Adaptec APA-1350 Bedienungsanleitung
R
User’s Guide
MiniSCSI 1350
Parallel Port to SCSI Adapter
APA-1350
Adaptec, Inc.
691 South Milpitas Boulevard
Milpitas, CA 95035
© 1998 Adaptec, Inc.
All rights reserved. Adaptec, and the Adaptec logo are trade-
marks of Adaptec, Inc. which may be registered in some
jurisdictions.
Printed in Singapore
STOCK NO.: 512111-00, Rev. A BKB 6/98
R
R
▼ ▼ ▼ ▼ MiniSCSI 1350
Parallel Port to SCSI Adapter
User’s Guide
▼ ▼ ▼ ▼ Contents
Introduction 1
Contents of Kit 1
System Requirements 1
Installing the MiniSCSI 1350 2
Software Installation 4
Windows 95 Software Installation 4
Printers 5
Uninstalling the Drivers 6
Understanding SCSI 7
SCSI IDs 7
Terminating the SCSI Bus 8
Obtaining SCSI Cables 8
Connector Types 9
Troubleshooting 10
General Hardware Troubleshooting 10
WINDOWS 95 Troubleshooting 11
Improving Overall Performance 12
Formatting your hard disk drives in Windows 95 13
Contacting Adaptec 15
Electronic Support 15
Technical and Product Support 16
Sales and Ordering Information 16
1
Introduction
Thank you for purchasing the Adaptec MiniSCSI 1350. The
MiniSCSI 1350 is the ideal solution for Plug & Play SCSI connections
to CD-ROMs, Scanners, Hard Disks, SyQuest, Iomega, Tape, MO
drives and other peripherals. It’s fast, easy installation adds full
SCSI flexibility to your Portable or Desktop PC without the hassle
and cost of plug-in host adapters. Simply plug it into your PC’s
parallel port and you’re set.
Contents of Kit
■MiniSCSI 1350 Parallel Port to SCSI Adapter
■User’s Guide
■Registration Card
■Windows 95 Setup Diskette
System Requirements
■Supports 486 and Pentium based portable or desktop systems.
■Operates on Standard, Unidirectional, Bidirectional, PS/2, EPP
and ECP (IEEE 1284) parallel ports.
2
MiniSCSI 1350 User’s Guide
Installing the MiniSCSI 1350
Follow the steps below to install the MiniSCSI 1350 and connect
your SCSI devices to it. Refer to Figure 1 on page 3 for an illustration
of a typical installation.
1
Connect the 50-pin interface plug to the SCSI interface socket
on your peripheral device.
2
Plug the 25-pin interface plug into a parallel-printer connector
on your computer.
3
Optional: If a printer cable is already attached to the connector,
unplug it and connect it to the 25-pin socket on the MiniSCSI
1350.
Note:
This is a pass-through printer connection that
will allow printing while your SCSI peripheral is in
use.
4
Ensure that your SCSI peripheral is properly terminated and
then switch on power to your SCSI peripheral. The green
power indicator on the MiniSCSI 1350 will now be illuminated
and you are ready to install the software.
3
Installing the MiniSCSI 1350
Note:
For the pass-through function to operate, your
SCSI peripheral must be connected and powered up
because the MiniSCSI 1350 uses the power on the SCSI
bus.
Figure 1. Typical Installation
50-pin Interface Plug
25-Pin Socket
25-Pin Interface Plug
SCSI Device
Laptop
Printer
4
MiniSCSI 1350 User’s Guide
Software Installation
To use your MiniSCSI 1350, you have to install software drivers on
your computer. This one time process is described below.
Note:
Before you begin, we recommend that you make
copies of the diskettes that came with your MiniSCSI 1350.
Before you begin, close any application you may have running
before installing the MiniSCSI 1350 software drivers.
Windows 95 Software Installation
1
Start Windows 95.
2
Insert the diskette labeled APA-1350 Setup Diskette into floppy
drive A.
3
Double-click on the My Computer icon.
4
Double-click on the Floppy Drive A.
5
Double click on the SETUP icon. The installation process will
begin. Follow the on-screen instructions until the installation
is complete. At the end of the installation process, a text file
called
README.TXT
will be displayed. This file contains
additional installation instructions, a troubleshooting section,
and un-install instructions.
Note:
README.TXT
can also be viewed at any later
time using Notepad. It will be copied to the folder on
the hard disk where the APA-1350 drivers have been
installed. The default directory is C:\MINISCSI.
After installation the devices can be accessed through Microsoft
Windows 95’s My Computer or Explorer applications. Audio CDs
can be played using CD-Player in the Multimedia group of the
Accessories section of the Program menu.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Adaptec Adapter Handbücher
Adaptec
Adaptec 9210LP Service-Handbuch
Adaptec
Adaptec Trantor T160 Handbuch
Adaptec
Adaptec AVA-2902E Bedienungsanleitung
Adaptec
Adaptec SlimSCSI APA-460 Handbuch
Adaptec
Adaptec 9110G Service-Handbuch
Adaptec
Adaptec AFW-1430 Bedienungsanleitung
Adaptec
Adaptec Trantor T260 Handbuch
Adaptec
Adaptec 5ANA-940 Bedienungsanleitung
Adaptec
Adaptec 131CA - AAA RAID Controller Montageanleitung
Adaptec
Adaptec USBConnect2000 Bedienungsanleitung
Adaptec
Adaptec ASH-1233 Bedienungsanleitung
Adaptec
Adaptec AIC-7890 Bedienungsanleitung
Adaptec
Adaptec AHA-1510A Series Bedienungsanleitung
Adaptec
Adaptec USB2Xchange Bedienungsanleitung
Adaptec
Adaptec Cogent ANA-6901 Combo Bedienungsanleitung
Adaptec
Adaptec AHA-3980 Bedienungsanleitung
Adaptec
Adaptec AHA-1540C Bedienungsanleitung
Adaptec
Adaptec AAA-UDMA Bedienungsanleitung
Adaptec
Adaptec PCI Ethernet and Fast Ethernet Adapters Bedienungsanleitung
Adaptec
Adaptec XHub2 - Hub - USB Bedienungsanleitung
