Wavenet Technology Dualwave-I Bedienungsanleitung

Dualwave-I

Wireless Modem

User Manual

Revision 3.2

July 2003

ACN 079 965 003

Publication No. DWI10012WT32

Published July 2003

This publication is copyright and no part may be reproduced or copied without the prior consent of:

Wavenet Technology Pty Ltd.

140 Burswood Rd

Burswood, 6100

Western Australia

Telephone: +61 8 9262 0200

Facsimile: +61 8 9355 5622

E-mail: [email protected]

Web Site: www.wavenet.com.au

This manual is intended to be used for the operation of Wavenet Technology equipment. Performance

figures quoted are typical values and subject to normal manufacturing and service tolerances.

Wavenet Technology Pty Ltd reserves the right to alter, without notice, the equipment, software or

specification to meet technological advancement.

COMPAQ and the Compaq logo are registered in the U.S. Patent and Trademark Office. iPAQ is a

trademark of Compaq Information Technologies Group, LP. Microsoft, ActiveSync, Windows and the

Windows logo are registered trademarks or trademarks of Microsoft Corporation in the United States

and other countries. Other product and company names herein may be the trademarks of their

respective owners.

Whilst every precaution has been taken in the preparation of this document, neither Wavenet

Technology Pty Ltd nor any of its representatives shall have any liability to any person or entity with

respect to any liability, loss or damage caused or alleged to be caused directly or indirectly by the

information contained in this document.

Published by Wavenet Technology Pty Ltd.

This device has not been authorized as required by the rules of the Federal Communications

Commission (FCC). This device is not, and may not be, offered for sale or lease, or sold or

leased within the USA, until authorization is obtained.

This product contains a transmitter approved under the FCC rules.

FCC ID:PQS-DWI800D

This device complies with Part 15 of the FCC rules.. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received including interference that may cause undesired

operation.

This product is approved under Industry Canada (IC) RSS119 rules.

IC: 4062A-DWI800D

Dualwave-I Modem User Manual ___________________________________________________________ Contents

DWI10012WT31 3 Wavenet Technology

Contents

Introduction ......................................................................................................5

Modem Features ..........................................................................................6

Compliance Statement .................................................................................7

Information for Your Safety...........................................................................7

System Requirements ..................................................................................9

Checking the Package Contents ..................................................................9

Exploring Your Dualwave-I Modem ............................................................10

Power/On-Line Indicator .........................................................................11

Low Battery Indicator ..............................................................................11

Battery Charging Indicator ......................................................................12

Getting Started...............................................................................................13

Setting up the Modem and iPAQ ................................................................13

Dualwave-I Modem Software Overview .....................................................13

DWiUART.ppc30_arm.CAB....................................................................13

DWiVDD.ppc30_arm.CAB ......................................................................13

MSMQ.ppc30_arm.CAB .........................................................................14

Installing the Modem Software ...................................................................14

Removing Software From Your iPAQ .....................................................17

Fitting the external battery to the modem ...................................................19

Engaging the iPAQ with the modem...........................................................20

Removing the Dualwave-I Modem..........................................................20

Charging the Modem Battery......................................................................21

Using Your Dualwave-I Modem .....................................................................23

Switching the Modem On/Off......................................................................23

Using the Modem Info Application..............................................................23

RF (Network Status) Tab ........................................................................24

Modem (Status) Tab ...............................................................................25

Settings Tab............................................................................................26

Messages Tab ........................................................................................28

Applications Tab .....................................................................................30

About Tab ...............................................................................................31

Synchronising Data Between Your iPAQ and Computer............................31

Updating Firmware on Your Dualwave-I Modem........................................31

Installing New Software on Your iPAQ .......................................................32

Troubleshooting .............................................................................................33

Technical Support ......................................................................................36

Specifications.................................................................................................39

Contents ___________________________________________________________ Dualwave-I Modem User Manual

Wavenet Technology 4 DWI10012WT31

Dualwave-I Modem User Manual __________________________________________________ Care & Maintenance

DWI10012WT31 5 Wavenet Technology

Introduction

The Wavenet Dualwave-I modem is a high performance wireless

modem developed for the Compaq iPAQ Pocket PC, H3800 and

H3900 series devices. It enables access to worldwide DataTAC

wireless networks to send and receive email, job dispatch, stock market

trading, Internet browsing, etc. All of which can be done while in

transit.

