9
Step 3 - Mounting the Rail
Ladder Rails
•Use a tape measure to
measure the centre to centre
distances between the wall
mounts (6) which are secured
in each leg and concealed
(7) or exposed wiring (8) wall
mounts.
•With all 4 legs secured to the
towel rail body, install the wall
mounts (6) into each leg using
the grub screws (3).
• Install the concealed wiring
wall mount (7) or exposed
wiring wall mount (8).
•Install the remaining 2 legs
(1A) to the towel rail body as
shown in Step 2.
•Mark the measurements taken
in the previous step on the
wall of your intended towel
rail location keeping in mind
that the lowest rail should be
at least 600 mm above the
floor level.
•Ensure the markings on the
wall are level.
•Attach the final leg (1B or
1C), for exposed or concealed
wiring, to the towel rail body
using the grub screws (2) as
shown.
65
3
7
4
•Drill 3 holes in the wall for
each of the 3 x wall mounts
(6).
NOTE: For exposed wiring drill
a 4th hole of equal size.
For masonry walls gently tap
wall plugs (4) into the holes
using a hammer.
8
