Adaptec AAA-130U2 SERIES Montageanleitung
INSTALLATION AND
HARDWARE GUIDE
AAA-130U2 SERIES
ULTRA2 SCSI RAID CARD
Adaptec, Inc.
691 South Milpitas Boulevard
Milpitas, CA 95035
R
© 1999 Adaptec, Inc.
All rights reserved. Adaptec, and the Adaptec logo
are trademarks of Adaptec, Inc. which may be regis-
tered in some jurisdictions.
Printed in Singapore
STOCK NO.: 512278-00, Rev. A RQ 2/99
R
▼ ▼ ▼ ▼ AAA-130U2 Series
Ultra2 SCSI RAID Card
Installation and Hardware Guide
ii
Copyright
© 1999 Adaptec, Inc. All rights reserved. No part of this publication may be repro-
duced, stored in a retrieval system, or transmitted in any form or by any means, elec-
tronic, mechanical, photocopying, recording or otherwise, without the prior written
consent of Adaptec, Inc., 691 South Milpitas Blvd., Milpitas, CA 95035.
Trademarks
Adaptec, the Adaptec logo, AAA, AHA, AIC, Array1000, ARRAYCONFIG,
CI/O, Adaptec CI/O Management Software, and SCSISelect are trademarks of
Adaptec, Inc. which may be registered in some jurisdictions.
Windows is a registered trademark and Windows NT is a trademark of Microsoft Cor-
poration in the U.S. and other countries used under license.
All other trademarks are owned by their respective owners.
Changes
The material in this document is for information only and is subject to change with-
out notice. While reasonable efforts have been made in the preparation of this docu-
ment to assure its accuracy, Adaptec, Inc. assumes no liability resulting from errors or
omissions in this document, or from the use of the information contained herein.
Adaptec reserves the right to make changes in the product design without reservation
and without notification to its users.
Disclaimer
IF THIS PRODUCT DIRECTS YOU TO COPY MATERIALS, YOU MUST HAVE PER-
MISSION FROM THE COPYRIGHT OWNER OF THE MATERIALS TO AVOID VIO-
LATING THE LAW WHICH COULD RESULT IN DAMAGES OR OTHER
REMEDIES.
iii
Federal Communications Commission Radio Frequency Interference Statement
WARNING: Changes or modifications to this unit not expressly approved by the party responsi-
ble for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. However, if this equipment does cause
interference to radio or television equipment reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/television technician for help.
Use a shielded and properly grounded I/O cable and power cable to ensure compliance of this
unit to the specified limits of the rules.
This device complies with part 15 of the FCC rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Canadian Compliance Statement
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matérial
brouilleur du Canada.
Adaptec, Inc.
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
AAA-131U2,
AAA-133U2
v
▼ ▼ ▼ ▼ Contents
1 Introduction
System Requirements 1-2
Installation Overview 1-3
2 Installing the Hardware
AAA-131U2/133U2 RAID Card Layout 2-2
Installing DIMM Memory 2-3
Installing the AAA-131U2/133U2 2-4
Connecting the LED Activity Indicator 2-5
Setting Up SCSI Devices 2-6
Check the SCSI IDs 2-6
Terminate the Ends 2-7
Additional Hints for Connecting SCSI Devices 2-8
Connecting SCSI Devices 2-9
Internal Ultra2 SCSI Connector (68-pin) 2-10
Internal Ultra SCSI Connector (50-pin) 2-13
External Ultra2 SCSI Connector (68-pin) 2-16
External SCSI Array Enclosures (Storage
Subsystems) 2-18
Configuring the AAA-131U2/133U2 2-19
3 Creating an Array With the ARRAYCONFIG U2
Utility
Creating an Array 3-2
Creating an Array with Express Setup 3-2
Creating an Array with Custom Setup 3-4
Making the Array Bootable 3-8
vi
AAA-130U2 Series Installation and Hardware Guide
4 Installing the Software Driver for Windows NT
Installing the Array1000U2 Driver for Windows NT 4-2
Installing the Driver When Installing Windows NT 4-2
Installing the Driver When Windows NT is Already
Installed 4-4
Windows NT Installation and Configuration Notes 4-5
5 Installing the Software Driver for Novell NetWare
Installing the Array1000U2 Driver for Novell NetWare 5-2
Installing the Driver When Installing NetWare 5-2
Installing the Driver When NetWare is Already
Installed 5-7
Netware Installation and Configuration Notes 5-8
6 Installing the Software Driver for SCO UnixWare
Installing the Array1000U2 Driver for UnixWare 6-2
Installing the Driver When Installing SCO
UnixWare 6-2
Installing the Driver When SCO UnixWare is Already
Installed 6-3
A Using SCSI
Select
and Disk Utilities
SCSISelect Default Settings A-2
Starting the SCSISelect Utility A-3
Using SCSISelect Menus A-3
Exiting SCSISelect A-3
Using the SCSI Disk Utilities A-4
SCSISelect Settings A-5
SCSI Bus Interface Definitions A-5
SCSI Device Configuration A-5
Additional Options A-6
B Troubleshooting
Troubleshooting Checklist B-1
Windows NT Troubleshooting B-2
Error Messages While Setting Up Windows NT B-2
vii
Contents
C Using a CD-ROM Drive
Using a CD-ROM Drive with DOS C-1
D Obtaining SCSI Cables
External Cables D-2
External Connector Diagrams D-2
Internal Ribbon Cables D-2
Internal Connector Diagrams D-2
Index
❒
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere Adaptec Computerhardware Handbücher
Adaptec
Adaptec 2045 Bedienungsanleitung
Adaptec
Adaptec RAID Solutions Handbuch
Adaptec
Adaptec AUA-3100LP Handbuch
Adaptec
Adaptec 9110G Bedienungsanleitung
Adaptec
Adaptec RAID 2405Q Bedienungsanleitung
Adaptec
Adaptec RAID 6405E Bedienungsanleitung
Adaptec
Adaptec RAID 2405 Bedienungsanleitung
Adaptec
Adaptec ACB-232XD Bedienungsanleitung
Adaptec
Adaptec SAS RAID Controllers Bedienungsanleitung
Adaptec
Adaptec 6405 Bedienungsanleitung
Adaptec
Adaptec AAA-131U2 Bedienungsanleitung
Adaptec
Adaptec ACB-2370 Bedienungsanleitung
Adaptec
Adaptec ACB-2010A Bedienungsanleitung
Adaptec
Adaptec PowerDomain 29160 Bedienungsanleitung
Adaptec
Adaptec AAR-1420SA Bedienungsanleitung
Adaptec
Adaptec 7210S Gebrauchs- und Pflegehandbuch
Adaptec
Adaptec ACB-2320 Bedienungsanleitung
Adaptec
Adaptec ASR-3085 Betriebsanleitung
Adaptec
Adaptec PowerDomain 2940UW Bedienungsanleitung
Adaptec
Adaptec 2045 Bedienungsanleitung
Beliebte Computerhardware Handbücher anderer Marken
EMC2
EMC2 VNX Series Betriebsanleitung
Panasonic
Panasonic DV0PM20105 Bedienungsanleitung
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung
Gigabyte
Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung
Raidon
Raidon iT2300 Bedienungsanleitung
National Instruments
National Instruments PXI-8186 Bedienungsanleitung
