weasy KFX32 Bedienungsanleitung
Instruction Manual
Manuel d’instructions
Bedienungsanleitung
Gebruiksaanwijzing
Manual de instrucciones
Manuale d’uso
KFX32
Espresso maker
Machine à expresso
Espressomaschine
Espressomachine
Máquina de café espresso
Macchina per caffè espresso
ENGLISH
IMPORTANT SAFEGUARDS
Before using the electrical appliance, the following basic
precautions should always be followed including the
following:
1. Before using checks that the voltage of wall outlet
corresponds to coffee maker rating plate.
2. The appliance must be earthed.
3. Close supervision is necessary when your
appliance is being used near children.
4. Do not place the coffee maker on hot surface or
beside fire, avoid to be damaged.
5. Remove plug from wall outlet before cleaning and
when not in use. Allow appliance to cool down
completely before taking off, attaching components or
before cleaning.
6. Do not operate any appliance with a damaged cord
or plug or after the appliance malfunctions, or is dropped
or damaged in any manner. Return appliance to the
nearest authorized service facility for examination, repair
or electrical or mechanical adjustment.
7. The use of accessory which is not recommended
by manufacturer may cause injury to persons or damage
to appliance.
8. Place appliance on flat surface or table, do not
hang its power cord over the edge of table or counter.
9. Ensure that the power cord does not touch hot
surface of appliance.
10. Some parts of appliance are hot when operated, so
do not touch with hand directly.
11. Do not immerse appliance or power cord into water
or any other liquids.
12. Do not use outdoors.
13. Save these instructions booklet for future reference.
14. This appliance may be used by children of at least 8
years of age, as long as they are supervised and have
been given instructions about using the appliance safely
and are fully aware of the dangers involved.
15. Cleaning and maintenance should not be carried
out by children unless they are at least 8 years of age and
are supervised by an adult.
16. Keep the appliance and its power cord out of reach
of children under 8 years of age.
17. When using electrical equipment, safety
precautions must always be taken to prevent the risk of
fire, electric shock and/or injury in the event of misuse.
18. Make sure that the voltage rating on the typeplate
corresponds to your main voltage of your installation. If
this is not the case, contact the dealer and do not
connect the unit.
19. Never leave the unit unattended while in operation.
20. The device must not be used if it has been dropped,
it obvious signs of damage are visible or if it has leaks.
21. Please keep this document at hand and give it to
the future owner in case of transfer of your device.
22. Do not operate this appliance if it has a damaged
cord or plug, if it is not working properly or if it has been
damaged or dropped. If the supply cord is damaged, it
must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a
hazard.
23. This device is not intended for use by persons with
reduced capacity on the physical, mental or sensory or
lack of experience and knowledge (including children),
unless he has them was asked to monitor or if they have
had instructions on the use of the appliance by a person
responsible for their safety. Children should be
supervised to ensure they do not play with the device.
24. Do not use outside
25. The device is not intended to be operated by
external timer means or a remote control system.
26. Before cleaning the machine, make sure the
machine is unplugged.
27. The machine is only used for household and indoor
HOUSEHOLD USE ONLY
PARTS AND INSTALLATION DRAWINGS
1. button for one cup 2. Button for two cups 3. On/off button
4. Manual control button 5. steam on/off 6. Cup plate 7. drip tray
8. tank cover 9. tank 10. steam knob 11. main body
12. steam pipe component 13. steam jacket 14. spoon
15.Funnel handle 16. hook(buckle when pour wasted coffee powder residue)
17.funnel 18. Filter for 2 cups
Preparation for first use / cold machine state
1. pour water into the water tank, and the water level should not exceed the "Max" mark in the
water tank.
2. plug in the power supply, and then press the ‘on/off button’, the upper indicator light turns
blue flicker at this time.Then you press the ‘manual control button’ and the water pump will start
to work,it will pump the water from water tank into the machine for heating.
3. The machine starts to warm up. At this time, the coffee switch indicator lights will fliker. To
wait untill the light turns to continuous illuminates from fliker,the pre-heat is finished, it will take
about 2 minutes.
4. Then press "one cup button",the machine will flow hot waters out,you can use the water to
wash the filter or cups.
start to make coffee
1. Place the filter into the funnel.
2. When the machine is preheating, you can fill the coffee powder into the filter and then flat and
tight the powder by the tail of spoon at the mean time. (the coffee powder can not be too coarse
or too thin)You can also clean the edge of filter with a brush or your hand
3. Insert and lock the funnel as indicated,then place the coffee cup under the funne
4. Press the ‘one cup button’,the machine begins to flow out one cup of coffee (or press ‘2 cups
button’, ,the machine begins to flow out two cups of coffee . or press ‘manual control
button’,then the machine begins to flow out the coffee,when it reach to the capacity which you
want,press the ‘manual control button’ again,the machine will stop flowing out the coffee.)
Steam and frothing function
1. Press the ‘steam on/off button’, the upper indicator light turns red flicker.To wait untill the light
turns to continuous illuminates from fliker,the pre-heat is finish.
2. Pour the ‘whole milk’ into the 1/3 of the frothing cup and insert the steam nozzle into 1CM
from surface,then turn the steam knob slowly until steam starts to blow out.
(Note: the degree of steam can be adjusted according to the proficiency of the individual. We
suggest to release a little bit moisture before you froth the milk.)
3. When the temperature of milk reaches to about 75 degrees(and the milk bubble begins to
expand), you can stop the steam by turnning the steam knob to "OFF" position and press the
‘steam button’. The indicator light will turn to blue color.(Or you can also press ‘on/off button’ to
turn off the machine)
Remark: after you frothed the milk,to clean the milk on the surface of the steam nozzle with a
damp cloth duly,and then spray steam to prevent the hole inside the nozzel will be blocked after
the milk was dried.
Hot water function
1. Press the ‘on/off button’, the upper indicator light turns to flicker with blue color,it means the
machine is pre-heating.To wait untill the light turns to continuous illuminates from fliker,the
pre-heat is finish.Turn the knob to ‘on’ position untill there’s water is flow out from the steam
nozzle.The water can use for drinking,cleaning or warming the cups.
2.After that ,you can turn the knob to ‘off’ position,then press’on/off button’again to turn off the
machine.
CLEAN AND MAINTENANCE:
1. Cut off power source and let the coffee maker cool
down completely before cleaning.
2. Clean housing of coffee maker with moisture-proof
sponge often and clean water tank, drip tray and
removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser.
Never immerse the housing in water for cleaning.
3. Detach the metal funnel through turn it
anticlockwise, get rid of coffee residue inside, then you
can clean it with cleanser, but at last you must rinse with
clear water.
4. Clean all the attachments in the water and dry
thoroughly.
CLEANING MINERAL DEPOSITS
1. To make sure your coffee maker operating efficiently,
internal piping is cleanly and the peak flavor of coffee,
you should clean away the mineral deposits left every 2-3
months.
2. Fill the tank with water and descaler to the MAX level (the
scale of water and descaler is 4:1; the detail refers to the
instruction of descaler. Please use “household descaler”,
you can use the citric acid (obtainable from chemist’s or
drug stores) instead of the descaler (the one hundred
parts of water and three parts of citric acid).
3. According to the program of pre-heating, put the metal
funnel (no coffee powder in it) and carafe (jug) in place.
Brewing water per “PRE-HEATING”.
4. Press the ‘on/off button’, the upper indicator light turns to
flicker with blue color,it means the machine is
pre-heating.To wait untill the light turns to continuous
illuminates from fliker,the pre-heat is finish.Turn the knob
to ‘on’ position untill there’s water is flow out from the
steam nozzle.
5. press the ‘on/off button’, the upper indicator light turns
blue flicker at this time.Then you press the ‘manual
control button’ and the water pump will start to work,it
will pump the water from water tank into the machine for
heating.
6. The machine starts to warm up. At this time, the coffee
switch indicator lights will fliker. To wait untill the light
turns to continuous illuminates from fliker,the pre-heat is
finished, it will take about 2 minutes
7. .Then press "one cup button",the machine will flow hot
waters out,you can use the water to wash the filter or
cups.
Inhaltsverzeichnis
Sprachen:
Andere weasy Kaffeemaschine Handbücher