Front and Rear views of the Dualwave-I Modem

This manual provides details on how to set up, charge and use the

modem. There is a troubleshooting section to the rear of the manual

and a section on care and maintenance. Specifications are provided on

the last page.

Care & Maintenance __________________________________________________ Dualwave-I Modem User Manual

Wavenet Technology 6 DWI10012WT31

Modem Features

The Dualwave-I modem has the following features:

• Automatic power on/off when the iPAQ Pocket PC is inserted and

removed, respectively – no manual on/off switch

• Always on-line using the Private DataTAC network with automatic

network roaming

• High sensitivity reception

• Auto wake-up of Compaq iPAQ Pocket PC on incoming messages

with silent “Vibration Alert” option

• Status indicators for visual feedback:

o “Power/On-Line” showing modem and network status

o “Battery Low” warning

o “Battery Charging” status (on the rear face of the battery)

• Externally replaceable rechargeable Li-Ion polymer battery which

can be conveniently swapped as required. A 920 mAh capacity is

fitted as standard, sufficient for a full business day of activity

• Use the modem battery to trickle charge the iPAQ battery during

modem use or as an exclusive extended battery to increase iPAQ

operating time

• Modem battery is recharged simultaneously with the iPAQ Pocket

PC when both units are inserted into the iPAQ Desktop Cradle or

when directly connected to the mains adaptor via the iPAQ serial

port (depending on iPAQ model – refer to the iPAQ user manual)

• Supports Private DataTAC RD-LAP and Native Command

Language (NCL) Protocols

• Easy to attach and remove with plug and play capability (using

supplied drivers)

• Form hugging stylish design with compact ¼-wave helical coil

antenna

Dualwave-I Modem User Manual __________________________________________________ Care & Maintenance

DWI10012WT31 7 Wavenet Technology

Compliance Statement

This equipment has been tested and found to comply with the limits for

a class B digital device, pursuant to Part 15 of the FCC rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the manufacturer’s instructions, may cause

interference harmful to radio communications.

There is no guarantee however, that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined

by comparing the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult your supplier or an experienced radio/TV technician for

assistance.

Warning: Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void the user’s

authority to operate this equipment.

Information for Your Safety

Please read these safety instructions and the operation instructions

provided in this manual before operating the modem or the battery

charger.

SAR (RF Absorption Levels into body)

Your modem contains a low power transmitter and receiver. When it is

switched on, it receives and sends out radio frequency (RF) signals. In

August 1996, the Federal Communications Commission (FCC)

adopted RF exposure (SAR) guidelines with safety levels for handheld

wireless devices. These guidelines are consistent with safety standards

previously set by both USA and International Standards: ANSI C95.1

(1992), NCRP Report 89 (1986), ICNIP (1996).

The modem is designed for handheld operation and has been certified

to comply with the aforementioned FCC guidelines and standards

under worst case conditions (zero separation distance). To maintain

the optimum operational characteristics, no part of the human body

should be in contact with the antenna during use.

Care & Maintenance __________________________________________________ Dualwave-I Modem User Manual

Wavenet Technology 8 DWI10012WT31

Safe Use

Switch the modem off in areas where radio devices are forbidden, or

when it may cause interference or danger. For example, fuel depots

(fuel storage and distribution areas), chemical plants, locations in

which hazardous or combustible gases may be present and where

blasting operations are in progress.

Do not use the modem in an aircraft. Such use may affect aircraft

instrumentation, communication and performance and may be illegal.

Be aware that the modem may interfere with the functionality of

inadequately protected medical devices, including pacemakers.

Additionally, the effect of the radio signals from the modem on other

electronic systems, including those in your car (such as electronic fuel-

injection systems, electronic anti-skid braking systems, and electronic

cruise-control systems) is unknown and malfunction of these systems

may result.

Do not place the modem on an unstable surface. It may fall, causing

injury and damage the equipment.

Discard the modem properly; the unit uses a lithium-ion battery. The

lithium-ion battery should not be disposed of in a fire. Dispose of the

lithium-ion battery in accordance with the laws and regulations in your

area governing disposal of such cell types. Contact your supplier if you

have any questions concerning disposal of the modem or battery.

Never push objects of any kind into the modem through any openings

as they may short out parts that could result in a fire or electrical shock.

Never spill liquid of any kind on the modem. Do not use the modem

near water (for example near a bathtub or sink, in a wet basement, near

a swimming pool etc.). The modem should be situated away from heat

sources.

Unplug the modem from the battery charger and remove the battery

before cleaning. Do not use liquid or aerosol cleaners. Use a damp

cloth to clean the unit.

Disconnect the battery charger, remove the battery and contact your

supplier if:

• Rain or other liquids have been spilled on and damaged the

modem.

• The modem has been dropped or damaged in any way.

• The modem does not operate normally by following the

instructions contained in this manual.

Failure to observe any or all of these instructions will void the

warranty.

Dualwave-I Modem User Manual __________________________________________________ Care & Maintenance

DWI10012WT31 9 Wavenet Technology

System Requirements

To install the modem device driver and Modem Info user interface

software onto your iPAQ, your computer system must meet the

following minimum requirements:

• Intel compatible 486 computer or higher

• Windows 98, or Windows NT 4.0, or later.

• Microsoft ActiveSync v3.5 or later

• 8MB RAM (memory) minimum, 16 MB recommended

• 1MB available hard disk space

• CD-ROM drive

• One available USB/com port (used for the ActiveSync process)

In addition, your iPAQ must have:

• The iPAQ desktop software already installed

• 500kB of available memory

• Microsoft Pocket PC v3.0 or later

Checking the Package Contents

The following items should be included in the box.

You should also have the CD-ROM, which includes

the Modem Info software and this User Manual.

Dualwave-I

Modem

Slim

920mAh

Battery

Care & Maintenance __________________________________________________ Dualwave-I Modem User Manual

Wavenet Technology 10 DWI10012WT31

Exploring Your Dualwave-I Modem

A picture of the Dualwave-I modem is shown below.

The modem is comprised of the following components:

PDA Port Provides a connection between the iPAQ and

the modem.

Latches Connects and releases the iPAQ from the

modem.

Antenna Compact ¼ wave helical coil type

Status Indicators Provides visual feedback regarding network

connectivity (On-Line) and Battery Capacity

Note there is no manual on/off power switch. The modem is automatically

powered on/off when the iPAQ Pocket PC is inserted and removed

respectively.

Low Battery Indicator

Power/On-Line Status

PDA Port

PDA Latch

Antenna

Inhaltsverzeichnis

Andere Wavenet Technology Modem Handbücher

Wavenet Technology

Wavenet Technology DWM0001 Bedienungsanleitung

Beliebte Modem Handbücher anderer Marken

Davicom

Davicom DM562AP Bedienungsanleitung

EpiValley

EpiValley TATA indicom SXC-1080 Bedienungsanleitung

Zte

Zte WiMAX Bedienungsanleitung

Intelimax

Intelimax MA-2060 Bedienungsanleitung

SMC Networks

SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch

Telstra

Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Bedienungsanleitung

Samsung

Samsung AceLink SAM-335A Bedienungsanleitung

Enfora

Enfora Enabler-G Kurzanleitung zur Einrichtung

iRZ

iRZ ATM2-232 Bedienungsanleitung

Zhone

Zhone 6310 Bedienungsanleitung

Paradyne

Paradyne Hotwire 7976 Bedienungsanleitung

US Robotics

US Robotics 3453C Bedienungsanleitung

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung

Zte

Zte MF823 Bedienungsanleitung

Four-Faith

Four-Faith F1403 Bedienungsanleitung

Sierra Wireless

Sierra Wireless AIRLINK MP595W Bedienungsanleitung

Gemtek

Gemtek WiMAX WIXFBR-103 Bedienungsanleitung