Page 315997-0-0903
Proper Log Placement
Log placement is critical to proper burner performance. Logs
must be correctly positioned onto the burner. The photos in this
manual show the proper pinned position for logs on this set.
Ownersneedtobeshownproperlogplacementandinstructednot
to move the logs.
Logsmustfit firmlyontotheburner when positionedasshown in
thephotos. Misformed logsorlogs withsloppypin holesmustbe
replaced.
Proper Placement of Rock Wool and Decorative Lava Rock
Rock wool can be added to burners for a glowing ember effect. It
must be positioned only on the front portion of the burner. The
photos in this manual show the proper placement of rock wool.
Decorativelavarockorsmallwoodpiecesshouldneverbeplaced
on the burner. These items are only for placement on the floor of
the fireplace or firebox.
Proper Primary Airflow into Burner
For proper burner operation and flame appearance, the flow of
primaryairintotheventuritube,locatedonthe rear of theburner,
mustnotbereduced.Thisflowofairisreducedifdirt,lintorother
obstructionsbuild-uparoundorinsidetheventuri.Anyobstruction
in the venturi tube area must be removed. The flow of air into the
venturi is also reduced if the gas orifice isn’t centered in the
venturi inlet and/or is not aligned with the venturi. Any
misalignment of the burner orifice may be corrected by bending
the shutter cap holding the orifice to the inlet of the venturi tube.
Ceiling Fans, Portable Fans or Logs Installed Near Cold Air
Returns
Ceiling fans or oscillating floor type fans need to be monitored
duringtheoperationofvent-freelogs.Iftheairblowsdirectlyinto
theflamecausingittoimpingeonthe log set, orfirebox,itshould
be turned off or redirected. Ceiling fans could be reversed to
possiblyeliminateflameimpingement,andthefloorfancouldbe
redirected. Upon installation, be aware of any cold air returns or
vents in the proximity of the log set. Any draft created around a
vent-free log set can cause the flame to impinge on the log and
create a sooting situation.
IMPORTANT INSTALLATION GUIDELINES
WARNING:Donotallowfanstoblowdirectlyintothefireplace.
Avoid any drafts that alter burner flame patterns.
WARNING:Donotuseablowerinsert,heatexchangerinsertor
other accessory not approved for use with this heater.
Candles
Avoid the use of scented or decorative candles while the log set
is in operation. Candles produce a residue in the air that creates
a soot like substance. Burning candles while the log set is
operating magnifies the problem. It should be noted that candles,
in general, produce soot. The amount of time burned and the
quantity of candles burned will determine the amount of soot
produced and deposited.
Make Owners Aware of Proper Log Set Operation
Properlyinstalledandproperlymaintainedlogsetsdonotdeposit
soot on the logs. If users see soot appear on a log, call for service.
Do not continue to operate the log set.
Sunken Fireplace
If installing this unit into a sunken fireplace, you must raise the
floor to insure adequate airflow and guard against sooting. Raise
fireplacefloorusinganon-combustiblematerial,whichissecure.
Glass Doors
Make sure that glass doors are open during all operations of the
logset. The opening of the glass door frame should be the
dimension used for the minimum front opening of the firebox.
Woodburning Fireplaces
Theinteriorofthefireboxandthechimneyshouldbecleanedand
free of all creosote before installing a gas burning log set.
Creosote will soften when heated and can drop on the logset
causing odors and possibly sooting.
WARNING: Before installing in a solid-fuel burning fireplace,
the chimney flue and firebox must be cleaned of soot, creosote,
ashes and loose paint by a qualified chimney cleaner.
Qualified Installing Agency
Installation and replacement of gas piping, gas utilization equip-
mentoraccessoriesandrepairandservicingofequipmentshallbe
performedonlybyaqualifiedagency.Theterm"qualifiedagency"
meansanyindividual,firm,corporation,orcompanythateitherin
personorthrougharepresentativeisengagedinandisresponsible
for (a) the installation, testing, or replacement of gas piping or (b)
the connection, installation, testing, repair, or servicing of equip-
ment; that is experienced in such work; that is familiar with all
precautions required, and that has complied with all the require-
ments of the authority having jurisdiction.
The installation must conform with local codes or, in the absence
of local codes, with the National Fuel Gas Code, ANSI Z223.1/
NFPA54.*
*Available from the American National Standards Institute, Inc. 11 West 42nd
St., New York, N.Y. 10018.
State of Massachusetts: The installation must be made by a
licensed plumber or gas fitter in the Commonwealth of Mas-
sachusetts.
In the Commonwealth of Massachusetts vent free products are
not approved.
State of Massachusetts requirement for installation of vented
decorative appliance in a vented fireplace is the following:
A vented decorative gas appliance must be installed in a vented
fireplace only in the state of Massachusetts. The vent damper
must be removed or welded permanently open.
GENERAL INFORMATION
