Yamaha NS-AW570 - Left / Right CH Speakers Bedienungsanleitung

NS-AW570

OWNER’S MANUAL

CONTENTS

CONSUMER PRECAUTIONS

UNPACKING

ATTACHING THE GRILLE

MOUNTING THE SPEAKERS

CONNECTIONS TO YOUR AMPLIFIER

SETTING UP THE SPEAKERS

PAINTING THE SPEAKER CASING AND GRILLE (OPTIONAL)

SPECIFICATIONS

INDOOR / OUTDOOR SPEAKER SYSTEM

CONSUMER PRECAUTIONS

Read these precautions carefully before setting up your NS-AW570 speakers.

•When installing these speakers outdoors, try to minimize their exposure to rain and snow by mounting the

speaker in corners or under eaves.

•Since these speakers can be wall mounted, it is essential that they are firmly secured. Be sure to consult a

reliable source about the best type of hanger for your particular wall’s construction. Secure

installation is the purchaser’s responsibility.

•Do not attach them to thin plywood or soft wall surface materials as the screws may tear free, causing the

speakers to fall and be damaged, or result in personal injury.

•Do not fasten the speakers to walls with nails, adhesives, or other unsafe hardware. Long-term use and

vibrations may cause them to pull free.

•Do not place the speakers where they are liable to be knocked over or struck by falling objects. Stable

placement will also ensure better sound performance.

•Placing the speakers on the same stand or shelf as a turntable can result in feedback.

•Never touch the woofer or tweeter units with your hands or expose them to excessive physical shock. If they

are dented or bent, the sound will be distorted.

•Lower the power amplifier / receiver volume control before changing input sources. Never change input

sources (for example, FM to CD) at high listening levels. Always turn the receiver / amplifier unit off when

installing or removing input cables.

•Anytime you note distortion, reduce the volume control on your power amplifier / receiver to a lower setting.

Never allow your power amplifier to be driven into “clipping”.

•Do not attempt to clean the speakers with chemical solvents as this might damage the finish. To clean wipe

with a dry, soft cloth.

•Secure placement or installation is the owner’s responsibility.

YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers.

UNPACKING

After unpacking, inspect the contents to confirm the following items are contained:

Speakers x 2 Large bracket screws x 4

Screw for mega mounting plates x 2

Screw for base or for L-Bracket X 2

L-Bracket for safety chain x 2

Safety chain x 2

Protective Paint Cover x 2 Grill x 2 Bracket x 2

Glue Strips x 2

ATTACHING THE GRILLE

When you first remove the speakers from the box they will have protective paint covers attached. Please attach

the grilles to the speakers.

Note

These speakers are paintable. If you wish to paint the speakers, please do so before attaching the speaker

grilles. Refer to “PAINTING THE SPEAKER CASING AND GRILLE” on page 8 for more information on painting

the speakers.

Attaching the grilles

Remove the protective paint cover from the speaker cabinet.

Align the grille with the grooves on the cabinet, then carefully push the grille edges onto the speaker cabinet.

Note

We recommend you use the supplied glue to guarantee that the grille is attached firmly. Apply the glue to the

areas depicted in the diagram below at right.

CAUTION

The aluminum grilles are easy to bend out of shape. Please be careful when replacing the grille on the speaker,

using only the minimum amount of force necessary.

MOUNTING THE SPEAKERS

The speakers can be placed on a bookshelf or wall/ceiling mounted with optional speaker brackets using 1/4 x

20 screws to fasten the optional bracket into the threaded inserts located on the back of the speakers. To wall /

ceiling mount the speakers, use the supplied mounting bracket. (see below)

Glue strips

*Secure to wall or ceiling

Large bracket screws

Eaves

OUTDOOR NOTE :

The supplied mounting

brackets allow the

speakers to be

mounted in corners or

under eaves to

minimize their exposure

to rain or snow.

Included mounting

bracket

Glue strips

1. Use the bracket as a template mark the locations of the key hole slots on the mounting area.

2. Next, using appropriate hardware (not included) securely fasten the bracket to the wall/ceiling.

3. Position the speaker in the bracket and secure the speaker by using the two large bracket screws included.

(see above)



If the mega mounting plate is already installed on the outside wall, the speaker can also be mounted using the

following procedure:

Wall

*Secure to wall or ceiling

Screw

Mega mounting plate

Included mounting bracket

Large bracket screws

CAUTION

Be sure to consult a reliable source for the best type of fasteners for your particular wall / ceiling construction.

Secure installation is the purchaser’s responsibility.

When using speaker brackets to mount the speaker on a wall, please use safety wire between the speaker and

the bracket to prevent the speaker from falling.

Insert the clasp of the safety wire through the bracket and loop.

Attach the L-bracket to the speaker with screw.





CONNECTIONS TO YOUR AMPLIFIER

Before making connections, make sure that the amplifier is switched off.

Loosen

Tighten

Red(+)

Black(-)

Speaker output

terminals of the

amplifier Banana plug

CONNECTIONS

•Connect the screw-type input terminals at the

rear of the speakers to the speaker output

terminals of the amplifier (or receiver) with the

speaker cables.

•One side of the speaker cable is red and the

other side is black. Connect the (+) terminals

on the amplifier (or receiver) and speakers

using the red side. Connect the (-) terminals on

both components using the black side of

the cable.

•Connect each speaker making sure not to

reverse the polarity (+,-). If the speaker is

connected with reversed polarity. The sound

will be unnatural and lack bass.

How to Connect:

Loosen the knob.

Insert the bare wire. [Remove the insulation

coating at the extremity of each speaker cable

by twisting the coating off.]

Tighten the knob and secure the cable.

Test the firmness of the connection by pulling

lightly on the cable at the terminal.

Note

Do not let the bare speaker wires touch each

other as this could damage the speaker or

amplifier, or both.

When using a banana plug

Tighten the terminal knob.

Insert the banana plug into the terminal.

INDOOR PLACEMENT

You can use these speakers as front or surround speakers.

—Front speaker placement should be separated by a distance of 6–10ft. If they are placed too close together,

there will be a reduction in the stereo effect. Conversely, If placed too far apart, the so called “middle-

omission” effect will occur and the vocal center fill will be lost. Height of the speaker should beat least

at ear level.

—Center channel speaker should be placed centered above or below the TV.

—Surround speakers should ideally be placed behind the listening area, At least as far apart as the front

speakers and up to 2 additional feet apart per side. The height of the speaker should be at a minimum of ear

level or preferably somewhat higher.

OUTDOOR PLACEMENT

Your speaker system has water-resistant enclosures that protect the speakers form the elements when mounted

outdoors. These speakers are designed with a wide dispersion pattern which means you will get good sound

quality over a large listening area. (100 ft2to approximately 400 ft2). Please note: if the listening area is too large,

and the speakers are positioned too far apart, “middle-omission” effect (lack of sound in an area between the

speakers) will occur and/or “hot spots” (loud sound near the speaker) will develop.

Try to place the speakers between 6’–10’ apart for good stereo listening. It is suggested for larger areas (over

400 ft2to about 600 ft2) two pairs of speakers be used, see below.

Note

•1 pair of speakers should be used for every 200–400 ft.

•We recommend that you install this speaker vertically, as it is designed to ensure a wide listening area

in this orientation.

Center channel Speaker

Left front Speaker Right front Speaker

6–10 feet

up to approx

2 feet more

up to approx

2 feet more

LISTENING AREA

rekaepSdnuorruSthgiRrekaepSdnuorruStfeL

SETTING UP THE SPEAKERS

We have selected a speaker finish designed to blend well with almost any surroundings. However you can also

paint them to obtain the perfect finish for a specific environment. Use high quality paint and select a well

ventilated area before proceeding. If you are not sure what paint will be most suitable, consult a paint store

professional or painter before purchase.

You will need

•A spray can of primer paint (Not necessary if you use plastic paint that does not require primer)

•A spray can of paint in the color of your choice. Be sure to choose a grade of paint appropriate for the

environment in which you wish to use the speaker. For example, use exterior-grade paint if you wish to use the

speakers outdoors.

•A paper clip or other similar small slim device for removing the speaker grille

•Provided protective paint covers

•2 clean cloths, one damp and one dry

•Masking tape

Preparation

1. Remove the speaker from the speaker bracket (if the speaker is mounted in a speaker bracket).

2. Remove the grille from the loudspeaker (If they are attached).

Removing the grille: Use a bent paper clip or other object with a hard tapered

point inserted into the areas above and below the grille as indicated on the

diagram to lift the four corners of the grille away from the speaker.

3. Using the damp cloth, wipe all surfaces of the speaker cabinet and grille clean.

Do not touch the surface of the speaker baffle. Make sure that everything is dry

before moving proceeding further.

4. Use masking tape to carefully mask off the screw-type input terminals at the

rear of the speaker, and also to cover the the Yamaha logos on the grille.

5. Use the protective paint covers provided to carefully cover the speaker baffle.

PAINTING THE SPEAKER CASING AND GRILLE (OPTIONAL)

Painting the cabinet

1. Apply one coat of primer to the speaker cabinet. You do not need to apply primer if you use “PAINT FOR

PLASTIC” or “DIRECT-TO-PLASTIC” plastic paint marked “NO PRIMER NEEDED”.

2. Allow the first coat of primer to dry completely.

3. Apply a second coat of primer.

4. Allow the second coat of primer to dry completely.

5. Apply the finish color.

6. Allow the paint to dry completely.

7. Carefully remove all masking material.

Painting the grille

1, Apply the finish color to the grille, making sure that the grille holes remain free of paint. Clogging the grille

holes may diminish the sound quality. You do not need to apply any primer.

2. Allow the paint to dry completely.

3. Remount the grille on the speaker.

CAUTION

The aluminum grilles are easy to bend out of shape. Please be careful when replacing the grille on the speaker,

using only the minimum amount of force necessary.

Type 2-way Acoustic Suspension

Speaker

Woofer 6-1/2” High Compliance P.P Mica Filled Cone and Rubber Surround

Tweeter 1” PEI Dome x 2

Frequency Range 60 Hz to 30,000 Hz

Impedance 6 ohms

Nominal Input 40 W

Maximum Input 120 W

Sensitivity (dB/2.83v. 1m) 87 dB

Dimension (H x W x D) 7-7/16” x 10-1/4” x 6-25/32” (188.67 x 260.12 x 172 mm)

Weight 5.07 lbs (2.3 kg)

Magnetic Shielding No

*Specifications subject to change without notice due to product improvements.

SPECIFICATIONS

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Yamaha Sprecher Handbücher

Yamaha

Yamaha Stagepas 300 Bedienungsanleitung

Yamaha

Yamaha VXS8W Bedienungsanleitung

Yamaha

Yamaha NS-C210BL - Bass-Reflex Center Speaker Bedienungsanleitung

Yamaha

Yamaha TRS-MS04 Bedienungsanleitung

Yamaha

Yamaha MSP3 - Speaker - 20 Watt Bedienungsanleitung

Yamaha

Yamaha YSTMS50B Bedienungsanleitung

Yamaha

Yamaha ST15 Bedienungsanleitung

Yamaha

Yamaha PS 110 Bedienungsanleitung

Yamaha

Yamaha 75B Bedienungsanleitung

Yamaha

Yamaha Electone HS-8 Bedienungsanleitung

Yamaha

Yamaha MSP5 - Speaker - 67 Watt Bedienungsanleitung

Yamaha

Yamaha YSP-5600 Bedienungsanleitung

Yamaha

Yamaha YSTMS50B Bedienungsanleitung

Yamaha

Yamaha DXR15 Bedienungs- und Wartungshandbuch

Yamaha

Yamaha NS-F210BL - Bass-Reflex Floorstanding... Bedienungsanleitung

Yamaha

Yamaha STAGEPAS 500 Bedienungsanleitung

Yamaha

Yamaha PJP-10UR Bedienungsanleitung

Yamaha

Yamaha NS-F901 Bedienungsanleitung

Yamaha

Yamaha MS100DR Bedienungsanleitung

Yamaha

Yamaha PJP-50USB Bedienungsanleitung

Yamaha

Yamaha YSP 1100 - Digital Sound Projector Five CH... Betriebsanleitung

Yamaha

Yamaha F12 Bedienungsanleitung

Yamaha

Yamaha NS-F150 Bedienungsanleitung

Yamaha

Yamaha MS40DR Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung