7
Pre-set using the “Adjustable thermostat (T) and programmer” (P) knob.
Warning!
Do not rotate the programmer knob (P) in an anticlockwise direction.
Press the no-spin pushbutton if required (Fig.16). When this pushbutton is pressed,
the machine completes the wash cycle without spinning. This option is useful for the
wash-n-wear clothing.
If the washing weighs 1/2kg or less, press the half-load pushbutton (Fig.17).
Light soiled materials option. Press the water saving pushbutton if required
(Fig.18) and the machine will complete automatically with one less rinse in the
process to save water.
Max. temperature option. Press the energy saving pushbutton if required (Fig.19 )
and the Max. temperature will be limited to 60℃to save energy.
To start the machine, pull the program knob (P) if required (Fig.21), or if the machine
has pushbutton, press the start pushbutton (Fig.20): the luminous indicator will light
up.
If the required program position is accidentally passed, interrupt the program by
pressing the programmer knob (P) (Fig.21), or , if fitted, press the start pushbutton
to turn the machine off (Fig.20). Rotate the programmer (P) in a clockwise direction
until the required position is reached. Pull the programmer knob out again (P)
(Fig.21) or, if fitted, press the start pushbutton (Fig.20).
It is always possible, though not advisable, to add clothes which have been leftover
during the main washing cycle.
To do this, proceed as follows:
Always check, by looking through the transparent door, that there is no water
in the drum, otherwise rotate programmer knob (P) to the discharge position.
If there is no water in the drum, press programmer knob (P) (Fig.21), or press and
release the stop pushbutton if fitted (fig.20).
Wait approximately 3minutes (Fig.22) to allow the safety devices to de-activate.
Open the door (Fig.12); add the leftover clothing and re-close the door.
If required, add low lather detergent. To start the machine, pull programmer knob (P)
(Fig.21), or if the machine has pushbuttons, press the start pushbutton (Fig.20).
The indicator light will be illuminated (Fig.23).
At the end of the washing program, the machine will stop at one of the STOP
positions on the programmer (P).
Press the programmer knob (P)(Fig.21), or press and release the stop pushbutton
if fitted (Fig.20).
Wait three (3) minutes for the door to unlock (Fig.22).
Remove the washing.
With dry hands, disconnect the machine from the mains supply (Fig.11).
Turn off the water tap (Fig.24).
Fig.16
Fig.17
Fig.18
Fig.19
Fig.20
Fig.22Fig.21
Fig.23 Fig.24
