Warmlite WL39002 Bedienungsanleitung
WL39002 -manual -1.indd 1 13/10/2011 09:38:54
Imported & Distributed throughout the U.K.
By PFD. ST4 2NL www.warmlite-products.co.uk
Instruction manual
Portable Gas Heater
with Quartz Electric Bars
WL39002
Like to nd out more? Visit www.GrownGreen.info
Responsible Transport:
This product was made in China. Most things are. But
when we brought it over here, we shipped it on a
container ship, along with 10,000 containers of other
things. It may not be fast, it takes about 4 weeks, but it’s
the greenest way of doing it.
100% Recyclable:
All the cardboard in this packaging is 100% recyclable.
If you can’t think of a good use for the box as it
is, please fold it at and put it out with your other
recycling. If you don’t have regular collections, it can be
taken to any cardboard recycling area or even used in
your composter. Now you can play your part!
Paperless Design:
We started thinking about how to make this packaging
“Green” from the very beginning,
and thought that using as little paper as possible would
be a good idea. So the whole design process was carried
out online. We didn’t post anything, kept printouts to a
minimum and let technology take the strain.
Sustainable Packaging:
The trees used to make the card board for this box
all come from sensitively managed forests. Since 2006,
the people that made the cardboard for this box have
planted over 700,000 acres of trees. On top of that, the
whole manufacturing process is ISO14001 approved.
WL39002 -manual -1.indd 2-3 13/10/2011 09:38:55
Testing gas for leaks:
If you suspect that the heater is leaking, turn off the gas supply and have the unit
inspected by a qualied technician.
Do not attempt to locate the source of leak with a naked ame.
Locate a leak by sound, smell or by applying soapy water,bubbles will form and
indicate the site of the leak.
Always change LPG cylinder in well ventilated area, and from any source of ignition
such as a liten candle, cigarette eg.
Parts Identication
Technical Data
This product is guaranteed for 12 months from the date of the original purchase.
If any defect arises due to faulty materials or workmanship the faulty products must
be returned to the place of purchase. Refunds or replacement is at the discretion
of the store.
The following conditions apply:
The product must be returned to the retailer with the original proof of purchase.
The product must be installed and used in accordance with the instructions
contained in this instruction guide.
It must be used only for domestic purposes.
It does not cover wear and tear, damage, misuse or consumable parts.
PFD has no responsibility for incidental or consequential loss or damage.
Valid in the UK and Eire only.
Guarantee.
Gas Heat Imput 4100W
Gas Catergory LPG ( Liquid Propane -Butane Gas)
Gas Pressure (28-30) mbar
Pin Code 598 CL250
Recommend to use 50mm hose for connection, which should be certied according
to applicable EN-standard BS EN 3212/2;
Regulator should be certied according to EN12864 (from rate:max.1.5kg/h)
Product Helpline.
01733 404 702
For all your product needs.
PRODUCT HELPLINE
01733 404 702
FOR ALL YOUR PRODUCT ENQUIRIES
Power 220~240V 50Hz 1250W
The type of regulator that is use is dependant on the connection on the gas bottle
used and this may be,dependant on gas supplier and your geographical location
If you are unsure which type of regulator you will need seek advice from your gas
supplier. Please see below
Typical U.K. Regulators
Regulators
Other Types of Regulators
which can be used in countries
such as Ireland and Spain
WL39002 -manual -1.indd 4-5 13/10/2011 09:38:56
Product Helpline.
01733 404 702
For all your product needs.
Product Helpline. 01733 404 702 For all your product needs.
Safety Warnings:
Read the instructions in the manual carefully. it has important information both
for operation use and for your safety.
Do not use faulty appliances.
Your heater should be checked anually by a qualied person for safe operation
and to detect any fault.
Retain these instructions for future reference. if necessary, a new copy
may be obtained from your dealer.
Turn off the gas container valve after use
The appliance is suitable for 14.2kg/5.5kg LPG container, when change gas container
move the appliance to a ame-free well ventilated atmosphere.
Do not move the appliance when in operation or when cooling.
Avoid to twisting the gas hose as this may cause the hose to stress and fracture.
Turn off the regulator and disconnect the regulator from cylinder, allow
Turn heater to control fully off position before removing and replace the cylinder
Do not attempt to remove the regulator while the heater is still running.
Do not move the heater while it is in use.
Always face the heater towards the centre of the room.
Use it only in a well-ventilated room. Ventilated is vital for the efcient
performance of this heater and for safety of the occupants of the room in which
it is being used.
Allow plenty of fresh air in, never seal up the doorways and windows.
Prevent young children and the inrm from touching very hot surfaces.
The normal dress guard only protects against accidental clothing contact.
Do not place clothes or other material on the heater.
Keep all ammable materials at least one meter away from the heater.
Turn off the gas valve and gas supply after use.
Never use or store solvents and pressure pack cans near a gas heater
even if the heater is turned off.
Never dispose of rubbish such as cigarette butts in a gas re-this can affect
Combustion and produce dangerous pollutants. and carbon monoxide
Always operate the gas control and cylinder valve from the side or rear
of the heater.
