BDU LED StatesGetting Started
• Connect the cables and accessories as shown
in Terminal Simplied Block Diagram.
• Insert a Fleet One SIM card, with the gold
printed circuit facing down.
• Switch on the terminal.
• User can access the web console when the
Terminal LED turns green.
• System is ready for normal operation when
the Terminal, Antenna and Registered LEDs
turn green.
Using the Optional Primary Handset
• On the optional primary handset, dial phone
number in the format:
<00><CountryCode><Telephone Number>
• Disconnect the call by pressing the key.
Using a Corded Analog Telephone
• Lift the handset or press the o-hook button,
listen for the dial-tone and dial phone number in
the following format:
<00><Country Code><Telephone Number><#>.
• Hang-up to disconnect.
Sending an SMS using the Optional
Primary Handset
• Select Menu>Messaging>OK>New
message>OK. Enter your test message using
the keypad.
• Select OK > Send.
• Enter the destination mobile number format:
<00><Country Code><Telephone Number>
OR
Select OK to choose an existing contact and
then select OK to send text message.
Status Meaning
TERMINAL
Steady Amber Terminal (BDU) is powering up.
Steady Green Terminal (BDU) has powered up
successfully.
Steady Red Terminal (BDU) has detected a
failure state.
Blinking Red VMS Alarm Notication.
ANTENNA
Steady Amber ADU is powering up.
Steady Red ADU has detected a failure
state.
Blinking Amber ADU is calibrating.
Blinking Green System is performing satellite
search.
Steady Green System has locked onto satellite.
No light (O) ADU is in OFF state.
REGISTERED
Steady Amber Attempting network registration
Steady Green Ready for all (Voice and Data).
Steady Red Network failure / Registration
error.
Blinking Amber Ready for Voice only.
Blinking Green Ready for Data only.
No light (O) No network service.
DATA ACTIVE
Steady Amber Activating data connection.
Steady Green Data connection is ready.
Steady Red Data activation failure
No light (O) No data connection.
Useful Password Reference:
• Web Console Username: admin (Default)
• Web Console Password: 1234 (Default)
• Terminal Pin: 0000 (Default)
Also applies to Factory Reset password.
