Insert the battery into the quadcopter, open
the door and slide the battery into the
battery holder. Connect the battery up, close
the battery compartment door and place the
quadcopter on a flat level surface. The X260
LED’s will flash fast and then slow to a blink
to show the quadcopter is ready bind to the
handset.
Make sure the throttle control stick is
positioned downwards and then turn on the
transmitter.
The Transmitter will make a constant
beeping while it is binding to the X260. Once
bound the transmitter will stop beeping and
the X260 LED’s will change from flashing to
solid to show the quadcopter is bound and
ready to fly.
After any flight the battery should be
disconnected and removed from the
quadcopter. This should be a post flight
habit to avoid any unforeseeable problems.
Warning: If the LiPo battery is left connected
in the quadcopter for long periods if may
become damaged due to over-discharge or
even become a potential fire hazard.
After flight and removal of the battery turn off
the transmitter. If the transmitter is not going
to be used for a long time you should
remove and store the batteries.
Warning: If the AA batteries are left in the
transmitter for extended periods of time
potential leakage could occur which may
damage the transmitter and also create a
fire hazard.
Binding of Radio
