Williams Sound PPA SelectView R38 Bedienungsanleitung

PPA R38

PPA SelectView™ FM Receiver

QUICK SETUP GUIDE



1. Open the battery compartment. Slide the battery selection

switch to the correct position for the type of batteries that

will be used. Use “Alkaline” for non-rechargeable batteries,

“NiMH” for rechargeable NiMH batteries (only). (Fig. A)

IMPORTANT: If the battery switch is not in the correct

position, damage may be caused to the unit.



A311

ALKALINE/

NiMH SWITCH

CAUTION: RECHARGE

ONLY NiMH BATTERIES

BATTERY REMOVAL

FABRIC STRIP

2. Install the AA batteries. Be sure to observe proper polarity

(+/-). Damage due to improper battery installation may void

the warranty on the product. The power button on top of

the unit will ash when the batteries are getting low; you

may continue to use until the unit quits operating, then

replace or recharge the batteries. (Fig. A)

3. Turn the unit on: press and hold the power button for three

seconds. The power button will illuminate green. (Fig. B)



4. Select the desired operating channel/frequency on

the transmitter. Up to eight transmitters can operate

simultaneously on different channels (see 8 channel mode

in chart). (Fig. C)

5. Change the receiver to the channel/frequency chosen in

step 4. Push the menu button once and select the channel

by pushing the left or right arrow buttons. (Fig. D). If the

currently broadcasting channel is unknown, use the seek

function to nd it, by pushing and holding the right or left

arrow button. The receiver will stop when it nds an active

channel. If multiple channels are active, repeat the seek

function until the desired channel/frequency is found.

A428

3.5mm

STEREO/MONO

HEADPHONE

JACK

R38 TOP

POWER BUTTON/

LOW BATTERY

INDICATOR



6. To access additional settings, push-and-hold the menu

button. The receiver will display “Loading Advanced

Setup”. After viewing or changing a setting, push the menu

button again to access the next setting. If no buttons are

pushed during the screen time-out period (5, 30 or 60

seconds, adjustable in menu), the display returns to the

main screen and then shuts off to conserve battery power.

The receiver remains on (also see step 11). (Fig. D, Fig. E)

17 Ch Mode Letter Freq (MHz) 8 Ch Mode

1 A 72.1 1

2 B 72.3 2

3 O 72.6 3

4 P 72.8 4

5 I 74.7 5

6 R 75.4 6

7 G 75.7 7

8 H 75.9 8

9 C 72.5

10 K 72.2

11 N 72.4

12 D 72.7

13 E 72.9

14 J 75.3

15 S 75.6

16 T 75.8

17 F 75.5

A376

A430

VOLUME

LEVEL

BATTERY

LIFE

CHANNEL

(OR FREQ.)

RF SIGNAL STRENGTH SETTINGS LOCKED



7. Plug in the earphones/headphones into the headphone jack

(Fig. B). The earphone/headphone cord is the antenna.

8. Adjust the volume by pushing the left or right arrow buttons

(Fig D).

9. To lock (or unlock) all of the settings (except volume), push

and hold the left and right arrow buttons. Three dashes

will appear and then disappear. Keep holding the buttons

until the last dash disappears, and the screen prompts to

push the menu button. After pushing the menu button the

receiver will display “Settings Locked (or Unlocked)”.

T46 FRONT

LEFT

ARROW

BUTTON RIGHT

ARROW

BUTTON

OLED

DISPLAY

A309





A119

10. To install the belt clip, position the belt clip on the back of

receiver. Turn the belt clip 180˚ left or right to secure the clip.

The receiver can now be clipped onto a belt. To remove,

turn the belt clip 180˚ so the open end of the clip points up,

and gently pull the belt clip off. (FIG. E).

11. After 6 minutes with no RF signal, the receiver will go

into a power-saving sleep mode. At any time during sleep

mode, if the receiver nds signal on the current channel,

it will wake up. After 2 hours with no RF signal, the unit

will power off completely. During sleep mode the receiver

consumes about 80% less power.

12. When the receiver is not being used, turn the unit OFF by

pressing and holding the power button for three seconds

(Fig. B). The power button light will go off.



Williams Sound products are engineered, designed, and

manufactured under carefully controlled conditions to

provide you with many years of reliable service.

Williams Sound warrants the PPA R38 against defects

in materials and workmanship under normal use and

conditions for the useful lifetime of the product from date of

purchase.

Microphones, earphones, headphones, batteries, chargers,

cables, carry cases, and most other accessory products

carry a 90-day warranty.

This warranty does not cover reimbursement for your costs

of removing and transporting the product for warranty

service evaluation or installation of any replacement product

provided under this warranty.

*For Complete Warranty Statement go to: www.

williamssound.com/warranty-statement

NOTICE: Williams Sound products are NOT designed

for use in extreme temperature, humidity or chemical

environments. The introduction of chemicals such as

chlorine, salt water or human sweat into the product will

cause damage to the circuitry. Damage due to these

causes is NOT covered under the Product Warranty.





