Yamaha NS-M225 Bedienungsanleitung
DeutschFrançais EspañolEnglish
E-1
NS-M225
SPEAKER SYSTEM
Thank you for choosing a Yamaha speaker system.
Caution
■ Read the following before using these speakers:
• To assure the finest performance, please read
this manual carefully. Keep it in a safe place
for future reference.
• Install the speakers in a cool, dry, clean place
away from windows, heat sources, sources of
excessive vibration, dust, moisture and cold.
Avoid sources of humming (transformers,
motors). To prevent fire or electric shock, do
not expose the speakers to dripping or
splashing.
• To prevent the enclosure from warping or
discoloring, do not place the speakers where
they will be exposed to direct sunlight or
excessive humidity.
• Do not place the following objects on top of
the speakers:
1. Glass, china, etc.
If glass etc. falls by vibrations and breaks,
it may cause personal injury.
2. A burning candle etc.
If the candle falls by vibrations, it may
cause fire and personal injury.
3. A vessel with water in it
If the vessel falls by vibrations and water
spills, it may cause damage to the unit, and/
or you may get an electric shock.
• Do not place the speakers where foreign
objects such as water drips might fall. It might
cause a fire, damage to this unit, and/or
personal injury.
• Do not place the speakers where they are liable
to be knocked over or struck by falling objects.
Stable placement will also ensure better sound
performance.
• Secure placement or installation is the owner’s
responsibility. Yamaha shall not be liable for
any accident caused by improper placement or
installation of speakers.
• Any time you note distortion, reduce the
volume of your amplifier immediately. Make
sure the input power does not exceed the
specified maximum input power, otherwise the
speakers will be damaged.
• Do not attempt to clean the speakers with
chemical solvents as this might damage the
finish. Use a clean, dry cloth.
• Do not attempt to modify or fix the speakers.
Contact qualified Yamaha service personnel
when any service is needed. The cabinet
should never be opened for any reasons.
Note:
This speaker is magnetically shielded, but placing
them too close to a TV may impair the TV picture. If
this happens, move the speaker away from the TV.
Owner’s Manual
URG
E-2
Setting Up the Speakers
Place the speakers on a sturdy, vibration-free surface, such as a well-built stand.
■ Using the NS-M225 as Normal
Stereo Speakers
To get the best stereo performance, angle the
speakers inward so as to create a triangle, with the
listener at the apex.
■ Using the NS-M225 as Front
Speakers in a Surround Sound
System
Position the speakers both side of your TV. The
positioning of these speakers is important because
they provide a solid anchor for the sound image.
They should be positioned facing the listener at
about ear level, and equidistant from the TV.
■ Using the NS-M225 as surround
speakers in a surround sound
system
The speakers can be mounted on a wall by using
the bracket attached to the speakers’ back panels.
Subwoofer
Center
NS-M225
Surround L
Surround R
Holes
Make sure that the screws are caught by a
narrow part of the holes securely.
26 mm
(1”)
E-3
English
Fasten screws into a firm wall or wall support as
shown in the figure below, and hang the holes on
the protruding screws.
WARNING:
• Each speaker weights 2.4 kg (5.3 lbs). Do not
mount them on thin plywood or soft wall
surface material, as the screws may come out
of the flimsy surface, causing the speakers to
fall down and be damaged, or result in
personal injury.
• Do not fasten the speakers to wall with nails,
adhesives, or other unsound hardware. Long
term use and vibrations may cause them to fall
down.
• To avoid accidents resulting from tripping
over loose speaker cords, fix them to the wall.
Note:
You can also use the screw holes on the bottom of
the NS-M225 for installing the speakers on
commercially available speaker stands.
• Before installing, please refer to the instruction
manual of the speaker stand.
NS-M225
Wall or wall
support
Tapping screw
(commercially
available)
Diam. 3.5 to
4 mm
(1/8”)
3 mm
(1/8”)
Min.
20 mm
(3/4”)
A screw with a
diameter of 4 mm (1/8”)
can be used (Hole
depth: 13 mm, 1/2”)
60 mm
(2-3/8”)
E-4
Connecting Your Speakers
Always turn off your amplifier or receiver before making any connections.
■ Preparing Your Speaker Cables
Carefully remove 10 mm (3/8”)of insulation from
both ends of your speaker cables and twist the
bare wires tightly, as shown.
