Wideye FX 500 Bedienungsanleitung
REGULATORY INFORMATION 1
INDUSTRY CANADA STATEMENT: 2
SAFETY INSTRUCTIONS 3
IMPORTANT INFORMATION TO INSTALLERS AND USERS 5
1 INTRODUCTION 6
2 OVERVIEW OF THE FLEETBROADBAND SYSTEM 8
3 MAIN UNITS 9
4 GETTING STARTED 14
5 USING THE PRIMARY HANDSET 19
6 USING THE WEB CONSOLE 55
7 TROUBLESHOOTING 114
LIST OF CONTENT:
FX 250 / FX 500 User Manual
1FX 250 / FX 500 User Manual
FEDERAL COMMUNICATION COMMISSION NOTICE
FCC Idener: QY9-AVCFX500BDE / QY9-AVCFX250BDE
USE CONDITIONS:
This device complies with part 15 of the FCC Rules. Operaon is subject to the following
two Condions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operaon.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protecon against harmful interference in a residenal installaon. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular installaon.
If this equipment does cause harmful interference to radio or television recepon, which
can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE: EXPOSURE TO RADIO FREQUENCY RADIATION
This Device complies with FCC & IC radiaon exposure limits set forth for an uncontrolled
environment. The Antenna used for this transmier must be installed to provide a separaon
distance of at least 100cm from all persons and must not be co-located or operang in
conjuncon with any other antenna or transmier.
FCC CAUTION:
Any Changes or modicaons not expressly approved by the manufacturer could void the
user’s authority, which is granted by FCC, to operate this satellite FleetBroadband System
Skipper FX 500 / 250 System.
REGULATORY INFORMATION
FX 250 / FX 500 User Manual
2
INDUSTRY CANADA STATEMENT:
IC: 5023A-AVCFX500BDE / IC: 5023A-AVCFX250BDE
This device complies with Radio standard specicaon RSS -170 and RSS-210 of Industry
Canada Rules. Operaon is subject to the following two condions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operaon.
IMPORTANT NOTE: Radiaon Exposure Statement
This equipment complies with IC radiaon exposure limits set forth for an uncontrolled
environment. This antenna used for this transmier must be installed to provide a separaon
distance of at least 100cm from all persons and must not be co-located or operang in
conjuncon with any other antenna or transmier.
EC Declaraon of Conformity:
Addvalue Communicaons Pte Ltd, 28 Tai Seng Street, #06-02, Singapore 534106 declares
under our sole responsibility that the accessory Product, brand name as Wideye and models:
Skipper FX 500 FleetBroadband satellite communicaon system, to which this declaraon
relates, is in conformity with the following standards and/or other normave documents:
ETSI EN 301 444, ETSI EN 301 489-1, -17,-19 & -20, ETSI EN 300 328 IEC 60945 / EN 60945,
IEC 60950-1 AND EN 60950-1, ITU-R M.1480
We hereby declare that all essenal radio test suite have been carried out and that the above
named product is in conformity to all the essenal requirements of Direcve 1999/5/EC.
The Conformity Assessment procedure referred to Arcle 10 and detailed in Annex [III] or
[IV] of Direcve 1999/5/EC has been followed with involvement of the following noed
body (ies):
TIMCO ENGINEERING Inc., P.O BOX 370, NEWBERRY, FLORIDA 32669.
Idencaon mark: 1177 (Noed Body number)
The technical documentaon relevant to the above equipments are held at:
• Addvalue Communicaons Pte Ltd, 28 Tai Seng Street #06-02, Singapore 534106.
• Signed by Mr. Tan Khai Pang (Chief Technology Ocer, 17 September, 2012) and
Mr. Prabakar Kuaniseeri (Manager-Quality Engineering, 17 September, 2012).
3FX 250 / FX 500 User Manual
SAFETY INSTRUCTIONS
For the sake of safety and protecon, read the manual before aempng to use the
Inmarsat FleetBroadband Terminal.