Standing in front of the heater exposes you to the risk of burns
This product is not intended for commercial use
This product is not intended to be operated by children or the inrm unless
adequate supervision and/or training has been given by the responsible person.
IIn the event of a gas leak open all doors and windows and do not use electrical
equipment as these may produce a spark which could ignight the LPG vapours
Lighting the Heater:
Before connecting the regulator to the gas cylinder. Cheek whether there
is a rubber washer on the regulator, and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise.
Turn the gas control knob on the heater to setting 1(g 4).
Press the control knob down and hold in the pressed condition. This will allow
gas to ow to the pilot and center burner.
While holding the control knob in the pressed position push the piezo electric
ignition (g 4) button 2 or 3 tines. Each tine you strike this piezoelectric ignition
you will hear a clicking sound as well as see a spark on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed
position for a further 10 to 15 seconds thus activating the ame failure safety
device.
The pilot and center burner should remain alight.
You may now adjust the heater setting to Low/Med/High as required.
Turning off the heater:
To turn off the heater, turn the control knob to position 1 and close the gas
cylinder valve by turning the knob on the cylinder clockwise. Ensure that the
pilot ame the center burner are extinguished.
Heat and ignition controls
Piezo Quartz Ignition Button
MAX HEAT
MIN HEAT MED HEAT
Installation
Put the cylinder into the gas heater then install the protection bafe to make
sure the cylinder cant' move when the re is moved from room to room
connect the pipe to the gas valve with cap (make sure no leakage)
Connect another side of the pipe to the regulator with cap (make sure no leakage)
Open the gas valve before using the heater, and close the gas valve after using.
WL39002 -manual -1.indd 6-7 13/10/2011 09:38:56
Product Helpline.
01733 404 702
For all your product needs.
Product Helpline.
01733 404 702
For all your product needs.
How to Use the Quartz Heater
This is Only relevant to heaters with Electric Quartz Heating elements
The electric heating system is designed with technology of infrared radiation.
Even if it is used in an unsealed and large size room, heating efciency will be perfect.
Ensure that the house hold electric supply is earthed.
Switch off the wall socket and insert the plug into the socketand switch on the wall
socket.
Press switch - to start the top quartz tube.
Press switch = to start the other two quartz tubes.
Press switch - and = to start all quartz tubes.Heat load reaches to peak.
After use please ensure that all switchess are turned off then switch off the wall
socket remove the plug from the wall socket. (As shown in diagram below ).
Maintenance:
Maintenance and cleaning must be carried out with the gas supply turned off and the
heater cold. do not attempt to clean the heater while it is in use.
your heater should be checked annually by a qualied person for safe operation and
to detect any faults.
If any faults are detected in use, stop using the heater and contact your dealer or the
advice helpline for advice.
Disposal of Unit
Disposal instructions for warmlight items in accordance with the WEEE directive.
Appliances bearing the symbol shown here may not be disposed of in domestic rub-
bish. You are required to dispose of old electrical and electronic appliances like this
separately. Please visit www.recyclemore.co.uk, or www.recylcenow.co.uk for access
to information about the recycling of electrical items. The WEEE directive, introduced
in August 2006, states that all electrical items must be recycled, rather than taken
to landll. Please arrange to take this appliance to your local Civic Amenity site for
recycling, once it has reached the end of its life.
Electrical Safety
The wires in the mains lead are coloured in accordance with the following code:
GREEN/YELLOW: EARTH (E)
BLUE: NEUTRAL (N)
BROWN: LIVE (L)
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows
:
The wire which is coloured GREEN & YELLOW must be connected to the terminal
in the plug which is marked with the letter “E” by the earth symbol or coloured
GREEN, GREEN/YELLOW.
The wire which is coloured BLUE must be connected to the terminal which
is marked with the letter “N” or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which
is marked with the letter “L” or coloured RED
Always ensure that the Mains Cord is xed into the plug through the Cord Guard
or Cable Clamp, (plug wiring diagram above), and that the Cord Guard screws are
tightened to clamp the Cord (outer sheath and inner coloured wires) into position
in the plug. Make sure that plug top is also tted securely.
This appliance must be protected by a 13 Amp fuse in a 13 Amp type (BS1363) plug.
Should you need to replace the fuse, use only a 13Amp ASTA approved BS1362 fuse
(13A).
WL39002 -manual -1.indd 8-9 13/10/2011 09:38:57
Inhaltsverzeichnis
Andere Warmlite Gasheizung Handbücher
Beliebte Gasheizung Handbücher anderer Marken
Superior
Superior BGE18NV Bedienungsanleitung
Dru
Dru Room-sealed atmospheric gas-fired heating... Bedienungsanleitung
klover
klover TKR 35 Bedienungsanleitung
Rothenberger Industrial
Rothenberger Industrial 035984 Bedienungsanleitung
New Buck Corporation
New Buck Corporation 34 Bedienungsanleitung
Hargrove
Hargrove Timberland Glow Kurzanleitung
