REGULATORY AND REGISTRATION INFORMATION
Warning -This equipment has been certified to comply with the limits for a Class Bcomputing device, pursuant to
Subpart J of Part 15 of FCC Rules. Only computers certified to comply with the Class B limits may be attached to this
equipment. Operation with non-certified computers is likely to result in interference to radio and
TV
reception. This
equipment uses radio frequency energy for its operation and if not installed and used properly, that is, in strict
accordance with the instruction manual, may cause interference to radio and television reception. It has been type
tested and found to comply with the
RF
emission limits for a Class B computing device which is intended to provide
reasonable protection against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more ofthe following measures:
• Move the computing device away from the receiver being interfered with.
• Relocate (turn) the computing device with respect to the receiver.
• Reorient the radio or television receiving antenna.
• Plug the computing device into a different AC outlet so that the computing device and receiver are on different
branch circuits.
• Disconnect and remove any
1/
0 cables that are not being used. (Unterminated 1/0 cables are a potential source of
high RF emission levels.)
• Unplug and remove any circuit boardsthat are notbeing used. (Here again,unterminatedcards can be a sourceof
potenti
al
interference.)
• Be certain that the computing device is plugged into grounded outlet receptacles. (Avoid using A/C cheater plugs.
Lifting ofthe powercord ground may increase RF emission levels and mayalso presenta lethal shock hazardto the
user.)
If you need additional help, consult your dealer or ask for assistance from the manufacturer. Customer service in-
formation maybefound on the inside backcover ofthis manual oron an insertsheet supplied with the equipment. You
mayalso find the followi
ng
booklethelpful: "Howto Identify and Resolve Radio-TV Interference Problems
."
This book-
let is available from the US Government Printing Office, Washington, D.C. 20402 -Stock No. 004-000-000345-4.
ZENITH ENGINEERING
The device has been designed and manufactured to comply with all applicable rules and regulations of the followi
ng
agencies:
Underwriters Laboratories
Canadian Standards Association
Federal Communications Commission -Part 15, Radio Frequency Interference
Anyattemptto alteror modifythedesign,orto use this device in a mannerotherthan described in the Manual,will void
the Warranty and release the manufacturer from any responsibility for its operation.
REGISTRATION
To receive thefull benefits ofyourWarranty,complete and mail the accompanying Registration Card. Also,record the
series and serial number of your equipment below. Refer to these numbers in any correspondence you have with
Zenith Data Systems regarding this equipment.
Series
____________________________________
_
Serial#
____________
________
________________
_
Date Purchased
_________________________________
_
