ACTIVATING THE ALARM
1. Once the alarm time is set, press “AL1/VOL-” button (7) once for alarm with buzzer (Indicator A will be
on) and twice for alarm with radio (Indicator B will be on).
2. Digits will stop flashing after a short while.
3. Press “AL1/VOL-” button (7) until all indicators off to turn off alarm.
WHEN THE ALARM SOUNDS
1. When the alarm sounds, press “ AL.OFF” button (1) to turn off alarm or press “SNOOZE NAP/SLEEP”
button (2) for snooze.
2. Once in snooze, alarm will sound again after 9 minutes.
DISPLAY BRIGHTNESS
When the radio is off and the current time showing, press “DIMMER” button (4) to change the brightness
of the display between high and low.
(Note: Do not change the display brightness while setting the clock radio and when the alarm is on.)
TIME PROJECTION
Press “PROJECTION ON/OFF” button (9) to turn time projection on and off. It is most visible on a flat white
surface. Press “180FLIP” button (6) to rotate time projection by 180. Tilt and adjust “time projection /
focus dial” (12) as needed.
RADIO OPERATIONS
General Operations
1. Press “AL.OFF” button (1) to turn radio on and off. The radio station frequency will appear on the
display.
2. Press “HOUR/TUN-” button (8) or “MIN/TUN+” button (11) to change radio frequency. Or, press and
hold down “HOUR/TUN-” button (8) or “MIN/TUN+” button (11)for approximately 3 seconds to auto
scan for the next available station.
3. Press “AL1/VOL-” button (7) or “AL2/VOL+” button (10) to adjust volume level.
4. Radio will show the time in a few seconds after changing frequency. Press “HOUR/TUN-” button (8) or
“MIN/TUN+” button (11) to view radio frequency.
Pre-set Station Memory
1. The radio can store up to 10 FM stations.
1. To store a station in memory, tune to the desired radio station. Press and hold down “PRESET” button
(5) and a number starting with “P” on the display will flash. This “P” number represent one of the ten
memory stations. Press “HOUR/TUN-” button (8) or “MIN/TUN+” button (11) to change the station
number. Press “PRESET” button (5) to confirm.
2. To recall a pre-set station, turn the radio on. Press “PRESET” button (5) repeatedly until station number
is found. The station frequency will be display momentarily.
