We THYONE-I Bedienungsanleitung

USER MANUAL

THYONE-I USB RADIO STICK

2611036021001

VERSION 1.3

APRIL 20, 2023

***************

MUST READ

Check for ﬁrmware updates

Before using the product make sure you use the most recent ﬁrmware version, data sheet

and user manual. This is especially important for Wireless Connectivity products that were

not purchased directly from Würth Elektronik eiSos. A ﬁrmware update on these respective

products may be required.

We strongly recommend to include in the customer system design, the possibility for a ﬁrmware

update of the product.

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

Revision history

Manual

version

version Notes Date

1.0 1.1 • Initial version of the manual February 2020

1.1 1.1

• Updated Declaration of EU conformity to latest

Version of EN 300 328 after successfully

passing corresponding delta test in chapter

Regulatory compliance information

November 2020

1.2 1.1 • Updated Declaration of EU conformity in

chapter

Regulatory compliance information

.December 2020

1.3 1.1

• Updated document style

• Function description is part of the Thyone-I user

manual [2]

April 2023

Order code 2611036021001 1

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

Abbreviations

Abbreviation Name Description

API

Application

Programming

Interface

FSE Field Sales

Engineer

Support and sales contact person responsible for

limited sales area

COM Port Communication

Port

FCC

Federal

Communications

Commission

FTDI

Future Technology

Devices

International

USB-to-Serial converter chip

GPIO General Purpose

Input/Output

HIGH High signal level

LOW Low signal level

MCU Micro Controller

Unit

PC Personal

Computer

RED Radio Equipment

Directive

RF Radio frequency Describes everything relating to the wireless

transmission.

UART

Universal Asynchronous Receiver Transmitter allows

communicating with the module of a speciﬁc

interface.

USB Universal Serial

Bus

VCP Virtual COM Port

VDD Supply voltage

WE Würth Elektronik

Order code 2611036021001 2

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

Contents

1 Introduction 4

1.1 Orderinginformation................................. 4

2 Functional description 5

2.1 TypicalSetup ..................................... 5

2.2 Takingintooperation................................. 6

2.2.1 UsageofCBUSpins ............................ 7

2.2.1.1 Resetting the Thyone-I USB radio stick using the CBUS pin . . . . 7

2.2.1.2 Switching from command mode to transparent mode and vice versa 7

3 Regulatory compliance information 9

3.1 ImportantnoticeEU ................................. 9

3.2 ImportantnoticeFCC ................................ 9

3.3 EU Declaration of conformity . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

3.4 FCC - Federal Communications Commission . . . . . . . . . . . . . . . . . . . 11

3.5 IC-IndustryCanada................................. 11

4 References 12

5 Important notes 13

5.1 General customer responsibility . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

5.2 Customer responsibility related to speciﬁc, in particular safety-relevant appli-

cations......................................... 13

5.3 Bestcareandattention ............................... 13

5.4 Customer support for product speciﬁcations . . . . . . . . . . . . . . . . . . . . 13

5.5 Productimprovements................................ 14

5.6 Productlifecycle ................................... 14

5.7 Propertyrights .................................... 14

5.8 General terms and conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

6 Legal notice 15

6.1 Exclusionofliability.................................. 15

6.2 Suitability in customer applications . . . . . . . . . . . . . . . . . . . . . . . . . 15

6.3 Trademarks ...................................... 15

6.4 Usagerestriction ................................... 15

7 License terms 17

7.1 Limitedlicense .................................... 17

7.2 Usageandobligations ................................ 17

7.3 Ownership....................................... 18

7.4 Firmwareupdate(s).................................. 18

7.5 Disclaimerofwarranty ................................ 18

7.6 Limitationofliability.................................. 19

7.7 Applicable law and jurisdiction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

7.8 Severabilityclause .................................. 19

7.9 Miscellaneous..................................... 19

Order code 2611036021001 3

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

1 Introduction

The Thyone-I is a radio module that provides wireless connectivity capabilities in the 2.4 GHz

frequency band. The Thyone-I USB radio stick incorporates the Thyone-I in a USB stick form

factor enabling easy interfacing with any USB enabled device like personal computer or laptop.

The Thyone-I USB radio stick allows quick set-up of a radio link between PC and any system

with integrated Thyone-I radio module.

1.1 Ordering information

WE order code Description

2611036021001 Radio dongle including Thyone-I

Table 1: Ordering information

Order code 2611036021001 4

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

2 Functional description

The Thyone-I USB radio stick consists of Thyone-I radio module along with a serial-to-USB

adapter that enables direct connection to any USB compatible device. An FTDI serial-to-USB

converter chip FT231X connects the USB interface to the UART pins of the integrated radio

module. Besides UART, additional digital GPIO pins (CBUS) are connected to the radio module

to provide special functions like reset. Figure

illustrates all the functional components of

Thyone-I USB radio stick.

Figure 1: Block diagram of the Thyone-I USB radio stick

For detailed function description of the Thyone-I USB radio stick, please refer

to the user manual of the underlying radio module Thyone-I [2].

2.1 Typical Setup

The Thyone-I USB radio stick offers either a Command API (default) or a Transparent Mode on

it’s UART interface.

Two modules or USB dongles can communicate with each other if they share the same radio

conﬁguration (radio proﬁle and channel). Based on the network conﬁguration, data can be

broadcast, multicast to a group or unicast to a speciﬁc module. The default module settings

are selected in such a way that an plug and play experience is possible by using 2 dongles and

the PC tool smart commander [1].

Order code 2611036021001 5

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

2.2 Taking into operation

The serial-to-USB FTDI converter chip FT231X requires special drivers to be installed for

proper operation. The Virtual COM Port (VCP) drivers have to be installed by following the

"Installation Guides" found under: https://www.ftdichip.com/Drivers/VCP.htm

It is recommended to restart the PC after installation of drivers.

