Waitsfield Cable
P.O. Box 9, Waitsfield, VT
www.waitsfieldcable.com ■496-5800
Make sure you are within range (about 12-15 feet) and pointing the remote at the
component.
Try fresh batteries. Your remote uses two AA alkaline batteries.
If it still isn’t working, use the following steps to reprogram your remote.
To reprogram your remote to work the set-top box:
On your remote control, press and hold the CBL and OK/SEL button for three seconds,
until the CBL button lights, then release the buttons.
On the keypad, press 0 0 2, then the CBL button, which will blink twice to show that it has
accepted the code. The set-top box should turn off or on. (This procedure must be done
within 20 seconds, or the remote will exit the programming mode.) The remote is now
reprogrammed to your cable set-top box. (This also works on the UR3-SR big-button
remote).
I still can’t get my remote to work my set-top box
Try a factory reset: Press and hold the CBL and REC buttons for five seconds, until the
Component buttons flash three times in sequence. Release the buttons, and the remote
should now control the set-top box. (Note: this will erase any codes that you have
stored in the remote to control your other components, such as TV, DVD, etc.
Whenever I press a button, the AUX, DVD, VCR, TV and CBL buttons flash twice
This is a low-battery indicator. Replace with two AA alkaline batteries.
Why do I need to enter 3-digits when selecting a channel?
By setting your remote to Auto Tune, you will no longer have to enter 3-digits when
selecting a channel.
Steps on Programming Remote To Auto Tune
Using your remote, press the Menu button.
Choose the Main Menu (house icon) by using the left/right arrows on either side of the
OK/SEL button. Highlight the Main Menu icon, then press OK/SEL.
Scroll down in the menu until Setup is highlighted and hit OK/Select.
Make sure Guide Setup is highlighted and click OK/Select.
Scroll down to the third entry in the list, which says Channel entry behavior: No
Auto Tune.
Press your left arrow on the remote and it will change to Auto Tune. Now press
OK/Select.
Click the Exit button to close the Menu
TIP: If you use your remote to control TV, DVD or VCR functions and have more than
one set, label each remote so they don’t get mixed up!
Visit our website at www.waitsfieldcable.com for more tips and online
tutorials on using your remote and Interactive Program Guide.
