5
Figure 6
Figure 7
Figure 8
Figure 9
Assembly of Fronts
All Models
Carefully lift the front surround. Hook the front surround onto the retaining plates on
the heater body and lower the front surround down – See figure 6.
Marseilles model 801
Check that the switch control spindle is in the OFF position and the slider is in the
OFF position. Swing the control linkage/boss towards the control spindle on the
heater and push the boss onto the spindle, ensuring the “D” flats are in alignment –
See figure 7
Final Assembly
With the two screws provided, fix the front surround to the heater body – See figure 8
Check the controls to make sure they operate smoothly.
Place the front casting/fuel support in position by passing the screw heads through the key hole
slots in the surround and lowering down – See figure 9.
Fuel Effects
Open the polythene bag containing the loose coals and place them on and in front of the
coal support to give the most pleasing effect. It is not necessary to use all the coals
supplied.
Place the ash pan into position below the casting.
Operating the Heater
Never cover the heater, there is a risk of fire if covered.
Sonnet model 802
The heater is operated by three switches, located below the canopy.
Switch 1 = O Main On – Off
In the On position only the fuel effect light operates
Switch 2 = ❙1 kW fan heat setting and fuel effect
Switch 3 = ❙❙ 2 kW fan heat setting and fuel effect
The switches are mechanically interlocked, so when switch 1 is turned off, all switches turn off.
Marseilles model 801
These models have a slider control located on the right side of the surround for operating the main functions of the heater.
Located to the left of the fan outlet grille is a lamp dimmer control and a room thermostat control.
The Lamp Dimmer is used to set the light output of the fuel effect between off and high as required.
The Room Thermostat is used to maintain room temperature, the higher the setting, the higher the room temperature
will be before the heater turns off. When using the fan Coolblow setting, the thermostat should be turned to a high
position.
The Slider Control
There are four slider positionsnOff
Fuel effect lighting on
Fan Coolblow on. Fuel effect lighting on (Set thermostat at High).
Fan heater on (2kw). Fuel effect lighting on (Set thermostat to a high setting and
allow the room temperature to settle before re-adjusting).