On proper installation of the drivers, the module appears as a virtual COM port on the PC

(ttyUSBx on Linux, COMx on Windows) in case of the VCP driver use. This COM port can be

opened in any serial emulator program or user written software to communicate with the radio

module.

The radio module responds to commands in a speciﬁc format. Please refer to the correspond-

ing Thyone-I user manual [2] for the complete description of the command set.

When connecting the USB radio stick to the PC, it is recommended to reset

the USB radio stick once. This can be done using the USB radio stick’s reset

button or using the CBUS0 pin (see chapter

2.2.1.1

). This reset procedure is

also recommended after each reboot of the PC.

Figure 2: Reset button on the Thyone-I USB radio stick

Order code 2611036021001 6

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

2.2.1 Usage of CBUS pins

To switch the CBUS pins static HIGH or LOW and thus to use the provided pins functions of

the Thyone-I radio module, the D2XX driver of FTDI has to be used. This driver is part of the

previous mentioned VCP driver installation in case of Windows OS. In case of Linux a manual

installation is required.

Please follow FTDI’s "Installation Guides" for proper D2XX install:

https://www.ftdichip.com/Drivers/D2XX.htm

Examples codes and tutorials for ¨how to use the D2XX driver within your own software tool¨

can be found in the software example section of:

https://www.ftdichip.com/Support/SoftwareExamples/CodeExamples.htm

2.2.1.1 Resetting the Thyone-I USB radio stick using the CBUS pin

The /RESET pin of the Thyone-I can be used to reset the integrated radio module. As the

/RESET pin is connected to the CBUS0 pin of the integrated FTDI chip, the radio module can

be reset by pulling the CBUS0 pin low for at least 100 ms and releasing it to high level again.

By default, the CBUS0 pin of the FT231X is conﬁgured as

FT_CBUS_GPIO

(bit bang), such that

the FTDI D2XX driver function

SetBitMode

can be used.

/*prep: create and connect an FTDI device intance */

/*set CBUS0 to output level LOW */

SetBitMode(0x10, FTDI.FT_BIT_MODES.FT_BIT_MODE_CBUS_BITBANG);

/*hold CBUS0 for at least 100ms on LOW level */

wait_ms(100);

/*clear FTDI receive and send buffers */

Purge(FTDI.FT_PURGE.FT_PURGE_RX | FTDI.FT_PURGE.FT_PURGE_TX);

/*set CBUS0 to output level HIGH */

SetBitMode(0x00, FTDI.FT_BIT_MODES.FT_BIT_MODE_RESET);

/*a delay according to the reset timing parameter will occur (see manual) */

/*disconnect and close the FTDI device instance */

Code 1: Pin reset via CBUS0 using the D2XX driver

2.2.1.2 Switching from command mode to transparent mode and vice versa

The operation mode of the Thyone-I USB radio stick can be deﬁned by applying the right voltage

level at the OP_MODE pin of the Thyone-I during its start-up phase. As this pin is connected

to the CBUS3 pin of the built-in FTDI converter chip, the CBUS3 pin can be controlled by the

host.

Order code 2611036021001 7

Version 1.3, April 2023 www.we-online.com/wcs

WIRELESS CONNECTIVITY & SENSORS

User manual Thyone-I USB radio stick

Additional care has to be taken when conﬁguring the pins on the FTDI con-

verter. The EEPROM content of the chip is changed by this action. Any miscon-

ﬁguration may prevent the normal operation of the USB dongle. This method

is not intended for periodic use. The factory defaults of the CBUS pins are:

CBUS0 to CBUS2 - GPIO, CBUS3 - CBUS_Drive_0

By default, the CBUS3 pin of the FT231X is conﬁgured as

FT_CBUS_Drive_0

(static LOW) such

that the Thyone-I USB radio stick starts in command mode. To start the USB radio stick in

transparent mode, conﬁgure the CBUS3 pin as

FT_CBUS_Drive_1

(static HIGH) and perform a

reset of the device, as speciﬁed in chapter

2.2.1.1

In case the USB radio stick shall start in command mode again, conﬁgure the CBUS3 pin

FT_CBUS_Drive_0

(static LOW) and perform a reset of the device, as speciﬁed in chap-

ter

2.2.1.1

Order code 2611036021001 8

Version 1.3, April 2023 www.we-online.com/wcs

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere We Modem Handbücher

We MF79U Bedienungsanleitung

Beliebte Modem Handbücher anderer Marken

Davicom

Davicom DM562AP Bedienungsanleitung

EpiValley

EpiValley TATA indicom SXC-1080 Bedienungsanleitung

Zte

Zte WiMAX Bedienungsanleitung

Intelimax

Intelimax MA-2060 Bedienungsanleitung

SMC Networks

SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch

Telstra

Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Bedienungsanleitung

Samsung

Samsung AceLink SAM-335A Bedienungsanleitung

Enfora

Enfora Enabler-G Kurzanleitung zur Einrichtung

iRZ

iRZ ATM2-232 Bedienungsanleitung

Zhone

Zhone 6310 Bedienungsanleitung

Paradyne

Paradyne Hotwire 7976 Bedienungsanleitung

US Robotics

US Robotics 3453C Bedienungsanleitung

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung

Zte

Zte MF823 Bedienungsanleitung

Four-Faith

Four-Faith F1403 Bedienungsanleitung

Sierra Wireless

Sierra Wireless AIRLINK MP595W Bedienungsanleitung

Gemtek

Gemtek WiMAX WIXFBR-103 Bedienungsanleitung