WorkPro Light Mouse Series Bedienungsanleitung
2 / 21
Ports:
Contacts:
3 / 21
Ethernet port
Main supply port
Supply optional port
Multifunction connection port,
PIN
Contact
1
GPIO 1
2
GPIO 2
3
GND
4
GPIO 3
5
GPIO 4
6
GND
7
GPIO 5
8
GPIO 6
9
GPIO 7
10
GPIO 8
11
GND
12
GPIO 9
13
GPIO 10
14
A 1
15
A 2
4 / 21
Activity LED indicator
Connection LED indicator
Ethernet port
Main supply port
Option supply port
Power LED indicator
Multifunction connection
5 / 21
6 / 21
LM GPIO detection in WorkCAD
7 / 21
Getting information about LM GPIO in WorkCAD
To get information about any device, place the mouse pointer over “i” icon of each device
Updating the LM GPIO in WorkCAD
Before to install the LM devices is recommended to update all of them to a recent
software version, they include bugs corrections and new functionalities. The steps for
device updating are the following:
1.Start WorkCAD and press“Network” tab, there you can find all LM family devices
available in the network.
2. Sliding the mouse pointer over the name of the device, you can see different icons, if it
appear the ^icon, it means we need to update the device.
8 / 21
3. Click on ^ icon ( in case of it is showed ) to update the device.
If an error mistake appears pressing “Yes”, please, check the IP range in the PC with
WorkCAD, it must be the same as the LM device.
GPIO
LM GPIO
9 / 21
4.Click on “YES” and the updating process will start.
5.During the updating process the progress bar will stop some seconds during the
auto-reset, please, keep some seconds and do not disconnect the device until the
process finishes
6.Once finished the updating process, WorkCAD will show a window indicating that
the process must be finished successfully.
10 / 21
Changing the LM GPIO name in WorkCAD
1-In order to change the name of the device, it is necessary to add it to a project,
therefore, press “+” icon in a device will be showed in “Network” tab. The device will
be inside “Project inspector” (Upper/left side).
2-Over the device name, press “left click” and a dropdown menu will be showed,
then, select “Rename” option.
3-Assign a new name.
Ones modified the name and IP address, it is advisable to reset the device in order
to store the data correctly.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere WorkPro Aufnahmegeräte Handbücher
Beliebte Aufnahmegeräte Handbücher anderer Marken
Strymon
Strymon NIGHTSKY Bedienungsanleitung
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Bedienungsanleitung
Tews Technologies
Tews Technologies TPMC465 Bedienungsanleitung
Honeywell
Honeywell Excel 50 Bedienungsanleitung
SeaLevel
SeaLevel COMM+8.LPCI Bedienungsanleitung
Arturia
Arturia AUDIOFUSE STUDIO Bedienungsanleitung
