XEMEX DINgate DSO Bedienungsanleitung

USER MANUAL

DINgate DSO

any means, electronic, mechanical, photocopying, recording or otherwise, without prior written permission of the publisher.

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 2 of 16

DOCUMENT INFO

Version: 1.0

Status: Draft

Version date: 1/10/2021

Filename: User Manual - DINgate DSO.docx

Author: Luc Olieslagers

Number of pages: 16

HISTORY CHANGES

VERSION

DATE

DESCRIPTION

1.0

11/08/2021

Draft

User Manual - DINgate DSO 
October 2021 XEMEX Confidential Page 3 of 16 
TABLE OF CONTENTS 
1INTRODUCTION...................................................................................................................................... 5 
1 Scope .............................................................................................................................................................. 5 
2 Target group................................................................................................................................................... 5 
3 Disclaimer....................................................................................................................................................... 5 
4 Applicable product versions ........................................................................................................................... 5 
5 Intended usage............................................................................................................................................... 5 
6 Technical assistance ....................................................................................................................................... 5 
7 Used symbols.................................................................................................................................................. 5 
8 Safety precautions.......................................................................................................................................... 6 
2TECHNICAL DESCRIPTION................................................................................................................... 7 
3TECHNICAL SPECIFICATIONS ............................................................................................................. 8 
1 Mains power connection................................................................................................................................ 8 
2 RS485 / Modbus RTU Interface ...................................................................................................................... 8 
2.1 Physical Interface ....................................................................................................................................... 8 
2.2 Protocol Description................................................................................................................................... 8 
3 IR Interface ..................................................................................................................................................... 8 
4 User Interface - LEDs ...................................................................................................................................... 9 
5 SIM card slot................................................................................................................................................... 9 
6 LTE antenna connection ................................................................................................................................. 9 
6.1 DINgate DSO 1.0......................................................................................................................................... 9 
6.2 DINgate DSO 1.1......................................................................................................................................... 9 
7 Enclosure ........................................................................................................................................................ 9 
8 Environmental conditions .............................................................................................................................. 9 
9 Standards........................................................................................................................................................ 9 
4INSTALLATION INSTRUCTIONS.........................................................................................................11 
1 Guidelines for safety and installation........................................................................................................... 11 
2 Mounting...................................................................................................................................................... 11 
3 Electrical wiring diagram .............................................................................................................................. 11 
4 Data connection with ABB B21 / B23 E-meter ............................................................................................. 12 
4.1 Via IR Interface......................................................................................................................................... 12 
4.2 Via Modbus Interface............................................................................................................................... 12 
5 Insert/extract SIM card................................................................................................................................. 13 
6 LTE Antenna.................................................................................................................................................. 13 
7 Mains power................................................................................................................................................. 13 
8 Configuration................................................................................................................................................ 14 
5OPERATING INSTRUCTIONS..............................................................................................................15 
1 PWR –POWER Status LED –Red LED ........................................................................................................... 15 
2 WAN –Network Status LED –Green LED ..................................................................................................... 15 
3 Service button .............................................................................................................................................. 15 

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 4 of 16

6CLEANING.............................................................................................................................................16

7LIFTING AND CARRYING.....................................................................................................................16

8MAINTENANCE AND SERVICE ........................................................................................................... 16

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 5 of 16

1Introduction

1.1 Scope

This manual is applicable to DINgate DSO, a communication gateway for the ABB B21/B23 E-meter family.

It describes the specifications, installation and operation of the product. Please read this document carefully before

installation and operating.

1.2 Target group

The installation and the operation of this device and any maintenance must be carried out by a qualified person in

accordance with specific local standards and safety regulations.

1.3 Disclaimer

The information in this document is subject to change without notice and should not be construed as a promise by

Xemex. Xemex assumes no liability for possible errors in this document. In no event shall Xemex be liable for direct,

indirect, special, incidental, or consequential damages of any kind arising out of the use of this document, nor shall

Xemex be liable for incidental or consequential damages arising out of the use of this document, described software

or hardware.

1.4 Applicable product versions

This manual is applicable for following product versions:

Product version

Description

DINgate 1.0 –DSO

4G Cat-1 with GPRS fallback communication gateway for ABB B21/B23 E-meters

DINgate 1.1 –DSO

4G Cat-M communication gateway for ABB B21/B23 E-meters

1.5 Intended usage

The DINgate DSO module can only be used in combination with the ABB B21/B23 E-meter family and shall operate

within the specified values only.

1.6 Technical assistance

In case technical assistance is needed, contact Xemex NV:

XEMEX NV

Metropoolstraat 11a

B-2900 Schoten

Belgium

Tel: +32 201 95 95

E-mail: support@xemex.eu

1.7 Used symbols

Following symbols are used in this document and/or are marked on the product:

Alternating current

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 6 of 16

Three-phase alternating current

Equipment protected throughout by DOUBLE INSULATION or REINFORCED

INSULATION

Caution, possibility of electric shock

Caution

1.8 Safety precautions

DANGER —HAZARDOUS VOLTAGES

WARNING - These installation/servicing instructions are for use by qualified personnel only.

To avoid electrical shock, do not perform any servicing other than that contained in the

operating instructions unless you are qualified to do so.

WARNING –Mains protection

WARNING - The DINgate module must always be protected by fuses on the incoming side. To

enable maintenance DINgate module, it is recommended to install a short circuit protection.

Do not operate the equipment other than indicated by the technical data.

Always adhere to the following checklist:

1. Only qualified personnel or licensed electricians should install the Xemex DINgate DSO. The mains voltages

of 230 Vac can be lethal!

