A-EON 60111 Bedienungsanleitung
s
s
s2
7
ABC
Three positions allow you to select the best height for your TV set on the stand. Use the appropriate
hooked opening on the vertical bar (7) to determine TV height. Using the top hooked opening on vertical
bar (7) will set the TV lower on the stand, while the bottom hooked opening will set the TV higher on the
stand. Attach one of the three hooked opening to the upper cross bar of the TV stand.
7
Select Height for Your TV Set
A) With two people, lift TV into place to
hang vertical rails (part #7) on top cross
bar of TV stand. (see step 6 to determine
height)
B) Screw part “S” upwards through
appropriate angled metal tab to secure
both vertical rails onto TV bracket (see
figure below).
Tighten screw part
(S) to lock rails
onto TV bracket
Secure Vertical Rails to TV Bracket
Washer
Attach rubber feet (8) to
bottom of glass stand.
Note: Two people may be needed to hold parts
in place while tightening assembly.
A) Align parts on a flat surface per figure (3).
B) Insert two threaded rods (part C) through
parts shown in figure (3).
C) Tighten two screws (part A) until assembly is
tight using wrench (part R). Once tightened
properly the shelves should not be able to be
moved within the assembly. Do not over
tighten.
D) (Optional) Attach part (9) with screw (K)
using wrench (R). This is for wire management
on back of column.
Attach TV Bracket to Column Assembly
A) Stand up assembly from step (3) vertically.
B) Align plastic part (N) on TV bracket as seen in figure (4). Make
sure holes align.
C) Attach TV bracket in Figure (4) onto the two brackets shown in
figure (5). Tighten in two places with bolt (G), spacer (M) and nut (I).
Do not over tighten.
A) Carefully angle your TV against a wall with the back of the TV facing
you. Align the two vertical rails (part 7) with the screw holes on back of the
TV. Use appropriate screw size from included packet (see chart below).
B) Tighten screws until rails are tight. Do not over tighten. Use spacer
(part 5 in chart below) if the screw holes are recessed.
C) If needed, use square washer (part 6 in chart below).
Note: Make sure both rails are using same hole location to attach to
TV to ensure TV is level.
Andere A-EON Rack & Stand Handbücher
Beliebte Rack & Stand Handbücher anderer Marken
Salamander
Salamander Acadia AC/W/L400/WH Bedienungsanleitung
Fohhn
Fohhn VAT-09 Benutzerhandbuch
ricoo
ricoo FS0522 Bedienungsanleitung
AMSOIL
AMSOIL BMK-22 Kurzanleitung
Kargo Master
Kargo Master 48220 Bedienungsanleitung
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung
