubehör Handbücher

Waeco

Waeco BatteryPack BP 124 Bedienungsanleitung

Beliebte Kamerazubehör Handbücher anderer Marken

Viltrox

Viltrox EF-NEX Montageanleitung

Calumet

Calumet 7100 Series CK7114 Bedienungsanleitung

Ropox

Ropox 4Single Series Bedienungsanleitung

Cambo

Cambo Wide DS Digital Series Betriebsanleitung

Samsung

Samsung SHG-120 Bedienungsanleitung

Ryobi

Ryobi BPL-1820 Bedienungsanleitung

Aegis

Aegis ABL-36020P Bedienungsanleitung

Fantasea

Fantasea EyeGrabber F Series Bedienungsanleitung

Honeywell

Honeywell HDZ20HD Bedienungsanleitung

EGO

EGO BA1400T Bedienungsanleitung

Sima

Sima SRW-62 Bedienungsanleitung

Shape

Shape A7SSMKIT Bedienungsanleitung

Slide Kamera

Slide Kamera HST-2 Bedienungsanleitung

Power works

Power works 2902613 Bedienungsanleitung

SES

SES SE-2047-2 Bedienungsanleitung

Starlite

Starlite OctoDome nxt Bedienungsanleitung

Custom Brackets

Custom Brackets Digital PRO-M Bedienungsanleitung

Vivo

Vivo MOUNT-LT01C Bedienungsanleitung