2. Follow all applicable local and national electrical and safety codes.

3. Install the device in an electrical enclosure (panel or junction box) or in a limited access electrical room.

4. Verify that circuit voltages and currents are within the proper range for the DINgate module.

5. Ensure that the DINgate is placed behind fuses or circuit breakers.

6. Equipment must be disconnected from the HAZARDOUS LIVE voltages before access.

7. Before applying power, check that all the wires are securely installed by tugging on each wire.

8. Do not install the DINgate module where it may be exposed to temperatures below –20°C or above 70°C,

excessive moisture, dust, salt spray, or other contamination. The device requires an environment no worse

than pollution degree 2 (normally only non-conductive pollution; occasionally, a temporary conductivity

caused by condensation must be expected).

9. Do not drill mounting holes in the device. Click the module on a DIN Rail instead.

10. If the DINgate device is installed incorrectly, the safety protections may be impaired.

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 7 of 16

2Technical description

The Xemex DINgate DSO device is a communication gateway with a Modbus Interface and an optical interface to

connect an ABB B21 of B23 E-meter.

It has following interfaces:

•Main power connection 230V

•RS485 / Modbus RTU Communication Interface

•Optical Interface

•User Interface - LEDs

•SIM card slot (for 2FF SIMs)

•LTE antenna connection (SMA)

The DINgate DSO module reads out the ABB B21 or B23 E-meter every 10 seconds and logs the data. Data can be

readout using the DLMS protocol via a TCP/IP connection over LTE.

The DLMS object model uses the SMR5 specification as a reference. Extra OBIS objects are added to provide LTE

connection settings and diagnostics. For these extra objects, the ESMR specification is used as reference.

The combination DINgate DSO + ABB E-meter can be seen as a compact version of the Dutch smart meter.

LTE antenna connection

RS485 / Modbus RTU

Interface

Mains power

connection 230V

User Interface - LEDs

SIM card slot

IR Interface

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 8 of 16

3Technical specifications

3.1 Mains power connection

DANGER

Working with high voltages is a potential danger to life. Persons exposed to high voltages can

suffer cardiac arrest, burns or other serious injuries. To avoid such accidents, make sure to

disconnect the power supply before starting the installation.

Nominal Voltage: 230 Vac

Voltage range: 220-240 Vac +/-10%

Frequency: 50 or 60 Hz

I nom: 10 mA

Connector: 2-pole screw terminal connector

Terminal wire: Solid wire / 0.2 –6 mm2

Stranded wire / 0.2 –4 mm2

Max torque: 0.6 Nm

Wire stripping: 7 mm

3.2 RS485 / Modbus RTU Interface

3.2.1 Physical Interface

Connector: Screw terminal connector for A, B and Shield

Terminal wire: 0.2 -1.5 mm2

Wire stripping length: 5 –6 mm

Max torque: 0.2 Nm

Max cable length: 30 meter

Cable location: indoor

3.2.2 Protocol Description

Protocol: Modbus RTU master over RS485

Modbus address default value = 1

Baud rate: 1200 ... 115200

default value = 19200 baud

Line setting: 8N1 (line settings register value = 0x04) , 8E1 (line settings register value = 0x24)

default value = 8E1

3.3 IR Interface

Optical interface to connect to ABB meter without wire connection.

Is an alternative for the RS485 Modbus connection between DINgate DSO and the ABB E-meter.

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 9 of 16

3.4 User Interface - LEDs

Power / Modbus indicator: Red LED

WAN indicator: Green LED

(See operating instruction 5.1 and 5.2 for functional explanation of the LEDs.)

3.5 SIM card slot

SIM card type: mini SIM (2FF) 25 x 15 mm

SIM Insert / extract: push / push

3.6 LTE antenna connection

The DINgate DSO is equipped with an LTE Cat-1 modem with GPRS fallback (DINgate DSO 1.0) or an LTE Cat-M

modem (DINgate DSO 1.1) functionality.

The supported frequency bands are:

3.6.1 DINgate DSO 1.0

-LTE Cat-1: B1, B3, B7, B8, B20

-GPRS: 900/1800 MHz

-Connector type on DINgate: SMA Female

3.6.2 DINgate DSO 1.1

-LTE-M: B3 (1800MHz) / B8 (900MHz) / B20 (800MHz)

-Connector type on DINgate: SMA Female

3.7 Enclosure

DIN rail mount: DIN 43880 / 2 units

Dimensions: 90 x 36 x 65 mm

Weight: 106 gr

Material: PA66-FR

3.8 Environmental conditions

Protection class II

Operating temperature -20 °C - +70 °C

Storage temperature -40 °C - +70 °C

Relative humidity < 75 % year’s average at 21 °C

< 95 % less than 30 days/year, at 25 °C

Pollution Degree 2

Altitude < 2000m

Application area Residential, Indoors in suitable meter cabinet

3.9 Standards

Safety: IEC 60950-1

Radiated emission: EN 55016-3-2

Conducted emission: EN 55016-2-1

Harmonic current emission: EN 61000-3-2

Voltage changes, fluctuations & flicker: EN 61000-3-3

Electrostatic discharge: EN 61000-4-2

RF immunity: EN 61000-4-3

Electrical fast transient: EN 61000-4-4

Surges: EN 61000-4-5

User Manual - DINgate DSO

01 October 2021 XEMEX Confidential Page 10 of 16

RF common mode: EN 61000-4-6

Voltage dips: EN 61000-4-11

Inhaltsverzeichnis

Andere XEMEX Steuereinheit Handbücher

XEMEX

XEMEX SUNGATE WatchTalk Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung