WE-EF QLS410 LED Bedienungsanleitung

WE-EF LEUCHTEN

Installation and Maintenance

Instructions

Wall Luminaires surface Mounted

QLS410 LED

QLS420 LED

INSTALLER

HOTLINE

+61 458 933 399

7am – 7pm AEST

Surge Protection

For comprehensive protection of a luminaire installation against lightning

and electrical surges, it is essential to cover mains supply and data input

lines at the distribution board level, by using respective primary (Type 1)

and secondary (Type 2) surge arrestors in compliance with EN61643-11/

IEC61643-1.

Warning

Ensure that all required surge protection measures are in place and

activated prior to luminaire installation. Also, disconnect luminaires before

operating high-power devices such as, for example, electrical arc welders.

IP66, Class I, ta ≤40°C

QLS410 QLS420

Wall Luminaires surface Mounted

Light Source

LED

Maintenance

Apart from cleaning the outside of the

luminaire, no special maintenance is necessary.

Do not spray with high pressure cleaners

Installation

The product must be installed and maintained by a

suitably qualiﬁ

ed person in compliance with the latest

applicable regulations and relevant legislation.

Claims based on defects attributable to improper

installation, application, operation and/or any modi-

ﬁ

cation carried out by the purchaser or third parties,

and the consequences thereof, are excluded.

Installation Procedure – QLS410/QLS420 LED

1. Switch off and isolate the mains electrical supply.

2. Remove wall ﬂange Afrom cover Bby releasing

screws C.

3. Check that rating shown on luminaire label con-

forms with mains electrical supply.

4. Determine positions for two ﬁxings crews D. Drill

relevant holes Eand insert wall plugs F.

Caution: Make sure not to damage any electric

cable, water pipe or other devices while drilling

holes.

5. Feed the mains supply cable G(and the second

cable Hfor through wiring, if required) through the

pressure screw Iat the side of the wall ﬂange,

while setting and ﬁxing wall ﬂange in position.

The pre-installed packing ring His suitable for

cable diameters 7 to 9.5 mm. If the cable is bigger,

replace the pre-installed packing ring with the sup-

plied auxiliary packing ring, which is suitable for

cable diameters 9.5 to 12 mm.

6. Ensure the point arrow mark Ron the wall ﬂange

aims upwards and that the luminaire is properly

oriented. Fix the wall ﬂangebyinser ting and tight-

ening screws D.

7. Connect mains supply leads to respective terminals

in terminal block J(N = Neutral, L1 = Phase,

= Earthing). Tighten pressure screw(s) Iﬁrmly.

For the version with 1-10 V analogue dimming in-

terface, connect mains supply cable Gto respective

terminals in terminal connectors J

(N = Neutral, L1 = Phase, = Earthing) and (D+,

D–= external 1-10 V dc diming device) (Fig. II).

8. Tighten pressure screw(s) I.

9. Reposition cover Bon wall ﬂange Aand secure in

position by evenly tightening the screws C.

Individual connection Through wiring

Fig. II Wiring diagram 1-10 V interface

1) Contents of Circular & TPS Grommet Kit. Products that

do not include a loop through option are supplied with

one kit, products with a loop through option are supplied

with two kits.

a) 1x Compression Nut

b) 1x TPS Grommet to suit 1mm2 to 2.5mm2

core cables

c) 1x Circular Grommet to suit application

(supplied with fitting)

Non-LED versions also include:

d) 3x Silicon Sleeves

2) Select the correct grommet for the application.

3) Slide the compression nut over the cable first, followed

by the grommet.

4) Feed the cable, grommet side first, into the housing, and

ensure enough cable is available to connect to the

incoming supply terminal block.

5) Tighten the compression nut to secure the cable in

place.

6) If required, remove the blanking plug and install the loop

through cabling as per steps 2 to 5.

7) For Non-LED products, strip the cable and over-sleeve

each of the cores with the high temperature sleeves. For

LED product, simply strip the cable suitable for

connection to the terminal block.

8) Connect all cores to the terminal block as labelled.

1) 2)

3) 4)

5) 6)

7) 8)

b) a) c)

Installation - Cable Grommets

Circular

Flat

Circular

Flat

Sleeving required on

non-LED product only

www.we-ef.com

TO9116W0715 © WE-EF 2015

Technical speciﬁcations are

subject to change.

WE-EF LEUCHTEN

Germany

Tel +49 5194 909 0

Fax +49 5194 909 299

info.germany@we-ef.com

WE-EF LUMIERE

France

Tel +33 4 74 99 14 44

Fax +33 4 74 99 14 40

info.france@we-ef.com

WE-EF HELVETICA

Switzerland

Tel +41 22 752 49 94

Fax +41 22 752 49 74

info.switzerland@we-ef.com

WE-EF LIGHTING

United Kingdom

Tel +44 844 880 5346

Fax +44 844 880 5347

info.uk@we-ef.com

WE-EF LIGHTING

Thailand

Tel +66 2 738 9610

Fax +66 2 175 2174

info.asiapaciﬁc@we-ef.com

WE-EF LIGHTING

Australia

Tel +61 3 8587 0444

Fax +61 3 8587 0499

info.australia@we-ef.com

WE-EF LIGHTING

United States of America

Tel +1 724 742 0030

Fax +1 724 742 0035

info.usa@we-ef.com

INSTALLER

HOTLINE

+61 458 933 399

7am – 7pm AEST

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere WE-EF Beleuchtungsausrüstung Handbücher

WE-EF

WE-EF VFL540-SE LED Bedienungsanleitung

WE-EF

WE-EF CFT500 LED Series Bedienungsanleitung

WE-EF

WE-EF GTY200 LED Series Bedienungsanleitung

WE-EF

WE-EF ESC330-FS LED Bedienungsanleitung

WE-EF

WE-EF LGI440 Bedienungsanleitung

WE-EF

WE-EF RFS500 Series Bedienungsanleitung

WE-EF

WE-EF RAIL66 Series Bedienungsanleitung

WE-EF

WE-EF VLR100 LED Series Bedienungsanleitung

WE-EF

WE-EF ETC329-FS LED Bedienungsanleitung

WE-EF

WE-EF FLC100 Series Bedienungsanleitung

WE-EF

WE-EF KTX234 Bedienungsanleitung

WE-EF

WE-EF DAC200 LED Series Bedienungsanleitung

WE-EF

WE-EF QSI254 Bedienungsanleitung

WE-EF

WE-EF FLC122LED Bedienungsanleitung

WE-EF

WE-EF LTM440 Bedienungsanleitung

WE-EF

WE-EF RMT320 LED Bedienungsanleitung

WE-EF

WE-EF LSP400 LED Series Bedienungsanleitung

WE-EF

WE-EF FLC121 Bedienungsanleitung

WE-EF

WE-EF DOC220 Bedienungsanleitung

WE-EF

WE-EF XRY300 LED Series Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung