ZyXEL Communications MAX308M Series Bedienungsanleitung

www.zyxel.com

Software v2.00

Edition 1, 1/2011

MAX308M Series

WiMAX Outdoor Gateway

DEFAULT LOGIN DETAILS

IP Address: http://192.168.1.1

Username: admin

Password: 1234

ZyXEL Communications Corporation

IDU and ODU

POE

SIGNAL

STRENGTH POWER

ETHERNET POWER

POE PORT

PORT

LED

CONNECT

LED FAULT

LED

ODU

RESET

BUTTON

IDU

LEDS

ENGLISH

Introduction

Welcome to the MAX308M Series which includes MAX308M and

MAX318M! This is a WiMAX subscriber station system comprised of an

outdoor unit (ODU) and an indoor unit (IDU).

The ODU such features as a high gain antenna and advanced IP

networking while the IDU provides power to it. It also provides

connectivity to the devices in your home or office at the same time.

How It Works

The ODU connects to the WiMAX network while the IDU is the

management point between the WiMAX network (via the ODU) and your

computer/local area network.

Firmware Caution: When your ISP upgrades your device’s

firmware, all of the LEDs will flash simultaneously. Do not

turn off or unplug the device until they stop blinking.

Package Content

You will also need:

• Another CAT5 8-wire Ethernet cable (not included) for connecting

the IDU and ODU

• One RJ-11 phone cable (not included) for connecting the IDU and

ODU

The WiMAX ODU The WiMAX IDU The Quick Start

Guide The Warranty Card

ZyXEL Support

Disc containing the

User’s Guide and

device drivers

AC Power Cord CableGlandBody,

Claw and Nut Mounting Kit

(Six M6 Nuts, One

Pole Bracket, One

U Bolt)

Grounding Kit (One

M3 Screw, One

Ground Cable)

One 1.8 meter long

CAT5 Ethernet

cableforconnecting

the IDU and your

computer

ENGLISH

Minimum System Requirements

• 64 MB RAM

• 20 MB of available hard disk space

• One available 10/100Mbps Ethernet port

• Internet Explorer 7, Firefox 2 and higher, or a compatible browser

Installing the Outdoor Unit

Before you begin, ensure that you are familiar with all safety

and accident prevention procedures necessary for working at

heights and with electricity.

Do NOT install the ODU during a lightning storm.

Choose a Location

The ODU can be mounted on a pole or antenna mast or on a wall using

the supplied bracket mount.

• Choose a mounting point that is sturdy enough to hold the ODU,

even during high winds.

• When choosing a location to install the ODU, remember that the

ODU’s front panel should point towards your service provider’s

nearest base station. If you are not sure where this is, consult your

service provider.

• You do not need to be able to see the base station from the ODU’s

position; there may be objects such as trees and buildings in the

way without signal loss. However, if you experience difficulties with

signal reception, a Line of Sight (LoS) connection may produce

better results.

• It is suggested that you transport the ODU to its intended

installation location in its original protective packaging.

Connecting the CAT5 Ethernet Cable

Lay the CAT5 Ethernet cable (not included) from your intended IDU

location to your intended ODU location.

• If you use cable extenders to cover a greater distance, signal

attenuation may result.

• If you intend to use cable ties or other methods to secure the cable,

do not tighten them yet. Leave the cable loose until you have

finished installing the IDU and ODU.

To connect the CAT5 Ethernet cable:

1. Separate the body, claw and nut pieces into their individual

components.

2. Feed one end of the CAT5 Ethernet cable through the nut.

ENGLISH

3. Open the claw then buckle it tightly to the cable.

4. Slip the body over the cable then connect the end of the cable to the

ODU.

5. Gently twist the body into the ODU behind the attached cable

connector.

6. Tightly secure the CAT5 Ethernet cable connector and the body and

claw with the nut.

Mount the ODU

See the installation instructions that came with your bracket mount for

information on mounting the ODU correctly.

To avoid the danger of rainwater entering the device, install the ODU

vertically (with a 90 degree angle to the ground).

Pole Mounting

You can install the WiMAX Modem vertically with a +15, 0, or -15 degree

angle relative to the pole. The connectors should be pointed down. The

following steps show you how to install it with a 0 degree angle.

+15o0o-15o

ENGLISH

7. For +15oand 0oangle installations, position the bracket with the +15o

mark on the top.

• Use the two holes (marked as A) for +15oangle installation.

• Use the two holes (marked as B) for 0oangle installation.

For -15oinstallation, position the bracket so the -15omark is on top.

8. Align two M6 nuts to the bottom two holes to attach the pole bracket

to the U blot on a pole or mast. Use a wrench to tighten the nuts with

the U blot.

9. Align the four edge holes on the mounting bracket with the screws on

the rear of the WiMAX Modem. Then use a wrench to tighten the four

nuts with the screws.

Grounding

Do the following steps for grounding the WiMAX Modem:

1. Use the M3 screw to secure the ground cable and the ground hole on

the WiMAX Modem’s rear panel as shown.

Inhaltsverzeichnis

Andere ZyXEL Communications Tor Handbücher

ZyXEL Communications

ZyXEL Communications ZyXEL ZyWALL 10W Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HN-Fx series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660H-T1 v3s Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications EMG2926-Q10A Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ADSL 2+ Security Gateway Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyWALL USG 2000 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications AMG1302-T series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660H-T Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications LTE3301 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HW Series Montageanleitung

ZyXEL Communications

ZyXEL Communications P873HNUP - Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HWP-D1 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications UAG50 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications MAX208M Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyXEL ZyWALL 2WE Montageanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL - CLI Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HN-F1A Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications VSG1432 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL USG 20 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-870HN-51B Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-662H Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-870HW-51A V2 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications EX5501-B0 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HW-DX V2 - V3.40 Bedienungsanleitung

Beliebte Tor Handbücher anderer Marken

LST

LST M500RFE-AS Bedienungsanleitung

Kinnex

Kinnex Media Gateway Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace 2N StarGate Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung

Telsey

Telsey CPVA 500 - SIP Bedienungsanleitung

RTA

RTA 460A-NNA4 Technisches Datenblatt

Shaw

Shaw Gateway HDPVR Bedienungsanleitung

ABB

ABB VSN900 Kurzanleitung

Commander

Commander Pulse Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Bedienungsanleitung

NETGEAR

NETGEAR C6300BD Bedienungsanleitung

Amit

Amit CDW531AM Bedienungsanleitung

HMS

HMS Netbiter EasyConnect EC150 Bedienungsanleitung

Huawei

Huawei EchoLife HG620 Bedienungsanleitung

AT&T

AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch

Logic IO

Logic IO RTCU MX2 turbo Bedienungsanleitung

Suttle

Suttle MediaMAX MXM-521 Bedienungsanleitung

RTA

RTA 460MCBC-N2E Technisches Datenblatt