Wunderkind Custom BMR18T Originalbetriebsanleitung

• www.wunderkind-custom.com ••• info@wunderkind-custom.com •

Installation manual and safety information

Lowering kit for headlight with speedometer

BMW R18

From model year 2021

Installation manual

• Revision: 00 • 30/04/2021 • © ABM Fahrzeugtechnik GmbH Page 2 of 4

Caution

Important safety advice:

Working on motorcycles poses a safety risk. Some work may only be carried out by appropriately

qualified personnel. Faulty work can have serious consequences and may pose a threat to life and

health. Only undertake installation works if you are sufficiently qualified and have an official workshop

manual as well as all relevant service notifications available. Otherwise, we strongly recommend that

the installation is carried out or at least checked in a specialist workshop.

Any work in relation to the installation, removal and tightening torque of original parts should always be

carried out in compliance with the workshop manual.

All screws must be attached with thread-locking fluid. However, this should only be done after the

installation is complete.

It is your responsibility to check the product regularly and to determine if a service or replacement is

required.

Please bear in mind that some products are safety-relevant parts of your vehicle. After a fall or collision,

check the product and if there is the slightest indication of damage, you must completely replace it.

Some products require registration.

These products have been designed for a standard vehicle. ABM® Fahrzeugtechnik GmbH makes no

warranty or guarantee of any kind for any damages whatsoever arising out of the combination with

other component parts not tested by ABM, as a consequence of improper installation or inadequate

maintenance.

Brake fluid may damage painted surfaces and fairings. Use suitable means to protect all of the surfaces

against damage.

Preparation

Please read the entire safety information and installation manual carefully.

A motorcycle not securely positioned can fall over during the following work. Therefore, make sure

that the motorbike is positioned on solid, flat ground and is secured against falling over and rolling

away.

Keep children and pets away from the work area.

Protect removed parts from damage.

Please note when disassembling individual parts which screws are used to fasten them. Keep these

parts and screws and unless specified otherwise, reuse when assembling.

Installation manual

• Revision: 00 • 30/04/2021 • © ABM Fahrzeugtechnik GmbH Page 3 of 4

Installation:

Make sure that the motorbike is securely positioned.

Remove the original headlight.

Pull out the plug of the headlight.

Replace the original headlight holder with the one

provided.

Installation manual

• Revision: 00 • 30/04/2021 • © ABM Fahrzeugtechnik GmbH Page 4 of 4

All electric wires must be laid in a manner which prevents them from bending or getting pulled during spring

deflection movements and which adequately protects them against rubbing.

After completing the work, check that all components and screws are tight and functioning correctly. Also

check the rear wheel's freewheel and the functionality of the brake system. Afterwards, a test drive must be

carried out! After completing the test drive, the tightness of all screw connections must be checked, as well

as the adequate free travel of all moving parts. Re-test the rear wheel's freewheel and check the brake

system for overheating.

Replace the brake lines. Please observe the manufacturer's

specifications!

Caution: To ensure a twist-free installation, the cable

connections can be aligned once at the fitting. Always use

new seals when installing.

Vent and check the brake systems according to

manufacturer's specifications.

Check the pressure point and function of the brake and

clutch.

Loosen the speedometer holder and attach using the

spacer bushings, washers and screws provided.

Reconnect the headlight.

Re-mount the headlight with holder.

Adjust the headlight and tighten all screws.

Check the function of all parts.

Final check

Inhaltsverzeichnis

Andere Wunderkind Custom Motorradzubehör Handbücher

Wunderkind Custom

Wunderkind Custom 106680-F15 Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom Horn bracket Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom FTR 1200 Benutzerhandbuch

Wunderkind Custom

Wunderkind Custom 106503-F15 Benutzerhandbuch

Wunderkind Custom

Wunderkind Custom 106852-F15 Benutzerhandbuch

Wunderkind Custom

Wunderkind Custom Indian Scout Bobber 2018 Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom 107045-F15 Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom Scout Bobber ABS Benutzerhandbuch

Wunderkind Custom

Wunderkind Custom BMR18T Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom FTR 1200 Benutzerhandbuch

Wunderkind Custom

Wunderkind Custom Fender Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom 2Stripes Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom BMR18T Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom HDN1V Handbuch

Wunderkind Custom

Wunderkind Custom LittleOne Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom 106725-F15 Benutzerhandbuch

Wunderkind Custom

Wunderkind Custom littleOne BMR18T Originalbetriebsanleitung

Wunderkind Custom

Wunderkind Custom HDN1V Handbuch

Beliebte Motorradzubehör Handbücher anderer Marken

SRC

SRC B-TRK502-01-01-SL Bedienungsanleitung

hepco & becker

hepco & becker 6307520 00 01 Bedienungsanleitung

HOMCOM

HOMCOM AA0-077 Bedienungsanleitung

hepco & becker

hepco & becker 6307558 00 01 Bedienungsanleitung

Dräger

Dräger HPS 3500 Bedienungsanleitung

M-WAVE

M-WAVE SKI Bedienungsanleitung

Kuryakyn

Kuryakyn 6212 Bedienungsanleitung

hepco & becker

hepco & becker 6507504 00 01 Bedienungsanleitung

Tool it

Tool it PROMAX LCD 9.13G Bedienungsanleitung

Custom Dynamics

Custom Dynamics TruWrapz Bedienungsanleitung

Roof

Roof RO200 CARBON Bedienungsanleitung

Kabuto

Kabuto Japan IBUKI Bedienungsanleitung

PUIG

PUIG 5051 Bedienungsanleitung

rizoma

rizoma ZTH050 Bedienungsanleitung

Joubert

Joubert 10001711 Bedienungsanleitung

SW-Motech

SW-Motech SBL.01.971.10000/B Bedienungsanleitung

GÜDE

GÜDE GSH 180-TC-2 Bedienungsanleitung

Cyclevision

Cyclevision EDGE CVHC-01-01 Bedienungsanleitung