© 2012 Wirepath™ Surveillance
pg. 3
WPS-MNT-EXT-DOM Installation Manual
Conduit Mounting (3/4”)
A. Remove the dome from the Camera Base
using the 3mm Allan key supplied with the
camera. Avoid contact of the dome with
surfaces in order to avoid scratching the
material.
B. Connect the wires from the junction box or
conduit to the Cameras wires.
C. Align the mounting holes in the camera base
with the with the camera screw locations.
Tip: Inserting a mounting screw into the Camera
Base and then into the Dome Extension Mount
speeds up the alignment process.
Note: To avoid moisture from entering the
camera; ensure that the rubber grommets are
on the screws during installation.
D. Secure the Camera Base to the Dome
Extension Mount (A) using all 3 provided
M4x25L - Round Head Philips (D) screws with
rubber washers.
E. Loosely re-attach the dome cover onto the Camera base. Note that you will need to remove the
dome cover later to setup the camera once it is fully mounted.
A. Using a utility knife, remove the center part of the gasket located on the rear of the Extension
Mount. This allow for easy installation of the conduit into the mount. (Figure 2)
B. Run the wires from the Conduit through the center hole in the Extension Mount. (Figure 3)
C. Secure the Mount to the conduit by rotating clockwise.
The WPS-MNT-EXT-DOM can also be used for commercial installations where mounting to the end of
threaded conduit is desired. This type of installation is for indoor use only, do not use this method for
outdoor cameras.
Remove
Figure 2 Figure 3
2. Attach the Camera to the Mount
Figure 4
Note: Internal camera components removed for
demo purposes. DO NOT disassemble the camera.