■ Hookup
■ Using a Banana Plug
1. Remove the speaker terminal cover by
gently pulling it toward you.
2. Tighten the terminal knob.
3. Simply insert the banana plug into the
terminal.
Notes:
• Make sure that the bare wires are not touching
each other as this could damage the speaker and
amplifier.
• Connect one speaker to the left terminals of your
amplifier, and another speaker to the right
terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
Good No Good
10 mm
(3/8”)
FRONT
OR
SURROUND
RL
+
–
NS-M225
Amplifier or
receiver
+
–
Loosen
Tighten
1
3
2
Banana Plug
Removing the front cover
The front cover is attached to protect the speaker
unit, but you can remove it if necessary.
The front cover is fixed by magnets. Hold the
speaker with one hand, and pull the front cover
gently with the other to remove it.
Specifications
Type
.......... 2-way acoustic suspension speaker system
magnetic shielding type
Driver......................8 cm (3.1 ”) cone woofer x 2
3 cm (1 ”) dome tweeter
Impedance ......................................................6 Ω
Frequency Response...................65 Hz to 50 kHz
Nominal Input Power .................................. 40 W
Maximum Input Power.............................. 120 W
Sensitivity................................... 86 dB/2.83 V/m
Crossover Frequency .................................. 3 kHz
Dimensions (W x H x D)
....... 107 (4.2”) x 360 (14.1”) x 133.7 (5.3”) mm
Weight ..........................................2.4 kg (5.3 lbs)
* Specifications are subject to change without
notice due to product improvements.
Notes:
• When removing the cover, be careful that you don’t
touch the drive units, and don’t exert excessive
force with any tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. after
removing it.
©2004 All rights reserved.
YAMAHA ELECTRONICS CORPORATION, USA
6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD.
135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H.
SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A.
RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE
YAMAHA ELECTRONICS (UK) LTD.
YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND
YAMAHA SCANDINAVIA A.B.
J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN
YAMAHA MUSIC AUSTRALIA PTY, LTD.
17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA
Printed in Indonesia WD69510-1
This product mainly uses lead-free solder.
Cet appareil utilise principalement de la soudure sans plomb.
Dieses Produkt verwendet hauptsächlich bleifreies Lot.
Este producto utiliza principalmente soldadura sin plomo.
Andere Handbücher für NS-M225
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Yamaha Lautsprechersystem Handbücher
Yamaha
Yamaha NS-P7900 Bedienungsanleitung
Yamaha
Yamaha SR-B20A Bedienungsanleitung
Yamaha
Yamaha SR-B30A Bedienungsanleitung
Yamaha
Yamaha ESB-1080 Bedienungsanleitung
Yamaha
Yamaha NS-M325 Bedienungsanleitung
Yamaha
Yamaha YAS 71 - Air-Surround XTREME Speaker Sys Bedienungsanleitung
Yamaha
Yamaha HS10W Bedienungsanleitung
Yamaha
Yamaha NS-P285 Bedienungsanleitung
Yamaha
Yamaha SRT-700 Bedienungsanleitung
Yamaha
Yamaha NS-10MM Bedienungsanleitung
Yamaha
Yamaha NS-AW1 Bedienungsanleitung
Yamaha
Yamaha NS-WSW121 Bedienungsanleitung
Yamaha
Yamaha YSP-4000 Bedienungsanleitung
Yamaha
Yamaha Digital Sound Projector YSP-900 Bedienungsanleitung
Yamaha
Yamaha YHT-300 Montageanleitung
Yamaha
Yamaha KMS-305 Bedienungsanleitung
Yamaha
Yamaha YHT495 Bedienungsanleitung
Yamaha
Yamaha NX-B55 Bedienungsanleitung
Yamaha
Yamaha ATS-B400 Bedienungsanleitung
Yamaha
Yamaha BR10 Montageanleitung
Beliebte Lautsprechersystem Handbücher anderer Marken
Sondpex
Sondpex Active Speaker System and Digital Music... Bedienungsanleitung
JVC
JVC NX-PN7 Bedienungsanleitung
Marshall Amplification
Marshall Amplification AR-DM61-BT Bedienungsanleitung
SE Audiotechnik
SE Audiotechnik I-LINE Bedienungsanleitung
Gemini
Gemini WRX-843 Series Bedienungsanleitung
TCL
TCL 6100 Series Bedienungsanleitung