FOR YOUR SAFETY
3
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed
to reduce the risk of fire, electrical shock and injury to persons, including
the following:
READ ALL INSTRUCTIONS BEFORE OPERATING THIS HEATER.
1) This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
Use handle when moving this heater. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the
front of this heater and away from the sides and rear.
2) Extreme caution is necessary when any heater is used near a child or physically
disabled person. NEVER LEAVE THE HEATER UNATTENDED WHILE OPERATING.
3) ALWAYS UNPLUG HEATER WHEN NOT IN USE.
4) Do not operate any heater with a damaged power cord or plug or after the heater
malfunctions or if it has been dropped or damaged in any manner. Return the heater
to WindChaser for examination in case of need for electric or mechanical adjustment
and repair.
5) DO NOT USE OUTDOORS.
6) This heater is not intended for use in bathrooms, laundry areas or similar indoor
locations where there may be moisture. Never place heater where it may fall into a
bathtub or other water receptacle.
7) Do not run power cord under carpeting. Do not cover cord with throw rugs, runners or
the like. Arrange cord away from traffic area to avoid tripping over it.
8) To disconnect heater, turn controls to off, then remove plug from outlet.
9) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause electric shock, fire or damage to the heater.
10) To prevent possible fire, do not block air intakes or exhaust openings in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked.
11) A heater has hot, arcing or sparking parts inside. Do not use it in areas where
gasoline, paint or flammable liquids are used or stored.
12) Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock or injury to persons.
13) The heater is not intended for use with an extension cord. Plug the cord directly into
an appropriate wall receptacle. However, if an extension cord is needed, the cord
should be No. 14 AWG minimum size and rated no less than 1875W.
14) THIS PRODUCT IS EQUIPPED WITH A POLARIZED A.C.
(Alternating Current) PLUG — a plug having one prong wider than the other.
This plug will fit into the power outlet only one way. This is the safety feature.
If you are unable to insert the plug fully into the outlet, try reversing the plug.
If the plug should still fail to fit, contact an electrician to replace the obsolete
outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG.
SAVE THESE INSTRUCTIONS
Oscillation function:
1. Press the Oscillate button to allow the unit to oscillate. To turn off the
oscillation function, press the Oscillate button again.
NOTE: THE UNIT CAN OSCILLATE IN BOTH VERTICALAND
HORIZONTAL POSITIONS.
Safety features:
Auto thermal cut-off
1. If the heater experiences excessive heat , the auto thermal cut-off will shut
the unit off.
2. Be sure that the front grill is not blocked and nothing is restricting any airflow.
3. Unplug the unit and let it cool down for 10 minutes before plugging the unit
back in again. If the heater fails to operate after 10 minutes, it may have
internal damage. Please contact WindChaser Products customer service at
Safety tip over switch
1. Heater is designed to automatically shut-off when tipped forwards or
backwards.
2. Return the heater to its normal upright position on a level surface to
operate again.
8
