Xantrex Power Inverter Stacking Bedienungsanleitung

www.xantrex.com

Smart choice for power

Inverter Stacking

Control Series

(ISC-S) Cable

Installation Guide

Inverter Stacking Control Series (ISC-S)

Cable

Installation Guide

About Xantrex

Xantrex Technology Inc. is a world-leading supplier of advanced power electronics and controls with products from

50 watt mobile units to one MW utility-scale systems for wind, solar, batteries, fuel cells, microturbines, and backup

power applications in both grid-connected and stand-alone systems. Xantrex products include inverters, battery

chargers, programmable power supplies, and variable speed drives that convert, supply, control, clean, and distribute

electrical power.

Trademarks

Inverter Stacking Control – Series Cable is a trademark of Xantrex International. Xantrex is a registered trademark of

Xantrex International.

Other trademarks, registered trademarks, and product names are the property of their respective owners and are used

herein for identification purposes only.

Notice of Copyright

Inverter Stacking Control Series (ISC-S) Cable Installation Guide© January 2004 Xantrex International. All rights

reserved.

Disclaimer

UNLESS SPECIFICALLY AGREED TO IN WRITING, XANTREX TECHNOLOGY INC. (“XANTREX”)

(a) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF ANY

TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION.

(b) ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSS OR DAMAGE, WHETHER DIRECT,

INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH

INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE ENTIRELY AT THE USER’S RISK.

Date and Revision

January 2004 Rev A

Part Number

975-0059-01-01 Rev A

Contact Information

Telephone: 1 800 670 0707 (toll free North America)

1 360 925 5097 (direct)

Fax: 1 800 994 7828 (toll free North America)

1 360 925 5143 (direct)

Email: customerservice@xantrex.com

Web: www.xantrex.com

975-0059-01-01 Rev A iii

About This Guide

Purpose

The purpose of this Installation Guide is to provide explanations and procedures

for installing the Inverter Stacking Control – Series Cable and provides

information regarding stacking two identical Sine Wave Plus inverters.

Scope

The Guide provides safety guidelines, detailed planning and setup information for

stacking inverters, and procedures for installing the ISC-S cable.

Audience

The Guide is intended for anyone who needs to install series-stacked, Sine Wave

Plus inverters using the Inverter Stacking Control – Series Cable. Installers should

be certified technicians or electricians.

Organization

This Guide is organized into three chapters.

Chapter 1, “Introduction” provides information on stacking of Sine Wave Plus

inverters.

Chapter 2, “Installation” provides information on installing the DC wiring, AC

Wiring, and the ISC-S for Sine Wave Plus inverters.

Chapter 3, “Operation”contains information on startup and functional testing

procedures for series-stacked Sine Wave Plus inverters.

Warranty and Product Information is provided at the end of the Guide.

About This Guide

iv 975-0059-01-01 Rev A

Conventions Used

The following conventions are used in this guide.

Abbreviations and Acronyms

The following acronyms and abbreviations are used in this guide:

Related Information

You can find more information about Xantrex Technology Inc. as well as its

products and services at www.xantrex.com

WARNING

Warnings identify conditions that could result in personal injury or loss of life.

CAUTION

Cautions identify conditions or practices that could result in damage to the unit or

other equipment.

Important:

These notes describe things which are important for you to

know, but not as serious as a caution or warning.

AC Alternating Current

ASC Authorized Service Center

BTS Battery Temperature Sensor

DC Direct Current

DCCB DC Conduit Box

DVM Digital Voltage Meter

GSM Generator Start Module

ISC-S cable Inverter Stacking Control – Series Cable

Hz Hertz

RMA Return Material Authorization

Vac AC Voltage

975-0059-01-01 Rev A v

Important Safety Instructions

1. Before installing and using the ISC-S cable, read all instructions and

cautionary information in this guide.

2. Do not expose the ISC-S cable to rain, snow, spray, or water.

3. Use only attachments recommended or sold by the manufacturer. Doing

otherwise may result in a risk of fire, electric shock, or injury to persons.

4. Do not operate the ISC-S cable if it has been damaged in any way. If the ISC-

S cable is damaged, see the Warranty section.

5. Do not disassemble the ISC-S cable. It contains no user-serviceable parts. See

Warranty for instructions on obtaining service. Attempting to service the ISC-

S cable yourself will void your wawrranty.

6. To reduce the risk of electrical shock, disconnect both AC and DC power

from the inverters before attempting any maintenance or cleaning or working

on any circuits connected to the ISC-S cable. Turning off the inverters will not

reduce this risk.

WARNING

This chapter contains important safety and operating instructions. Read and keep this

Installation Guide for future reference.

975-0059-01-01 Rev A vii

Important Safety Instructions

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -v

Introduction

Stacking Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 1–2

The ISC-S Cable - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 1–5

Installation

DC Wiring - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–2

Battery Requirements for Series-stacked Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–2

Battery-Bank Configuration for Series-stacked Inverters - - - - - - - - - - - - - - - - - - - - - - - - - 2–2

Grounding Series-stacked Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–3

Connecting the Battery Bank to the Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–4

AC Wiring - General - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–6

Inverter AC Distribution Panel (Sub-Panel) Wiring (if used) - - - - - - - - - - - - - - - - - - - - - - - 2–6

Neutral Bonding - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–7

Grounding - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–7

AC Wiring - Specific - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–8

Off-Grid AC Wiring for Sine Wave Plus Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–8

On-Grid AC Wiring for Sine Wave Plus Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–10

Generator AC Wiring to Series-stacked Inverters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–12

Wiring for a 240 Vac-Only Input Source - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–14

Connecting the ISC-S Cable - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–16

Operation

Start-up and Testing- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–2

Setting Changes - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–4

Automatic and Manual Generator Control - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–4

Bulk and Float Charging Parameters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–4

Equalize Charging - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–4

Automatic Generator Equalize Charging - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–5

Manual Equalize Charging - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3–5

Warranty and Return Information

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - WA–1

Index

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - IX–1

Contents

viii

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Xantrex Kabel und Steckverbinder Handbücher

Xantrex

Xantrex SWI - INSTALLATION REV B Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken

Philips

Philips SWA6310 Bedienungsanleitung

StarTech.com

StarTech.com CRJ4550PK Bedienungsanleitung

Nohau

Nohau EMUL-IP2K-PC Bedienungsanleitung

Foxun

Foxun SX-SP144E-HD4K2K Bedienungsanleitung

Philips

Philips SWA3305W Bedienungsanleitung

opticis

opticis Stretch DVIM1-1P0x Bedienungsanleitung

Volkswagen

Volkswagen VAS 6558A Bedienungsanleitung

NEXIBO

NEXIBO N-13 Bedienungsanleitung

CYP

CYP PU-1H3HBTL Bedienungsanleitung

Allen-Bradley

Allen-Bradley 1784-u2dhp Bedienungsanleitung

Global Caché

Global Caché Flex Link Blaster Bedienungsanleitung

Hauppauge

Hauppauge USB-Live2 Bedienungsanleitung

Fenix

Fenix MPSV 15 Bedienungsanleitung

BEGA

BEGA 71 085 Bedienungsanleitung

Tesla

Tesla HPWC Bedienungsanleitung

GAMERON

GAMERON LUXURY TV CABLE Bedienungsanleitung

molex

molex Milli-Grid Dual row 87568 Series Bedienungsanleitung

Burndy

Burndy Continental Industries thermOweld CRE-7 Bedienungsanleitung

Xantrex power Inverter Stacking Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken