If using a new HDD, you must format it after assembling WS-131C.
If using a used HDD, you'd better reformat after assembling WS-131C.
B. Separate upper and lower cases.
C. Connect the HDD to the PCB board.
D. Turn over the case and screw the PCB board with 4 pieces of large bolts.
E. Screw the upper and lower cases with 8 pieces of small bolts.
4. Part name of Wonlink WS-131C
․ Blue LED indicator : shows the status of transferring data
․ Red LED indicator : shows that status of connecting with Wonlink WS-131C
․ IEEE1394 6 pin connector : connects IEEE1394 6pin cable
․ USB 2.0 connector : connects USB 2.0 cable
․ Slide switch :
a. USB 2.0 : when using USB
b. USB 2.0-DC-Firewire : when using USB/IEEE1394 with extra power
c. Firewire : when using IEEE1394(Firewire)
4-1. How to Install IEEE1394(Firewire)
Place the slide switch on Firewire and connect IEEE1394 6pin cable.
◆ Recognize as IEEE1394 device with red color signal on lamp 1.
◆ When it access to Harddisk, blue color signal appears on lamp 2.
◆ When adequate power is not supplied in using notebook with 4pin or 6pin cable,
place the slide switch on USB2.0-DC-Firewire and connect PS/2-USB Power
Cable to PS/2 or USB port and to power terminal of WS131-C.
(For use of IEEE1394, driver is not needed. Refer to the manual inside of CD
for something related in driver or harddisk(FDISK, FORMAT)).
4-2. How to install USB2.0
Place the slide switch on USB2.0 and connect USB2.0 cable.
◆ Recognize as USB2.0 device with red color signal on lamp 1.
◆ When it access to Harddisk, blue color signal appears on lamp 2.
◆ When adequate power is not supplied in using desktop or notebook, place the
slide switch on USB2.0-DC-Firewire and connect PS/2-USB Power Cable to
PS/2 or USB port and to power terminal of WS131-C.
(For use of USB2.0, driver is needed under Windows 98 SE. Refer to the
manual inside of CD for something related in driver or harddisk(FDISK,
FORMAT).
