4xem E200DNWV Bedienungsanleitung
..
User’smanual 1
IP Dome Cameras
UERS’ MANUAL
Before attempting to connect and use this dome camera, please read this
manual carefull
y,
and save this manual for the
p
ossible future use
the Hardware
..
User’smanual 2
CAUTION
This Class B digital apparatus meets all requirements of the
Canadian Interference Causing Equipment Regulations.
ATTENTION
Cet appareil numerique de laclasse B respects toutes les
exigencies du Reglement sur le materiel brouilleur du
Canada
Safety Information
Federal Communication Commission (FCC) Statement
Notice for customers in Canada
NOTE: This equipment has been tested and found to comply
with the limits of a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This device generates,
uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference,
the user is encouraged to try to correct the interference by on or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Correct the equipment into an output o a circuit different
from that to which the receiver is connected
Consult the dealer or an experienced radio / television
technician for help
FCC Caution: To assure continued compliance, any change
or modification not expressly approved by the
party responsible for compliance could void the
user’s authority to operate this equipment.
..
User’smanual 3
Preface
Congratulations to you for your purchasing of this world smallest
and compact IP dome camera. It is in light weight and high
performance. This camera is designed and manufactured to meet
surveillance and observation requirements of today’s and future’s
living standard.
This manual covers three versions of the speed dome in the
series. The main difference among them is the lens: standard,
day & night and vari-focus, which can be verified by visual.
These cameras, with high performance video server built in, can
pan for 360oand tilt for 90o (75owhen use vari-focus lens) which
provide you the capability to view all the spots around the places
where they are installed. The cameras also give you the capability
to program your own surveillance tour by setting presets of view
positions. The embedded server allows you to link this device to
network without use PC, and access the camera via IE browser.
You are also allowed for moving the lens manually.
You may use these cameras for Internet / WAN, intranet or local
networking surveillance. With the function given by the software,
you will be able to control the camera for rotation, preset setup,
recall and scan to form 24-hour surveillance from remote.
We suggest that you read this manual carefully in order to use the
dome properly.
..
User’smanual 4
Features
Compact Size
Built in video server for direct networking applications
Pan for 360oand tilt for 90o (75owhen use vari-focus lens)
Fast search speed of 300oper second
M-JPEG compression with excellent video quality
View position preset, up to 20 spots
Support IE browser for remote view
Resolution options to accommodate bandwidth variation
Easy to mount --- Embedded or bracket mount
Night vision capability (optional function)
..
User’smanual 5
Hardware Construction
Vari-focus Version
Day & Night Version
..
User’smanual 6
Step 2: Adjust The Focus
Loosen this screw on lens side, then
turn the lens until the most clear picture
is acquired by visual.
Tight the screw up again after the
adjustment is done
Step 1: Adjust View Angle
(zoom)
Loosen the screw on housing side,
turn the zoom adjustment ring to
the desired direction. “T” means to
acquire the target in far. “W” means
that you will see wider angle (bigger
scope)
IR LED x 9
(light source in dark)
Light Sensor
(to turn LED on / off) The sensor will turn IR LED on when
environment is dark (lower than 4 lux)
Day & Night Version --- The Light Source
Vari-focus Version --- To adjust the camera lens
..
User’smanual 7
Ethernet Port;
Connect it to the network
Use RJ-45 connector
Status Indicators
V
ideo Out From Camera
For local recording; To make it,
connect this to a DVR or VCR.
(use RCA to RCA / BNC cable)
DC INPUT
Use the supplied DC
12V / 1.5A adapter
Input, Output and Power Connections On IP Dome
..
User’smanual 8
Caution:
If you want to mount the dome to wooden wall, make sure the wood thickness is
not less than 1/2 inch (1.3 cm).
Mount The Camera
There are two ways to mount the camera.
1. Mount the camera on wall through camera holder (bracket)
2. Embed the camera into ceiling
Hang The Camera on Wall with Camera Holder (bracket)
The camera has a hole of 1/4” on the bottom cover, for camera
holder mounting application:
1. Get the camera holder
2. Mount the camera holder onto the desired place by following the
instructions given by the holder manual
3. Get the camera body and mate the hole on its base to the screw on
the camera holder.
4. Turn the screw all the way in until it stops. Keep screw a little loss until
the step 5 is finished
5. Rotate the camera to find the best direction so that wires will not be
bended during the wiring work
6. Tighten the screw now
..
User’smanual 9
Embed The Camera Into Ceiling or Wall
The camera can be embedded into ceiling or wall with the
assistance of the supplied decoration cover:
1. Drill a hole on the desired place with proper tools, in a diameter
between 4-1/8 inches (10.5 cm) and 4-1/4 inches (11 cm) – make
sure the hole is not too big nor too small
2. Get the camera and put the decoration cover on.
3. Rotate the camera body and make sure the camera body and
decoration cover are locked completely
4. Insert the camera body into the hole slowly. Make sure the wires
get through first
5. With the decoration cover touched to the mount surface, screw the
cover onto the surface tightly through the three screw holes on the
cover.
..
User’smanual 10
Specification
General
Scan / Search Navigation range Pan 360o
Tilt90
o
75o ( vari-focus lens)
Search speed Programmable,
up to 300o/ sec
View Position Programmable,
Max 20 positions
Dwell time Programmable,
Max 255 seconds
Communication Protocol RS-485
Video Output Format NTSC or PAL (optional)
Level 1.0 V (typical)
Power Input DC12
Connectivity Network RJ-45 ethernet connector
Video Output RCA
RS-485 communication RJ-11 phone jack
DC input jack
Operation Temperature 0 ~ 40℃
Humidity 20 ~ 90% RHD
Storage Temperature -20℃~ 70℃
Humidity 20 ~ 100% RHD
Certification FCC, CE (pending)
In the box IP Dome camera 1 set
User’s manual 1 set
Power adapter 1 set
ScrewPack 1set
Inhaltsverzeichnis
Andere 4xem Sicherheitskamera Handbücher
4xem
4xem WPTZ Bedienungsanleitung
4xem
4xem 4X-SD7313 Bedienungsanleitung
4xem
4xem WPT Bedienungsanleitung
4xem
4xem WLPTS Bedienungsanleitung
4xem
4xem W80 Bedienungsanleitung
4xem
4xem 4X-IP7160 Bedienungsanleitung
4xem
4xem W80 Bedienungsanleitung
4xem
4xem WFDV Bedienungsanleitung
4xem
4xem 4X-PZ7112 Bedienungsanleitung
4xem
4xem 4X-IP8330 Bedienungsanleitung
4xem
4xem WFDV Bedienungsanleitung
4xem
4xem WLPTZ Bedienungsanleitung
4xem
4xem 4X-IP7153 Bedienungsanleitung
4xem
4xem 4X-PZ7111 Bedienungsanleitung
4xem
4xem W45 Bedienungsanleitung
4xem
4xem 4X-FD8361 Bedienungsanleitung
4xem
4xem W45 Bedienungsanleitung
4xem
4xem WPTZ Bedienungsanleitung
4xem
4xem 4X-FD7132 Bedienungsanleitung
4xem
4xem WPTS Bedienungsanleitung
