11.
Loosen the screws In the top retarnrng brackets.
Rotate the brackets from shipprng posrtron to the
Install posrtron. Fietrghten See Figure 72
/ RETAINING
BRACKETS
FIGURE12
NOTE: Position **A’*-Compactor frame willbe flush with
cabinets. Remove cabinet mount screws from retaining
brackets. Save for use in step 13.
Position “B”-Midpoint between posit/on ‘A” and “C. ”
Position “C’,-Drawer front will be flush with cabinets
12. When moving or lifting the compactor, use a glove to
protect and cushion your hand.
To prevent damage to floor coverrng, do not allow the
rear frame of the compactor to touch the floor when
lrftrng or rollrng (See Figure 13)
FIGURE 13
Align the rear of the compactor wrth the cabrnet
opening Plug the power cord Into a properly grounded
receptacle. See figures 1, 2 and 9.
Lift the front of the compactor and roll Into the
opening untrl the retarnrng brackets stop the unrt
13. Fasten the retaining brackets to the undersrde of the
counter top wrth the screws provrded Use auxrlrary
clip for fastenrng to cabinet front when counter top
mounting method IS not permrsstble. See Figure 14.
RETAINERBRACKET
\ RETAINERBRACKET
/
MOUNTING CLIP
MOUNTING SCREW
COUNTER TOP MOUNTING AL TERNATE CABINET FRONT
FIGURE14
MOUNTING
Lift the front of the compactor until It IS parallel with
the cabinet front Place a screwdriver or other wedge
under the front edge of the compactor
14. Loosen the screws to the front levelers (do not remove
screws). Pivot the levelers to the floor and retrghten
screws. See Figure 15.
FIGURE15
15.
Replace the drawer
16.
The Use and Care Gurde, located behrnd the handle of
the drawer, provides complete details for operation
and care of your compactor.
ADJUSTABLE TOE PLATE
In some rnstallatrons, the toe plate may rub the floor
covering If thus occurs, the toe plate clearance may be
changed as follows:
1.
Determine the amount of Interference of the toe plate
wrth the floor coverrng
2. Remove the drawer from the unit (Refer to Step 3 of
the Installation Instructrons.)
3. Lay drawer so the front panel faces upward. Protect
the floor
4. With a ruler and a pencil or chalk, draw a line where
the toe plate Interferes with the floor covering.
5. Use a pair of sctssors and cut toe plate along this Irne.
See Figure 16.
6.
Replace drawer In unit
FIGURE 16
CHANGING FRONT PANEL COLOR
During installation, or in the future, you may wish to
change the front panel color. Your compactor has three
reversible front panels which offer six color options:
Harvest Gold, Black, Almond, White, Platinum and Toast.
See details of panel assembly in Figure 77.
PANEL
PANEL
FIGURE 17
3 780291 Rev. A
![Whirlpool [12:36:03] ?????????????????: GC900QPPB Bedienungsanleitung](/data/manuals/27/6/276dh/sources/whirlpool-12-36-03-gc900qppb-trash-compactor-manual.jpg "Whirlpool [12:36:03] ?????????????????: GC900QPPB Bedienungsanleitung")
