The on/off switch is fitted with a brake function which stops your
chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
Warning: Do not operate for long periods at low speed
because excess heat will be produced internally.
The switch trigger can be locked in the OFF position. This helps to
reduce the possibility of accidental starting when not in use. To lock
the switch trigger, place the rotation control in the center position.
For drilling and screw driving use forward rotation marked “ ”
(lever is moved to the left). Only use reverse rotation marked “ ”
(lever is moved to the right) to remove screws or release a jammed
drill bit.
Warning: Never change the direction of rotation when the
chuck is rotating, wait until it has stopped!
The drill has a two-speed gear control designed for drilling or driving
at LOW (mark is 1) or HIGH (mark is 2) speeds. A slide switch is
located on top of the drill to select either LOW or HIGH speed. When
using the drill in the LOW speed range, the speed will decrease and
the drill will have greater power and torque. When using the drill in
the HIGH speed range, the speed will increase and the drill will have
less power and torque.
Gear I
2
3
4
Low speed range: for screwdriving or working with large drilling
diameter
Gear II
High speed range: for working with small drilling diameter
Warning: To prevent gear damage, always allow the chuck
to come to a complete stop before changing the direction of
rotation or the two-speed gear control.
To open the chuck jaws rotate the front section of the chuck. Insert
the drill bit between the chuck jaws and rotate the front section in
the opposite direction. Ensure the drill bit is in the center of the chuck
jaws. Finally, firmly rotate the front chuck section in the opposite
directions. Your drill bit is now clamped in the chuck.
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The
torque is greater when the torque adjustment ring is set on a higher
setting. The torque is less when the torque adjustment ring is set on
a lower setting.
When drilling in wood, metal, plastic and screwdriver choose the drill
position .
Make the setting as follows:
1 - 4 for driving small screws
5 - 8 for driving screws into soft material
9 - 12 for driving screws into soft and hard material
13 - 16 for driving screws into hard wood
5
6
