5
Note: See the User’s Guide for the SHD1111’s advanced programming.
Installation
Before installing the SHD1111, you should add it to a Z-Wave network for
proper functions. See Adding to Z-Wave Network.
1. Detach the magnet from the SHD1111. The LED illuminates for 2
seconds to ensure that the SHD1111 and the magnet respond to
each other properly.
Note: Do not press the tamper switch on the back of the SHD1111 at this stage.
It is used for inclusion/exclusion to Z-Wave network.
2. Mount the back cover of the SHD1111 on the fixed part of the door/
window frame with the screws. Do not over tighten the screws as this
may damage the casing.
3. Fasten the SHD1111 to its back cover and secure it.
4. Use adhesive tapes or 19mm fixing screws to affix the magnet to the
moving part of the door/window opposite of the SHD1111. Make sure
the matching line on the magnet is aligned with the SHD1111 and at
the right direction as shown in the figure below.
Association 1. Have the Z-Wave Controller
enter association mode.
2. Press the tamper switch 3
times within 1.5 seconds to
enter association mode.
• The Z-Wave Controller will display whether the inclusion/exclusion of the
node ID has succeeded or failed.
• For the first 10 minutes after you install the batteries and include the
SHD1111 to your Z-Wave network, it can associate with the Z-Wave
Controller and other nodes automatically. After 10 minutes, you need to
follow the steps in the above table to enter association mode.
Function Description LED Indication