The following general safety precauons must be observed during all phases of operaon,
service and repair of this equipment. Failure to comply with these precauons or with
specic warnings elsewhere in this user guide violates safety standards of intended use of
the system.
Addvalue Communicaon Pte Ltd assumes no liability for the customer’s failure to comply
with these requirements.
Hazard Symbols
Avoid touching those areas of the terminal that
are being marked with this symbol otherwise it
may result in injury.
Antenna Radiaon Warning
and Distance to other Radiaon
Equipment
During transmission the antenna in the system
radiates high power levels of radio frequency.
This radiaon is considered health hazardous to
any personnel that come close to the antenna.
It is important to maintain a separaon distance
from the transming antenna to any personnel
of at least 2-meters.
Power Supply
Turn o the power at the mains switchboard
before beginning of the installaon.
Conrm the power voltage is compable with
voltage rang of the equipment. It is highly
recommended to use +24V DC power line, if it is
available on the vessel.
If there is no +24V DC power line provided by the
vessel, an external AC/DC power supply with an
input of 115/230V AC and an output of +24V DC
can be used.
Note: Be certain that the AC/DC power supply is
adequate to handle a high surge current of 25A
at 24V DC for 1ms.
FX 250 / FX 500 User Manual
4
Equipment Venlaon
To ensure adequate cooling of the transceiver, 5-cenmeter of unobstructed space must be
maintained around all sides of the unit except the boom side. The ambient temperature
range of the transceiver is: -25°C to +55°C.
Fire Precauons
The equipment must not be operated in the presence of ammable gases or fumes as well
as any explosive atmosphere. Operaon of any electrical equipment in such an environment
constutes a denite safety hazard.
Obtaining Licensing For Inmarsat Transceivers
Under rights given under ITU Radio Regulaons, local telecommunicaons administraons
establish and enforce naonal rules and regulaons governing types of emissions, power
levels, and other parameters that aect the purity of signal, which may be radiated in the
various frequency bands of the radio spectrum.
To legally operate Inmarsat equipment, it is necessary to obtain permission from the
local telecommunicaons regulatory authories of the country you are operang from.
Using your equipment in any country without permission causes you to run the risk of
conscaon of the equipment by the local authories. The normal procedure to bring such
equipment into another country is to apply for a license before travel. If a license has not
been obtained before travel, the equipment may be put in to storage by local authories
unl such me license is obtained.
Grounding, cables and
connecons
Service
The chassis of the equipment must be
connected to an electrical ground. This
will minimise electric shock and mutual
interference. In short, the terminal must be
grounded to the vessel.
Do not aempt to access to the interior of the
terminal. Only qualied personnel authorized by
its manufacturer may perform service. Failure to
comply with this rule will result in the warranty
void.
Under certain condions, dangerous voltages
may exist even with the power cable removed. To
avoid injuries, always disconnect power before
accessing the terminal.
5FX 250 / FX 500 User Manual
IMPORTANT INFORMATION TO INSTALLERS AND USERS
General
It is important that the user of this equipment read and observe all safety requirements and
operate the system according to the descripons published in this manual.
Failure to comply may result in risk of injury or equipment failure and voids the validity of
the warranty provided by equipment manufacturer.
The system consists of 2 systems, BDU and ADU and must be used as provided by the
manufacturer or authorized dealer. Do not substute any one of the system which
is not provided by the manufacturer or authorized dealer. Should needs of servicing or
replacement is required, always contact the distributor or manufacturer for instrucons.
Any modicaons or aempts to open up the devices by not authorized by Addvalue
Communicaons Pte Ltd, will void the warranty.
Contents in this manual may be subjected to change without noce, to obtain latest version,
please enquire it from product manufacturer or distributor.
Installaon:
Refer to Installaon Manual for FX 250 / 500 FleetBroadband System.
FX 250 / FX 500 User Manual
6
1 INTRODUCTION
The Skipper FX 250 / 500 User Equipment (UE) is a dedicated compact soluon specically
designed to meet the FleetBroadband ( FBB ) services for the marime environment
providing seamless ocean coverage from 76° North to 76° South. FBB is the marine version
of the highly successful BGAN (Broadband Global Area Network) from Inmarsat.
Through a marime BGAN antenna, it provides constant, simultaneous access to voice
and high-speed data in a compact soluon. Allowing you to run online operaon systems,
and sll having access to email, intranet and voice calls - achieving greater operaonal
eciencies and signicantly reducing the cost of both business and crew communicaons.
1.1 Range of Services
• Email and webmail
• Secure communicaons
• Intranet and internet access
• SMS and instant messaging
• Videoconferencing and streaming
• Phone and fax services
• Large le transfers
7FX 250 / FX 500 User Manual
1.2 Features
The FX 250 / 500 oers the following features:
The UE has built-in Web Console, allowing you to manage your phone book, messages and
calls, and customize the terminal to your specic needs
1.3 Interfaces
The FX 250 / 500 UE has the following connecng interfaces:
+12V / 24V DC Power Input Connector
Antenna Connector ( N-Type )
SIM Card Slot for FBB SIM card
Dedicated Primary Handset port
I/O Port
GPS Output Port
The number of RJ45 Ethernet ports and RJ11 ports for the BDUs of the FX 250 and FX 500
are illustrated below:
Services FX 250 FX 500
Coverage Voice, fax and data are available globally except for the extreme polar regions
Voice
4kbps AMBE+2
3. 1 K H z A ud i o
(above 20º elevaon)
4kbps AMBE+2
3.1KHz Audio
(above 5º elevaon)
Fax Group 3 fax via 3.1KHz Audio
(above 20º elevaon)
Group 3 fax via 3.1KHz Audio.
(above 5º elevaon)
SMS Standard 3G (up to 160 characters) per SMS. Maximum of 4 chained SMS.
Data
Standard IP : Up to 284 kbps
Streaming IP : 8, 16, 32, 64,
128 kbps
Standard IP : Up to 432 kbps
Streaming IP : 8, 16, 32, 64, 128,
256 kbps
RJ45 Ethernet Ports for PC and router 4 LAN Ports ( including 2 PoE)
RJ11 Phone YES
RJ11 Fax YES
Built-in WiFi YES
FX 250 / FX 500 User Manual
8
2 Overview of the FleetBroadband system
BGAN Services
The Broadband Global Area Network (BGAN) is a global Satellite Internet Network using
portable terminals. The terminals are usually connected to a laptop computer to access
broadband Internet in remote locaons, where a line-of-sight to the satellite exists. The
user can make phone calls, access the Internet, check e-mail, download les, or perform
any other Internet acvity using the terminals. The network is provided by Inmarsat and
uses three geostaonary satellites called I-4 to provide almost global coverage.
The map below shows the three I-4 satellite coverage regions.
Note: The above map depicts Inmarsat’s expectaons of coverage, but does not
represent a guarantee of service. The availability of service at the edge of coverage areas
uctuates depending on various condions.
Inhaltsverzeichnis
Andere Wideye Antenne Handbücher
Beliebte Antenne Handbücher anderer Marken
Alfa Network
Alfa Network APA-L01 Bedienungsanleitung
Naval
Naval PR-422CA Bedienungsanleitung
Feig Electronic
Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung
TERK Technologies
TERK Technologies TV44 Bedienungsanleitung
Directive Systems & Engineering
Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung
HP
HP J8999A Bedienungsanleitung
CommScope
CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung
Ramsey Electronics
Ramsey Electronics DAP25 Bedienungsanleitung
COBHAM
COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch
Trango Systems
Trango Systems AD900-9 Bedienungsanleitung
Steren
Steren ANT-100 Bedienungsanleitung
Proxim
Proxim 5054-PA-23 Bedienungsanleitung