ABB FDNA-01 Installationshandbuch

Options for ABB drives, converters and inverters

Quick installation and start-up guide

FDNA-01 DeviceNet adapter module

Safety instructions

WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the

equipment can occur. See the user’s manual.

Mechanical installation

Electrical installation

Layout of the module

1. Pull out the lock.

2. Install the module carefully to an option

module slot of the drive. See the drive

hardware manual.

3. Push in the lock.

4. Tighten the screw to torque 0.8 N·m using

a Torx TX10 screwdriver.

WARNING! Do not use excessive force,

or leave the screw too loose. Over-

tightening can damage the screw or

module. A loose screw decreases the EMC

performance, and can even cause an operation

failure.



No. Description

1Lock

2 Mounting and grounding screw

3 Bus connector [X1]

4 Diagnostic LEDs

Start-up

When the module is connected to the drive, the drive control program sets the applicable parameters.

See the appropriate drive manual.

Basic parameter settings

To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.

Further information

Index Name Value

20.01 Ext1 commands Fieldbus A

22.11 Speed ref1 source FBA A ref 1

28.11 Frequency ref1 source FBA A ref 1

50.01 FBA A enable Enable (or select the option slot in which the module is installed).

This activates the communication module. The HOST LED becomes green.

50.02 FBA A comm loss func Fault

51.02 MAC ID Set the MAC ID number for the drive.

See the latest version of FDNA-01 DeviceNet adapter

module user's manual (3AFE68573360 [English]) in ABB

library (www.abb.com/drives/documents).

For more information on fieldbus options and protocols

provided by ABB Drives, see the fieldbus

communications web page

(new.abb.com/drives/connectivity/fieldbus-connectivity).

Pin allocation for [X1] Bus termination

The module does not provide bus termination. The DeviceNet

network should be terminated at both ends of the trunk cable with

a 121 ohm, ¼ W, 1% metal film resistor.

Connect the resistor between the two signal wires (CAN_H,

CAN_L) on the DeviceNet cable, as shown in this figure.

Pin Description

1 V- Network power supply

ground (0V DC)

2 CAN_L CAN_L bus line

3 SHLD Network cable shield

4 CAN_H CAN_H bus line

5 V+ Network power supply

source (24V DC)

12345

Node 1 Node n

121



CAN_H

CAN_L

Scanner

121



Metal Film

1/4 W

Metal Film

1/4 W

…

3AXD50000158515 Rev A (EN) 2017-11-23

FDNA-01 manual

Fieldbus communications web page

Andere Handbücher für FDNA-01

Inhaltsverzeichnis

Andere ABB Steuereinheit Handbücher

ABB

ABB FENA-01 Installationshandbuch

ABB

ABB relion REF615 Bedienungsanleitung

ABB

ABB CMS-700 Bedienungsanleitung

ABB

ABB ACS880-34 Bedienungsanleitung

ABB

ABB NCAN-02 Installationshandbuch

ABB

ABB COM600 series Bedienungsanleitung

ABB

ABB RER 133 Stücklistenhandbuch

ABB

ABB ControlNet FCNA-01 Installationshandbuch

ABB

ABB CP1484 Bedienungsanleitung

ABB

ABB ACS880-304 +A003 Series Bedienungsanleitung

ABB

ABB SafeRing Bedienungsanleitung

ABB

ABB ACH550 series Bedienungsanleitung

ABB

ABB EBS852 Bedienungsanleitung

ABB

ABB REF542plus Leitfaden

ABB

ABB CMS-660 Bedienungsanleitung

ABB

ABB UCU-22 Bedienungsanleitung

ABB

ABB A3 Series Bedienungsanleitung

ABB

ABB FEPL-02 Ethernet POWERLINK Installationshandbuch

ABB

ABB RED615 ANSI Gebrauchsanweisung

ABB

ABB IEC 60870-5-103 Bedienungsanleitung

ABB

ABB Relion 615 series Datenblatt

ABB

ABB TA571-SIM Bedienungsanleitung

ABB

ABB Arc Guard System TVOC-2 Produkthandbuch

ABB

ABB Busch-ComfortTouch 9 Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung