Wahl LITHIUM PRO Series Bedienungsanleitung

LITHIUM PRO SERIES CLIPPER

INSTRUCTIONS

LITHIUM PRO SERIES CLIPPER

CONTENTS

GENERAL USER INFORMATION Page 3

IMPORTANT SAFEGUARDS Page 4

OPERATING INSTRUCTIONS Page 8

CLIPPER USE & MAINTENANCE Page 11

CLEANING Page 13

TROUBLESHOOTING Page 14

LITHIUM-ION BATTERY REPLACEMENT

REMOVAL AND DISPOSAL Page 14

CLIPPING & TRIMMING DOGS Page 15

TRIMMING HORSES Page 19

WIRING Page 21

DISPOSAL Page 21

GUARANTEE Page 22

Please read all instructions carefully to familiarise yourself

with your new clipper before using.

Save these instructions for further reference.

For any further assistance or information call Customer Services on

T: 01227 740066

or visit

W: www.wahl.co.uk

E: customer[email protected]

LITHIUM PRO SERIES CLIPPER

GENERAL USER INFORMATION

Information about using the operation manual

►Before using the appliance for the rst time,

you must read and understand the operation

manual completely.

►Consider the operation manual as part of the

product and store it in a safe and accessible

place.

►Include this operation manual if passing the

appliance on to a third party.

►In the case of conicts with national safety

specications or instructions, the national

requirements must be followed.

Explanation of symbols and notes

DANGER

Danger of electric shock which may result in serious physical injury or death.

DANGER

Danger of explosion which may result in serious physical injury or death.

WARNING

Warning of possible physical injury or a health risk.

CAUTION

Information about danger of material damage.

Note with useful information and tips.

Action to be taken by owner.

Carry out these actions in the sequence described.

List

LITHIUM PRO SERIES CLIPPER

Please retain this leaet for future reference.

READ ALL INSTRUCTIONS BEFORE USING.

IMPORTANT SAFEGUARDS

When using this electrical appliance, especially when

children are present, basic safety precautions should

always be observed including the following.

Requirements

►Read the instruction manual in full to

familiarise yourself with the product before the

rst use.

►This appliance can be used by children

from aged 14 years and above and

persons with reduced physical, sensory or

mental capabilities, or lack of experience

and knowledge, if they have been given

supervision or instruction concerning use of

the appliance in a safe way and understand

the hazards involved. Children shall not

play with the appliance. Cleaning and user

maintenance shall not be made by children

without supervision.

►Use this appliance only for its intended

purpose.

LITHIUM PRO SERIES CLIPPER

Hazards

Danger! Electric shock due to damage to

appliance

►Do not operate the appliance with a broken

cord, plug or charger, or if the appliance

malfunctions, or is dropped or damaged in any

way.

►Any servicing or repair must be performed

by Wahl (UK) Ltd or a suitably qualied

professional.

►The use of attachments that are not supplied

by the manufacturer may cause re, electric

shock or injury and damage to the appliance.

Danger! Electric shock due to penetration

of liquid.

►To protect against risk of electrical shock,

never immerse the unit or let it come into

contact with water or any other liquids. Do not

use the unit with wet hands. If the appliance

should become wet, damp or fall in water,

remove plug from mains socket immediately.

Do not put your hands in the water. Do not

take into bathroom.

Danger of explosion

►Never use the appliance where aerosol (spray)

products are being used or where oxygen is

released.

LITHIUM PRO SERIES CLIPPER

►Exhausted batteries/rechargeable batteries/

Lithium batteries should not be disposed of

in the household waste. Dispose of them in a

completely discharged state in accordance with

local legal regulations. Do not throw into re

where heat could cause them to rupture.

Warning! Injuries due to incorrect handling

►Switch off the appliance and unplug from outlet

when not in use, before putting on or taking

off attachments and also before cleaning the

appliance.

►Never use your appliance without paying

attention! Except when charging, always

unplug this appliance from the electricity outlet

immediately after using.

Caution! Danger of product damage

►

Do not wrap the cord around the appliance / charger.

►

Do not use outdoors or in damp areas.

►

Never carry the unit by its power cord.

►

Do not drop or insert any object into any opening.

►

Use this appliance only for its intended purpose.

►

During use, do not place or leave appliance where it

may be damaged by an animal or exposed to weather.

►

The blades on your clipper have fine teeth for precise

cutting. Handle carefully when using against the

animals skin to avoid injury or irritation.

LITHIUM PRO SERIES CLIPPER

OPERATING INSTRUCTIONS

CHARGING THE BATTERY

Before the appliance is used for the rst time, it should

be charged for 5 hours, you will need to plug the

transformer directly into the unit but be sure the clipper

is switched OFF when charging. When the battery is

fully charged, the equipment can be used for up to 120

minutes continuous run time. It will then take 3 hours to

fully recharge the battery again.

CHARGING PRECAUTIONS

• Only charge the device when charging is required.

A charge is required when the product begins to

slow down or has trouble maintaining speed while

performing its intended function. (Note: If the product

is cord/cordless, and you do run out of charge, you

may continue running the device corded from the

mains to complete your task.)

• If the device is fully discharged, apply a charge right

away to prevent damage or inability to recharge.

• A partial charge is ne; Lithium-Ion does not require a

full charge.

• Charge the device at moderate temperatures. Do not

charge below freezing.

• Do not leave the device connected to the charger

when the charger is not plugged into an outlet for

charging.

• Perform regular maintenance on the device including

keeping the blades oiled, clean, and free of debris to

prevent taxing the battery.

LITHIUM PRO SERIES CLIPPER

FOR DIRECT PLUG-IN OPERATION

1. Should you need to use the appliance in corded

mode when the battery is fully discharged, it is best

to charge the appliance in OFF position for several

minutes before use. During use, you may notice

a change in blade speed. This is perfectly normal.

The clipper will still perform adequately in corded

mode with fully discharged batteries.

2. Connect the appliance to the transformer cord, and

plug the wall transformer into an electrical outlet.

3. Move the switch to ON position.

4. After use, turn to OFF position then disconnect wall

transformer from outlet.

BLADES

• Blades do not become dull from cutting hair, they

are dulled by abrasive particles on the hair, such as

dirt, sand and grease etc.

• Blades will not cut if abrasive particles are picked

up and carried by the oil lm between the blades.

These particles tend to hold the blades apart and

cause chewing and pulling of the hair instead of

clean cutting.

• The cutting blades furnished with Wahl Animal

clippers are made of special high carbon steel

scientically heat-treated for correct hardness.

Years of experience have created a special process

for grinding these blades to a superior sharpness.

Oil blades before and during use.

• Oiling the blades performs two distinct functions.

a. Provides a low friction, very thin lm lubricant

between the cutting blades so that they can take a

LITHIUM PRO SERIES CLIPPER

full cutting stroke without becoming hot from friction.

b. Flushes abrasive particles and hair out from

between the blades.

CHANGING THE BLADE SET

Warning! Injuries and material damage due to

incorrect handling.

1. Switch the appliance o󰀨 using the on/o󰀨 switch

(g.1a/b) and disconnect from the power supply.

2. Undo the screws on the blade set, (T20 Torx

screwdriver required) remove the bottom blade and

the top blade (g. 5).

3. To replace the blade rst check that the tension

spring (g 6c) is properly located under the lug in

centre of housing (g 6b).

4. Turn motor cam so that the pin is in the top position

(g 6a).

5. Place the cam follower (g 6e) on to the small blade

(g 6f) ensure the cam follower is positioned as

shown.

6. Put a smear of grease into the cam slot on cam

follower (g 6d).

7. Position the small blade assembly on to the head

of the clipper, ensure the ends of the spring line-up

with the slots on the cam follower (g 6g) and the

cam slot lines-up with the pin on the motor cam.

8. Press and hold blade assembly against head of

the clipper with one hand, take care as you will be

pushing against the spring tension, with the other

Inhaltsverzeichnis

Andere Wahl Haarschneider Handbücher

Wahl

Wahl 9649 Bedienungsanleitung

Wahl

Wahl 1588 Bedienungsanleitung

Wahl

Wahl 8504L1 Bedienungsanleitung

Wahl

Wahl NAC Bedienungsanleitung

Wahl

Wahl Z100 Bedienungsanleitung

Wahl

Wahl 1881C Bedienungsanleitung

Wahl

Wahl 1870 Bedienungsanleitung

Wahl

Wahl 1871 Li Bedienungsanleitung

Wahl

Wahl 1170 Bedienungsanleitung

Wahl

Wahl 1245 Bedienungsanleitung

Wahl

Wahl MC3 Bedienungsanleitung

Wahl

Wahl 1871 Bedienungsanleitung

Wahl

Wahl 1591 Q Bedienungsanleitung

Wahl

Wahl 1260 Bedienungsanleitung

Wahl

Wahl 1854 Bedienungsanleitung

Wahl

Wahl Moser Prima Bedienungsanleitung

Wahl

Wahl Type 1230 Bedienungsanleitung

Wahl

Wahl Genio Pro 1874 Bedienungsanleitung

Wahl

Wahl 1245 Bedienungsanleitung

Wahl

Wahl 4212-0470 Bedienungsanleitung

Wahl

Wahl Adore 1872 Bedienungsanleitung

Wahl

Wahl Type 1230 Bedienungsanleitung

Wahl

Wahl Bravura 1870 Li+ Bedienungsanleitung

Wahl

Wahl Hair Clippers Bedienungsanleitung

Beliebte Haarschneider Handbücher anderer Marken

Clatronic

Clatronic HSM 800 Bedienungsanleitung

Mellerware

Mellerware MACRO ALDANY MA20001 Bedienungsanleitung

VALERA

VALERA X-Master 652 Bedienungsanleitung

Remington

Remington HC5780 Bedienungsanleitung

Lister

Lister Legend Bedienungsanleitung

Philips

Philips HC5440/80 Bedienungsanleitung

Andis

Andis MBA 23125 Bedienungsanleitung

Philips

Philips Philishave HQC488/61 Bedienungsanleitung

Shear Magic

Shear Magic Nifty 1800 Bedienungsanleitung

Philips

Philips QC5390 Bedienungsanleitung

Andis

Andis US-1 Kurzanleitung

Panasonic

Panasonic EH-KA81 Bedienungsanleitung

Philips

Philips HC5450 Bedienungsanleitung

Andis

Andis US-1 Montageanleitung

Remington

Remington Classic HC450 Bedienungsanleitung

Andis

Andis ML Montageanleitung

O'Barber

O'Barber MINI SLIDE Bedienungsanleitung

Oster

Oster 76110 Bedienungsanleitung