Ace Superdryer 62 Bedienungsanleitung

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 1

Superdryer

ehumidifiers

Distributed Exclusively By: Manufactured by:

Air Cleaning Equipment, Inc.

Broadway, NC 27505

Phone: 919-258-3330

www.AirCleaningEquipment.com

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 2

Safety Notes:

•The Superdryer Series Dehumidifier must always be connected using the grounded

electrical connection as required from all electrical appliances. The warranty is voided

and all responsibility for the operation is born by the owner if non-grounded wiring is

utilized.

•The Superdryer Dehumidifiers must only be maintained and serviced by a qualified

technician.

•The Superdryer Dehumidifiers are designed to be transported and operated in the

vertical position. Any other orientation could cause water to come in contact with the

electrical components. Remove plug before moving dehumidifier. If any water may

have spread throughout unit, the unit should be opened and allowed to dry thoroughly

before reconnected to electric and restarting.

•For proper operation, neither the inlet nor discharge should be positioned against a

wall. The inlet requires a minimum of 12” clearance and the discharge needs a

minimum of 48” clearance.

•If the unit is utilized in a narrow room, the unit should be positioned so that the inlet

and discharge are facing the longest straight runs.

•Do not insert any objects into the inlet or discharge. If service is required, call a

qualified technician. All work on unit should be done with the unit “off” and

unplugged.

•Do not use water to clean unit exterior. Only use a damp cloth with unit unplugged.

•Do not use unit as shelf or device to hang clothes. This could cause damage to unit.

•The inlet filter generally needs cleaned once per month. Check unit on a weekly basis

to insure that more frequent cleaning is not required.

Pertinent Technical Standards and Regulations:

The Superdryer dehumidifier has been designed and manufactured to all the following

European Standards (Norms) and Regulations:

•MACHINES NORMS (D.P.R., NR. 459 - 24th July 1996) ;

•SECURITY REGULATIONS FOR LOW TENSION APPLIANCES 2006/95/CE);

•ELECTROMAGNETIC COMPATIBILITY (EMC) – 2004/108/CE.

•It is hereby certified that this Dehumidifier conform to the:

•IEC Regulations CEI-EN 60335-2-40, CEI-EN 55014-1, 55014-2.

•The machine is built according to RoHS European Norms

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 3

Identification:

For future reference, write down the model, serial number, date of purchase and use this

information whenever corresponding concerning your dehumidifier.

Model Number Superdryer 62

Serial Number _____________________________

Date of Purchase _____________________________

Customer Service:

For additional questions concerning the operation of your dehumidifier, please:

Contact your installing contractor

Please call ACE at 919-258-3330

Email: [email protected]

Warning

120 Volts AC may cause serious injury from electric shock.

1. Disconnect electrical power before servicing or moving

2. Plug unit only into grounded electrical outlet

3. Do not use extension cord

4. Do not use plug adapter

Power Supply: 115V, 60 Hz, Single Phase

Outlet Requirement: 3-Prong

Circuit Protector: 15 Amp Time Delay Fuse or Circuit Breaker

Principle of Operation

The Superdryer Series Dehumidifier utilizes its integral humidistat to monitor the conditioned

space. When the relative humidity goes above the selected set point, the dehumidifier will

energize. Air is drawn across an evaporator coil. The evaporator coil is cooler than the dew

point of the air so moisture will condense out of the air (below 70°F you will actually see ice

forming on the evaporator coil). Air is then reheated through the condenser coil and

distributed back into the room.

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 4

Unit Set-Up

The unit will only function properly in a closed area. All windows and doors must be closed

to allow “drying” to occur.

WARNING: It is recommended to remove dehumidifier from area if applying a liquid

vapor barrier. Some coatings dry via “solvent evaporation,” which can be harmful to certain

components in your dehumidifier. Allow coating to completely dry and exhaust vapors prior

to positioning dehumidifier. Read and follow coating manufacturer’s instructions completely.

Place dehumidifier on level surface

WARNING – If during handling, the dehumidifier is moved in such a manner that the

compressor didn’t remain in a vertical orientation, wait a minimum of 2 hours before turning

the unit “on.”

Route drain line (3/4” ID tubing on gravity drain, 3/8” ID tubing on units with

condensate pump) to drain or outside of the area. Note: On units with gravity drain,

Drain line must have a downward slope to drain. (Not applicable to units with

reservoirs)

Reference: (Fig. 1/2), De-

humidistat (7) starts the functioning

of the dehumidifier when the humidity

is higher than the preset level. Air is

drawn in through the filter (1) flows

through the aluminium refrigerated

coil/ evaporator (2), through the

heat exchanger/ condenser (3).

Finally, the motor fan (4) expels the

air back into the room through the

front grilled panel. The condensed

water is collected in the tank (5). A

micro-switch (6) stops the machine

when the water in the tank reaches

the correct level activating the full

circuit. An electronic circuit (8)

controls the defrosting and prevents

the compressor (9) from short

cycling.

Fig. 1

Machines with water

reservoir Fig. 2

Machines with condensate pump

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 5

Plug unit into 15 amp grounded outlet.

To operate unit, turn humidistat knob clockwise until unit energizes.

oUnit will run fan only for approximately 2 minutes and than compressor will

energize.

oConfirm compressor is running and allow to run for minimum of 15 minutes

If under 70°F, a layer of ice will form on evaporator coil

If over 70°F, a layer of frost or water droplets will form on coil

After you’ve confirmed satisfactory operation of unit, humidistat should be set at

desired position for automatic operation.

Position of Dehumidistat Knob 1 2 3 4 5___________________

Approximate Room Setpoint 70% 60% 48% 35% 25% Relative Humidity

•In “OFF” the machine will never start

•In “CONT” the machine will never stop

NOTE: Humidistat settings are approximate only. For critical applications, you may

want to confirm actual settings with a psychrometer and adjust according.

Display Panel Indications:

•“Power” Indication: Red light illuminates when unit is plugged into outlet

•“Full” Indication: Green light illuminates when either water tank is “full” or

condensate pump is not working properly. When light is “on”, unit will be in “off”

condition.

•“Defrost” Indication: Red light illuminates during initial “soft-start” or any normal

defrost cycle.

•“Working” Indication: Red light illuminates (together with “Power” light) when

machine is operating in normal dehumidification mode.

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 6

Operation

During normal operation, the dehumidifier will automatically cycle “on” and “off” to maintain

your desired set point. If it should need to run for extended periods of time, the

dehumidifier features an automatic defrost cycle to melt any ice that accumulates on

evaporator coil. Approximately every 35 minutes of continuous operation, the unit will test

for the need for a defrost cycle. If required, it will defrost for approximately 3 minutes.

Warning: Never apply an external source of heat to melt ice off coil.

Maintenance – Annual Inspection of Coils and drain line is required.

1. Unplug Unit

2. Filter may be cleaned by

a. Vacuuming

b. Washing with warm, soapy water. Rinse and shake dry.

3. Coils may be cleaned by

a. Vacuuming the external surfaces of coil

b. Blowing compressed air from behind coils. Hold air nozzle 6” away from coil to

avoid damage.

Warning: Do not steam clean refrigerant coils.

4. Plug in Unit

5. Test Refrigerant Charge

a. Confirm compressor is running and allow to run for minimum of 15 minutes

i. If under 70°F, a layer of ice will form on evaporator coils

ii. If over 70°F, a layer of frost or water droplets will form on coil

6. Test Defrost System

a. Leave unit running for approximately 35 minutes (45-55 minutes). The unit

should enter a defrost mode for approximately 3 minutes. The unit will run fan

only for a period of time and then check the temperature of the coil. If

necessary, the unit will enter a defrost mode with the compressor operating

and fan off to defrost the coil If the unit will not defrost, either

i. Control board may be defective

ii. Bypass valve may be defective

7. After routine maintenance has been completed, return humidistat to desired setting.

8. When you are ready to move unit, depress button on condensate pump (while unit is

“on”) to drain condensate or empty water tank prior to moving. This will prevent

water from splashing on inside of unit.

If any problems occur during routine maintenance, contact your contractor or the factory.

