Zenith A13P01D Bedienungsanleitung
machine numbers H13P01L A13P01D
operating guide / warranty
Thanks for
choosing Zenith!
hookup directory
index
your on-screen menus
page 20
page 11
page 3
RECORD YOUR MODEL NUMBER
(Now, while you can see it)
The model and serial number of your new TV are located
on the back of the TV cabinet. For your future convenience,
we suggest that your record these numbers here:
MODEL NO.____________________________________
SERIAL NO.____________________________________
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence
of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
POWER CORD POLARIZATION:
CAUTION: To Prevent Electric Shock, Match wide blade of plug to wide slot, fully insert.
ATTENTION: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne
correspondante de la prise et pousser jusqu’au fond.
NOTE TO CABLE/TV INSTALLER:
This reminder is provided to call the cable TV system installer’s attention to Article 820-40 of the National Electric Code
(U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the point of the cable entry as practical.
REGULATORY INFORMATION:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures: •Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Do not attempt to modify this product in any way without written authorization from Zenith Electronics Corporation.
Unauthorized modification could void the user’s authority to operate this product.
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
3369-o
INSTALLATION GETTING STARTED PAGE 3
This page will
direct you to
which page
to go to for
proper hook-
up of your
Entertainment
Machine.
Hook-Up Directory
IMPORTANT!!
Use this page to decide where you need to begin your setup. First, find the line
below that best describes what you want to do, then go to that page number.
Note: Design and specifications are subject to change without prior notice.
Cable TV
wall jack
Cable box
In
Out
Cable TV
wall jack
Cable box
In
Out
If you are using an antenna and no other equipment, go to . . . . . . . . . . . . . . . . . . page 4
If you have cable and no other equipment, go to . . . . . . . . . . . . . . . . . . . . . . . . . page 5
If you are using an antenna and have a VCR, go to . . . . . . . . . . . . . . . . . . . . . . . page 6
If you have cable and a VCR, go to . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7
Antenna only
Cable only
Antenna with VCR
Cable and VCR
Hook up your Entertainment
Machine, see diagrams at right.
Plug in your TV. Do not plug it
into a switched outlet.
Go to page 8 to Auto Program
your Entertainment Machine.
3367-O
INSTALLATION STANDARDPAGE 4
Connect an
antenna
to your
Entertainment
Machine.
Hook Up Your Antenna to the TV
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300 TO 75 OHM ADAPTER A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an
inch long with two screws on one end and a round opening with a wire sticking out on the other end.
RF coaxial wire
(75ohm)
Antenna
Antenna
Flat wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV back panel
(expanded view)
Antenna
Typical TV back
Typical TV back
If you have a 75 ohm RF cable,
then you don’t need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
A 300 to 75 ohm adapter is not
included with your Zenith
Entertainment Machine.
120V
60Hz
1
2
3
Flat-Wire Antenna to Adapter
Round Antenna Wire
Hook up your Entertainment
Machine, see diagrams at right.
Plug in your TV. Do not plug it
into a switched outlet.
Go to page 8 to Auto Program
your Entertainment Machine.
3367-O
INSTALLATION STANDARD PAGE 5
Connect
cable to your
Entertainment
Machine.
Mini glossary
CABLE SERVICE The wire that supplies all your cable TV (CATV) stations.
Hook Up Your Cable (CATV) to the TV
Cable TV
wall jack
Cable TV
wall jack
Cable box
In
Out
RF coaxial wire (75ohm)
RF coaxial wire (75ohm)
3 4
output
switch
Antenna
Antenna
Typical TV back
Typical TV back
If you’re using a cable box, leave your
TV on channel 3 or 4 and use your
cable box to change channels.
Remember, when screwing RF cables
onto jacks, clockwise tightens, and
counterclockwise loosens.
If you’re using a cable box, Auto-
Program (page 8) might only find the
channel your cable service is on
(usually channel 3 or 4). Don’t worry,
that’s all you need!
1
2
3
Without Cable Box
With Cable Box
120V
60Hz
Hook up your Entertainment
Machine, see diagrams at right.
Plug in your TV. Do not plug it
into a switched outlet.
Go to page 8 to Auto Program
your Entertainment Machine.
Flat wire
(300ohm)
Antenna
300/75 ohm
Adapter
Cables not included with TV
Over-the-Air
Antenna
In
Out
3 4
VCR back
VCR back AV panel
Output
switch
Typical
TV back
In
Out
3 4
VCR back
VCR back AV panel
Output
switch
Typical
TV back
3369-o
INSTALLATION STANDARDPAGE 6
Connect your
off-air
antenna and
VCR to your
Entertainment
Machine.
Hook Up Antenna and VCR to the TV
Remember, when screwing
RF cables onto jacks, clockwise
tightens, and counterclockwise
loosens.
1
2
3
Flat-Wire Antenna to Adapter
Round Cable to VCR
120V
60Hz
Hook up your Entertainment
Machine, see diagrams at right.
Plug in your TV. Do not plug it
into a switched outlet.
Go to page 8 to Auto Program
your Entertainment Machine.
Cable TV
wall jack
Cable TV
wall jack
Round wire (75ohm)
Round wire (75ohm)
Cable box
In
Out 3 4
output
switch
In
Out
3 4
VCR back
VCR back AV panel
Output
switch
Typical
TV back
In
Out
3 4
VCR back
VCR back AV panel
Output
switch
Typical
TV back
3369-o
INSTALLATION STANDARD PAGE 7
Connect
your VCR and
Cable to your
Entertainment
Machine.
Hook Up Your Cable (CATV) and VCR
Leave your VCR and your television
tuned to channel three and use
the cable box to change channels.
Remember, when screwing in RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
1
2
3
Cable Service
Cable Service with a Cable Box
120V
60Hz
3367-O
OPERATION CHANNEL SEARCHPAGE 8
Use Auto
Program to
automatically
find and
store the
channels
available in
your area.
Auto Program
Press MENU repeatedly until the
Setup Menu appears.
Using the UP/DOWN (CHANNEL,
SELECT) arrows, select Auto
Program.
Press the RIGHT (VOLUME,
ADJUST) arrow to access the Auto
Program Menu.
Using the UP/DOWN (CHANNEL,
SELECT) arrows, select Off Air
Antenna, or Cable TV if you sub-
scribe to cable service
Press the RIGHT VOLUME, ADJUST
arrow to begin the channel
search.
Press ENTER to return to
TV viewing.
1
2
3
4
5
6
Mini glossary
AUTOPROGRAM Auto Program is how your Entertainment Machine finds all the channels available in your area and stores them into memory.
Typical TV Front Panel Controls
16
ENTER MENU VOL
ADJ
CH
SEL POWER
ENTER MENU VOL
ADJ
CH
SEL POWER
3/5 2/4
3367-o
OPERATION FRONT PANEL CONTROLS PAGE 9
Front Panel Controls
Press MENU repeatedly to access
either the Setup or Video menu.
Choose the function you wish to
change using the CH Up/Down
buttons. The Channel buttons act
as a “Select” (Up/Down) func-
tion.
The VOLUME buttons act as an
“adjustment” (Left/Right) func-
tion. Use the VOLUME buttons to
make changes or adjustments.
Press ENTER to remove menus.
Menus disappear after five seconds.
To get them back, push the MENU
button again. Your front panel
may differ from this one but its
functions are the same.
1
2
3
When using the on-screen menus, the buttons on
the front panel correspond are as follows:
VOLUME = Adjust Up/Down
CHANNEL = Select Up/Down
Press POWER to turn TV on/off.
How to use
your front
button panel
to operate
the menus.
ENTER MENU VOL
ADJ
CH
SEL POWER
ENTER MENU VOL
ADJ
CH
SEL POWER
13
Typical TV Front Panel Controls
2
4
4
3367-O
Introducing
you to the
basics of your
Entertainment
Machine.
Basic Television Operation
OPERATION TV FUNDAMENTALSPAGE 10
Basic Operation
You’ll have to use the Channel Down/Up buttons to access it. Pressing
the ENTER key will show the Channel/Time display; the currently select-
ed channel and the time set on the Clock.
CHANNEL DOWN/UP buttons: Use to change the channels. Auto Program
will have found all channels available to you.
VOLUME Down/Up buttons: To adjust the volume level, use the volume
Down/Up buttons.
Channel/Time
Channel Changing
Audio
CH 12
10:55
Channel
Time
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Zenith Fernseher Handbücher
Zenith
Zenith System 3 Z36X31 Bedienungs- und Wartungshandbuch
Zenith
Zenith Z27H96 Bedienungs- und Wartungshandbuch
Zenith
Zenith C32C84R Series Bedienungs- und Wartungshandbuch
Zenith
Zenith SM3589BT Bedienungs- und Wartungshandbuch
Zenith
Zenith 19M20 Bedienungsanleitung
Zenith
Zenith L17W36DVD Bedienungsanleitung
Zenith
Zenith H27F56DT Installationsanleitung
Zenith
Zenith SENTRY 2 SM0953X Bedienungs- und Wartungshandbuch
Zenith
Zenith SR2786 Bedienungs- und Wartungshandbuch
Zenith
Zenith Concierge H19D34Y Bedienungs- und Wartungshandbuch
Zenith
Zenith SM2571BT Bedienungs- und Wartungshandbuch
Zenith
Zenith A60M91W9 Series Bedienungs- und Wartungshandbuch
Zenith
Zenith SR2745 Bedienungs- und Wartungshandbuch
Zenith
Zenith H27E55DT Bedienungsanleitung
Zenith
Zenith C27C41 Bedienungs- und Wartungshandbuch
Zenith
Zenith B19A23DC Bedienungsanleitung
Zenith
Zenith Z52SZ80 Bedienungsanleitung
Zenith
Zenith C27C35T Series Bedienungs- und Wartungshandbuch
Zenith
Zenith SENTRY 2 Z25A11 Bedienungs- und Wartungshandbuch
Zenith
Zenith Sentry 2 Series Bedienungs- und Wartungshandbuch
Beliebte Fernseher Handbücher anderer Marken
Philips
Philips Colour Television Bedienungsanleitung
Toshiba
Toshiba 27A10 Bedienungsanleitung
Philips
Philips 42PF9630A/37 Bedienungsanleitung
Hitachi
Hitachi 32FX48B Bedienungsanleitung
DAEWOO ELECTRONICS
DAEWOO ELECTRONICS DTQ-14V1FC Bedienungsanleitung
Changhong Electric
Changhong Electric uhd55b6000is Bedienungsanleitung