Battery Type: Two (2) AA 1.5 V non-rechargeable

Alkaline batteries (BAT 001-2), 47 mA

nominal current drain, up to 50 hours

battery life, or

Two (2) AA 1.5 V rechargeable NiMH

batteries (BAT 026-2), 47 mA nominal

current drain, up to 32 hours battery life

per charge, recharges in 14–16 hours,

uses CHG 3502 or CHG 3512 Charger

Operating

Frequencies:

Selectable, 17 wideband channels,

72.1 – 75.9 MHz (channels 1-8 are a

non-interfering channel set - used for

simultaneous broadcast - see Fig. C)

Antenna: Integral with earphone/headphone cord

(required)

External/

Controls:

Top: Momentary push button - push and

hold 3 seconds for power On/Off. Low

battery: button ashes.

Front: Left Arrow, Menu, Right Arrow

buttons for accessing/changing the

receiver settings

Display: 1” OLED, for viewing receiver settings

Operating

Frequencies:

72.1, 72.2, 72.3, 72.4, 72.5, 72.6, 72.7,

72.8, 72.9, 74.7, 75.3, 75.4, 75.5, 75.6,

75.7, 75.8, 75.9 MHz*

Compatible

Transmitters: PPA T45, PPA T35, PPA T46, PPA T27

Audio Output: 3.5 mm stereo/mono headphone jack

Approvals: FCC, Industry Canada, RoHS, WEEE

Warranty: Lifetime PLUS Limited Warranty





NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

This device complies with “RSS-Gen Issue 2 June 2007” for Industry Canada and FCC part

15.105[b] for the United States.

Operation is subject to the following two conditions: [1] this device may not cause interference,

and [2] this device must accept any interference, including interference that may cause undesired

operation of the device.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject

to the following two conditions: (1) This device may not cause interference, and (2) this device

must accept any interference, including any interference that may cause undesired operation

of the device.

Cet appareil est conforme à la norme RSS Industrie Canada exempt de licence. Son fonc-

tionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer

d’interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences

pouvant causer un mauvais fonctionnement du dispositif.

This device complies with ICES-003 class B. Test data is available from the manufacturer on

request.







This product is designed to amplify sounds to a high

volume. To protect your hearing and the hearing of others:

1. Make sure the unit is OFF or the volume is turned down

before putting on the earphones.

2. Set volume level at the minimum setting you need to hear.

3. Do not allow children or other unauthorized persons to

have access to this product.





Do not attempt to recharge alkaline or other non-

rechargeable batteries, which may explode, release

dangerous chemicals, cause burns, or cause other serious

harm to the user or product. To reduce the risk of re or

burns, do not crush, puncture, short contacts, or expose to

temperatures above 140F (60C). Replace only with battery

types designated for this product. Recycle or dispose of

properly.





Before using this product with a pacemaker or other

implantable medical device, consultant your physician

or the manufacturer of the device to make sure that you

are using this product in accordance with their safety

guidelines.

Inhaltsverzeichnis

Andere Williams Sound Stereo-Receiver Handbücher

Williams Sound

Williams Sound WIR SYS 90 PRO Bedienungsanleitung

Williams Sound

Williams Sound PPA R19-6 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus Infrared System WIR SYS 90V Bedienungsanleitung

Williams Sound

Williams Sound Personal PA Wideband Receiver PPA R7-4NA Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus Basic Courtroom System WIR SYS 1 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus Infrared System WIR TX925 Bedienungsanleitung

Williams Sound

Williams Sound Personal Receiver R1-173 Montageanleitung

Williams Sound

Williams Sound Receiver WIR RX16 Montageanleitung

Williams Sound

Williams Sound Infrared Receiver WIR RX22-4 Betriebsanleitung

Williams Sound

Williams Sound SoundPlus Value Courtroom System WIR SYS 2 Bedienungsanleitung

Williams Sound

Williams Sound Receiver WIR RX14-2 Montageanleitung

Williams Sound

Williams Sound PPA R751 Bedienungsanleitung

Williams Sound

Williams Sound PPA R35-8 Montageanleitung

Williams Sound

Williams Sound Personal PA Receiver PPA R19 Bedienungsanleitung

Beliebte Stereo-Receiver Handbücher anderer Marken

Marantz

Marantz CINEMA 70S Bedienungsanleitung

Kenwood

Kenwood KMDX92 Bedienungsanleitung

Yamaha

Yamaha RX-830 Bedienungsanleitung

Pioneer

Pioneer AVH-Z7250BT Bedienungsanleitung

Yamaha

Yamaha RX-750 Bedienungsanleitung

Denon

Denon AVR-1311 Bedienungsanleitung

Denon

Denon AVR-S760H Bedienungsanleitung

Denon

Denon AVR-X7200W Bedienungsanleitung

Pioneer

Pioneer SC-LX904 Handbuch

Sony

Sony XAV-1500 Bedienungsanleitung

Radio Shack

Radio Shack DX-399 Bedienungsanleitung

Sony

Sony STR-DE535 - Fm Stereo/fm-am Receiver Bedienungsanleitung

Pioneer

Pioneer SX-1000TA Bedienungsanleitung

Yamaha

Yamaha MusicCast TSR-5B3D Bedienungsanleitung

Sony

Sony STR-DE335 - Fm Stereo/fm-am Receiver Bedienungsanleitung

Sony

Sony STR-DG500 - Multi Channel Av Receiver Bedienungsanleitung

Panasonic

Panasonic AJSD955B - DVCPRO50 STUDIO DECK Bedienungsanleitung

Pioneer

Pioneer SX-838 Bedienungsanleitung