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 7

Specifications:

MODEL Superdryer 62

HEIGHT 21”

WIDTH 21”

LENGTH 36”

WEIGHT 102.00 LBS

AIRFLOW 360 CFM

MOISTURE REMOVAL

AT 80F/60% RH 65 PINTS PER DAY

POWER SUPPLY 115 VOLT/60 HERTZ SINGLE

PHASE

FINISH POWDER-COATED EPOXY

OPERATING RANGE 33 F TO 90 F

REFRIGERANT R-22

CONDENSATE DRAIN SIZE 3/8” Tube on Pump

AMPS (FULL LOAD)

AT 80F/60% 5.8 FLA

POWER CORD 20’ GROUNDED PLUG

FILTER SIZE 13.5” x 12”

Troubleshooting:

1. Unit will not operate

a. Insure unit is plugged in and red “power” lamp is illuminated

b. Insure humidistat is set to high enough level to operate.

c. If unit plugged in and red “power” lamp is “off”, check fuse or breaker for

outlet to make sure power is getting to unit

2. If green “full” light is “on”

a. On units with reservoir, insure reservoir is empty and properly placed back in

unit to allow operation

b. On units with condensate pump, check that drain line is not blocked preventing

pump from discharging water to drain.

__________________________________________________________________________________

Superdryer 62 Owner’s Manual 8

Warranty

Seller warrants the equipment to be free from defects in workmanship and material for a

period of 12 months after shipment (36 months on compressor). This warranty is limited,

however, to the repair or replacement of defective equipment, which is returned, freight

prepaid, to the Seller’s factory.

This limited warranty does not apply to any part or component that is damaged in transit or

when handling, has been subject to misuse, has not been installed, operated or serviced

according to the Seller’s instructions, or has been operated beyond the factory-rated capacity

or has been altered in any way. Routine maintenance is not covered by this warranty.

Seller’s liability is limited to replacement of defective parts or components and does not

include any cost of labor (including, but not limited to, labor to remove and/or reinstall any

defective part).

ACE/Fral shall not be responsible for loss of use of any product, loss of time, inconvenience,

or damage to other equipment, or any other indirect or consequential damage with respect

to property whether as a result of breach of warranty, neglect, or otherwise.

THE WARRANTIES AND LIABILITIES SET FORTH ARE IN LIEU OF ALL OTHER

WARRANTIES EXPRESSED OR IMPLIED, IN LAW OR IN FACT, INCLUDING

IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR

PURPOSE.

The foregoing shall constitute the total liability of seller in the case of defective performance

of all or any of the equipment or services provided to Buyer. Buyer agrees to accept and

hereby accepts the foregoing as the sole and exclusive remedy for any breach or alleged

breach of warranty by Seller.

Inhaltsverzeichnis

Andere Ace Luftentfeuchter Handbücher

Ace

Ace Horizon Series Bedienungsanleitung

Beliebte Luftentfeuchter Handbücher anderer Marken

Daitsu

Daitsu CD031IU-DFA Bedienungsanleitung

Fehom

Fehom PDGT701BE Bedienungsanleitung

Hitachi

Hitachi RD-190GX Bedienungsanleitung

Westpoint

Westpoint MDF1-30AE Bedienungsanleitung

SOLIS

SOLIS easy dry compact Bedienungsanleitung

ENVIROBOSS

ENVIROBOSS EB240 Bedienungsanleitung

Sinclair

Sinclair R-9112 Bedienungsanleitung

Kenmore

Kenmore 580.54701 Bedienungsanleitung

Demargo

Demargo DM828NF Bedienungsanleitung

Altrad Lescha

Altrad Lescha LDH 600 Bedienungsanleitung

BOMANN

BOMANN LE 1150 CB Bedienungsanleitung

SPT

SPT SD-46 Bedienungsanleitung

REMKO

REMKO SLN 40 Bedienungsanleitung

Haier

Haier HD458 Bedienungsanleitung

Logik

Logik L20DHW12 Bedienungsanleitung

Frigidaire

Frigidaire FDR30S1 - 30 Pint Capacity Dehumidifier Kurzanleitung

Blitz

Blitz HHD Series Bedienungsanleitung

Prem-I-Air

Prem-I-Air PD14DEN Bedienungsanleitung