WESTERSTRAND T/T Bedienungsanleitung

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

Manual

Westerstrand T/T- display

With chronometer function

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

ENERAL

...................................................................................................................................................................... 3

NSTALLATION

............................................................................................................................................................... 4

ONNECTION

................................................................................................................................................................. 5

ONNECTION SYNCHRONISATION

................................................................................................................................... 5

TRAPPING

MIN-

IMPULSE COMPUTER BOARD

(

DEFAULT

) ........................................................................................ 6

TRAPPING

DCF-

RADIO

–

IRE

)

COMPUTER BOARD

..................................................................................................... 6

TRAPPING

DCF-

RADIO

–

IRE

)

COMPUTER BOARD

.................................................................................................... 7

YNCHRONISATION

........................................................................................................................................................ 8

ONNECTION TEMPERATURE SENSOR

(

OPTION

). .............................................................................................................. 9

ROGRAMMING

............................................................................................................................................................. 9

Manual programming time ...................................................................................................................................... 10

Setting light intensity............................................................................................................................................... 11

Setting synchronisation ........................................................................................................................................... 12

MPULSE SYNCHRONISATION

. ....................................................................................................................................... 12

Setting alternating time, Loop time .......................................................................................................................... 12

Setting Correction value, for the temperature sensors. ............................................................................................. 13

Setting DLS-function. .............................................................................................................................................. 13

Setting12 24 h format. ............................................................................................................................................. 14

UNCTION AS CHRONOMETER

. ...................................................................................................................................... 14

ROGRAMMING OF THE CHRONOMETER

........................................................................................................................ 15

YNAMIC

TATIC FORMAT

.......................................................................................................................................... 16

ECHNICAL SPECIFICATION

.......................................................................................................................................... 17

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

General

esterstrand time- and temperature displays, alternates time and temperature in 1-25 seconds

intervals.

This device is for use alternatively as digital clock or as chronometer.

7-segments LED digits in dimensions 150, 190, 250, 300 and 450 mm.

The time and temperature display could be single or double sided with or without second.

Example for time display:

4 digits

6 digits

Example for date display:

4 digits

6 digits

Example for temperature display:

4 digits

6 digits

4 digits

6 digits

:59:

:59

17.06.

17.06

ºC

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

The Temperature sensor is not included. It is an option.

The programming of the time and temperature display is made by buttons at the computer board or via

remote control.

The digital clock can operate stand alone with a built in quartz crystal as time reference, as a slave

clock to a master clock transmitting 24 V polarised 1/1 minute impulses or synchronised by TC, DCF.

If the DLS-function is set , the clock is changing, summer and winter time, the last Sunday in March

and the last Sunday in October automatically.

The clock has adjustable light intensity.

If power failure occurs the display is turned off. The internal clock continues to keep the correct time

for 48 hours. After power failure the display is turned on and correct time is shown.

Installation{TC \l1 "Installation}

 Mount the clock by means of the mounting brackets. Both wall and roof mounting is possible by

rotating the brackets.

 To open the clock, slide the front glass by loosening the aluminium profile on the short side of the

clock. Unscrew 2 screws and open the service plate.

 Connect the synchronisation source if present (radio, impulse etc). See the connection diagrams,

page 5.

See also the configuration instructions for setting of synchronisation (page. 6 and 8.)

 Connect the mains, 230VAC 50Hz . Installation fuse max 10A.

The socket outlet shall be installed near the clock and shall be easily accessible.

hen the clock is installed permanently, a readily accessible disconnect device (2-polar, 3 mm

contact gap) shall be incorporated in the fixed wiring.

 Set correct time and date according to the programming instructions on page 10.

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

Connection

Connection s nchronisation

TC and MIN-imp is connected at +IMP and –IMP.

V+

-IMP+IMP

DCF -

DCF 2-wire is connected V+ and – (GND)

GND

T/T LED

-IMP

DCF

+IMP

V+ -DCF

DCF RECEIVER

DCF 3-wire is connected DCF , V+ and – (GND)

DCF

T/T LED

V+

-IMP+IMP

DCF -GND +

DCF RECEIVER

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

Strapping TC / MIN-impulse computer board (default)

Strapping DCF- radio(2 –wire) computer board

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

Strapping DCF-radio (3 –wire) computer board

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

S nchronisation

Stand alone

If no synchronisation the T/T works as stand alone.

Minute impulse

Set the straps according to the strapping schema page 6.

Connect the wires, see page 5.

The T/T could be set for synchronisation or slave mode.

Synchronisation mode:

Set the T/T in synchronisation mode InSy, see programming page 10.

Set time and wait for next minute impulse. It is now synchronised.

Slave mode:

Set the T/T in slave mode InSL, see programming page 10.

Set time and wait for next minute impulse. It is now working in slave mode.

Set the straps according to the strapping schema page 6.

Connect the TC wires, see page 5.

Set the T/T in synchronisation mode sync. Functions DCF see programming page 10.

After one correct accepted time message the time is displayed and the colon starts flashing on and off.

DCF

Set the straps according to the strapping schema page 6 and 7.

Connect the DCF wires, see page 5.

Set the T/T in synchronisation mode sync. Functions DCF see programming page 10.

After one correct accepted time message the time is displayed and the colon starts flashing on and off.

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

Connection temperature sensor (option).

Temperature sensor connection

1 red.

2 black

3 Screen

1 2 3

TEMP.SENSOR

Programming

Programming is made via a remote control or push buttons at the computer board.

Doc

ument:

1846

.doc

Auth

TAn

Date

201

Page

av 1

WESTERSTRAND URFABRIK AB

Box 133 Te . 0506 48 000 Internet:: www.westerstrand.se

545 23 TÖREBODA Fax. 0506 48 051 E-mai : inf[email protected]

Remote control:

R (Return) Enter the base mode (display time)

F (Function) Next function / Accept displayed value

P (Program) Enter the displayed function / Increase displayed value.

Manual programming time

Push [F] until display shows

Push [P] display shows year.

Push [P] until desired year (00-99)

Accept with [F].

Display shows month.

Push [P] until desired month (1-12).

Accept with [F].

Display shows day.

Push [P] until desired date (1-31).

Accept with [F].

Display shows weekday.

Push [P] until desired weekday (1-7). 1 = Monday.

Accept with [F].

Display shows hour.

ti ne

yy 95

nn 1

d d 1

dA 1

hh 12

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere WESTERSTRAND Monitor Handbücher

WESTERSTRAND

WESTERSTRAND 190100 Series Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung