Yamaha Electone STAGEA ELB-01 Bedienungsanleitung

ELB-01 Assembly Instructions 1

ELB-01 Assembly Instructions

Carefully read these instructions BEFORE assembling the Electone.

Open the package, take out the two styrofoam pads from the both sides of the package, and carefully

place the main unit on top of the pads as shown.

Take care not to pinch AC power cord plug between the pads and Main unit.

Take out all parts from the package.

Please conﬁrm that all parts shown in the illustration are provided.

When you take out the Speaker Unit, always hold the bottom of the Speaker Unit, not holding the Grill Net.

Be careful not to confuse any of the parts, and be sure to install all parts in the correct direction by following the

procedures given below.

Be sure to assemble the Electone with two or more people.

Don’t use any screws other than the ones speciﬁed and included in this package. Use of incorrect screws can cause

damage and malfunction.

Be sure to tighten all screws upon completing assembly.

Make sure to perform all assembly operations on a ﬂat surface.

To disassemble, reverse the procedures.

You need a Phillips (+) screwdriver to assemble the Electone.

Long screws (ø6 X 25 mm): 4 pcs.

Short screws (ø5 X 12 mm): 8 pcs.

Screw caps: 4 pcs.

Bench Board

Bench

Legs: 4 pcs.

Pedalboard cord clamps: 2 pcs.

Main Unit

Music Rest

Pedalboard Unit

Sideboard

(Left)

Sideboard

(Right)

Speaker

Unit

Grill Net

Attached to the Speaker Unit

Styrofoam pads

Take out the styrofoam pads, and

place the Main Unit on top of the pads.

Dust Cover

ELB-01 Assembly Instructions

Mount the Sideboards onto the Pedalboard

unit.

Be sure not to confuse the Right and Left

Sideboards.

3-1 Raise the Pedalboard as shown in the illustration

below.

3-2 Position each screw hole on both the Pedalboard

and Sideboards as shown in the illustration and

mount the Sideboards onto the Pedalboard using

the 4 short screws (2 screws on each Sideboard).

3-3 Stand the Pedalboard after securing the screws.

Mount the Speaker Unit onto the Sideboards.

4-1 Remove the Grill Net from the Speaker Unit.

4-2 With the help of another person, hold the Speaker

unit horizontally, and slide it from the rear into

place along the brackets.

Take care not to drop the Speaker unit or to pinch your

ﬁnger(s) between the Speaker unit and Sideboard.

4-3 While holding the Sideboard(s) to the Speaker

unit, fasten the four short screws from the rear, to

secure the Speaker unit to the Sideboards. Cover

the four screw holes on the rear side with the

corresponding screw caps.

Mount the Main Unit.

5-1 As shown in the illustration, hold the Main unit

horizontally (with two people), and place it on the

front side of the Speaker unit so that the arm at the

bottom of the Main unit comes in front of the

Sideboards, then slide it to the rear side.

Take care not to drop the Main unit or to pinch your

ﬁnger(s) between the Speaker unit and Main unit.

Push the Sideboard

toward the Pedalboard

Short/black screws

Screw caps

Short screws

Push the Sideboard

toward the Speaker unit Push the Sideboard

toward the Speaker unit

Short

screws

1. Place down so that

the arm comes in

front of the Sideboard

Arm

2. Slide to the rear side

ELB-01 Assembly Instructions 3

5-2 Use the four long screws to fasten the Main unit to

the Sideboards as shown in the illustration.

Fit the Grill Net onto the Speaker.

First, align the net with the bottom line, then

secure it to the speaker assembly.

Connect the Pedalboard cord and Speaker

cord to the Main Unit.

Make sure that the latches on each plug of the

cords face toward you, and connect them to each

socket securely.

Fix the Pedalboard cord to the Sideboard

using the Pedalboard cord clamps.

8-1 Afﬁx the two Pedalboard cord clamps to the rear

side of the Speaker unit and the lower inside of the

Left Sideboard as shown in the illustration.

8-2 Insert the Pedalboard cord in the clamps.

Long screw

Fasten the Grill Net by

inserting the knobs

into the holes.

Speaker cord Pedalboard cord

Shut the clamp

after inserting

the cord.

ELB-01 Assembly Instructions

Place the music rest on the Electone.

Turn on the Electone’s power switch and

conﬁrm that the Electone can be played, and

that the assembly is successful.

BENCH ASSEMBLY

Turn the bench board over and put the legs in place,

one by one, at the corners of the bench board, then

tighten each nut using the included wrench. Be sure

to put the washer between each leg and nut as

shown.

Leg

Bench

board

Nut

Washer

After completing the assembly, please check

the following items.

• Are there any parts left over?

→Review all assembly procedures.

• Is the Electone clear of doors and other movable

ﬁxtures?

→Move the Electone to an appropriate location.

• Does the Electone make a rattling noise when

you shake it?

→Tighten all screws.

• Can the Electone be turned on?

→Conﬁrm that the AC power cord plug is securely

connected to an appropriate power outlet.

• Does the Electone produce sounds?

→Conﬁrm that the Speaker cord plug and the Pedalboard

cord plug are securely connected to each socket on the Main

unit.

If the Electone creaks or is otherwise unsteady when

you play on the keyboard, refer to the assembly

instructions and tighten all screws again.

U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation

WF43900 510MWAP3.3-01A0

Printed in China

Andere Handbücher für Electone STAGEA ELB-01

Andere Yamaha Musikinstrument Handbücher

Yamaha

Yamaha Electric Acoustic Guitar Bedienungsanleitung

Yamaha

Yamaha Clavinova CVP-202 Bedienungsanleitung

Yamaha

Yamaha YDP-123 Kurzanleitung

Yamaha

Yamaha Clavinova CLP-555 Bedienungsanleitung

Yamaha

Yamaha Clavinova CVP-301 Bedienungsanleitung

Yamaha

Yamaha TP65 Bedienungsanleitung

Yamaha

Yamaha YPR-7 Bedienungsanleitung

Yamaha

Yamaha YCL-631 Bedienungsanleitung

Yamaha

Yamaha Clavinova CLP-500 Bedienungsanleitung

Yamaha

Yamaha AW2400 Bedienungsanleitung

Yamaha

Yamaha J-5000 Bedienungsanleitung

Yamaha

Yamaha Disklavier Mark II XG Series Bedienungsanleitung

Yamaha

Yamaha PSR-SX900 Bedienungsanleitung

Yamaha

Yamaha Electone EL-25 Bedienungsanleitung

Yamaha

Yamaha Clavinova CLP-153SG Bedienungsanleitung

Yamaha

Yamaha Electric Grand CP-80 Bedienungsanleitung

Yamaha

Yamaha Pacifica 112V Bedienungsanleitung

Yamaha

Yamaha Clavinova CVP-83S Bedienungsanleitung

Yamaha

Yamaha P-515 Bedienungsanleitung

Yamaha

Yamaha PortaSound VSS-100 Bedienungsanleitung

Yamaha

Yamaha AVANTGRAND N2 Bedienungsanleitung

Yamaha

Yamaha PSR-I500 Bedienungsanleitung

Yamaha

Yamaha PF-1500 Bedienungsanleitung

Yamaha

Yamaha System65 Bedienungsanleitung

Beliebte Musikinstrument Handbücher anderer Marken

Kawai

Kawai CN17 Bedienungsanleitung

Korg

Korg SP-170S Bedienungsanleitung

Roland

Roland ep-97 Bedienungsanleitung

Roland

Roland LX-15 Bedienungsanleitung

Johannus

Johannus Rembrandt 200 Bedienungsanleitung

Casio

Casio celviano ap-700 Bedienungsanleitung

Modulus

Modulus Quantum Series Bedienungsanleitung

Gear4music

Gear4music SDP-4 Bedienungsanleitung

HOMCOM

HOMCOM 390-006 Bedienungsanleitung

Xotic Guitars

Xotic Guitars ProVintage Series Bedienungsanleitung

Sadowsky

Sadowsky MetroLine Series Bedienungsanleitung

Bosendorfer

Bosendorfer CEUS Bedienungsanleitung

Gewa

Gewa UP 260 G Bedienungsanleitung

Casio

Casio TONEBANK MT-750 Bedienungsanleitung

Alesis

Alesis AHB-1 Bedienungsanleitung

Roland

Roland V-Accordion FR-1x Bedienungsanleitung

Samick

Samick DCP-12 Bedienungsanleitung

thomann

thomann DP-50 Bedienungsanleitung