Addonics Technologies Pocket DVD Bedienungsanleitung
Addonics
TECHNOLOGIES
Pocket DVD
USB
FIREWIRE
Serial ATA
CardBus/PCMCIA
Users Guide
Revision 5.0
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class
B digital device pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy. If not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment on and off, the user is
encouraged to try and correct the interference by one or more of the following
suggestions.
• Reorient or relocate the receiving antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to a different power outlet other than the
one where receiver is connected
• Consult a certified television or radio technician
Addonics Technologies – Pocket DVD Users Guide v5.0 1
Contents
FCC Warning.......................................................................................1
Contents................................................................................................2
Chapter 1 Getting started......................................................................3
Power and Cable Installation...............................................4
Chapter 2 USB Cable Installation........................................................5
Firewire Cable Installation ..................................................6
Cardbus/PCMCIA Cable Installation ..............................7-9
Serial ATA Cable Installation ...........................................10
Chapter 3 Software Installation..........................................................11
Chapter 4 Installing Windows OS.................................................12-14
Chapter 5 Playing Audio CDs............................................................14
Technical Support & Contact Information .....................................…15
Addonics Technologies – Pocket DVD Users Guide v5.0 2
Chapter 1
Getting Started
This chapter will walk you through the installation of your external Pocket
DVD. Make sure that you have the following items:
For DVD with Firewire Cable
! Pocket DVD Drive
! Firewire cable with 36 pin connector
! DVD Decoding Software
! USB Power Cable
! AC/DC adapter
! This User Guide
For DVD with Cardbus/PCMCIA Cable
! Pocket DVD Drive
! CardBus/PCMCIA cable with 36 pin connector
! DVD Decoding Software
! USB Power Cable
! AC/DC adapter
! Driver Disc
! This User Guide
For DVD with USB2.0 Cable
! Pocket DVD Drive
! USB cable with 36 pin connector
! DVD Decoding Software
! USB Power Cable
! AC/DC adapter
! Driver Disc
! This User Guide
For DVD with Serial ATA Cable
! Pocket DVD Drive
! Serial ATA cable with 36 pin connector
! DVD Decoding Software
! USB Power Cable
! AC/DC adapter
! This User Guide
Addonics Technologies – Pocket DVD Users Guide v5.0 3
Pocket DVD Power and Cable Connections
MC-36
Connector
AC/DC Adapter
Input Jack
Diagram 1
Switch Setting
Power from AC Adapter = to the Right
Power from Computer = to the left
USB Power Cable
You can use the USB port of your computer to power any Addonics Pocket
Device. One end connects to the USB port of the computer and the other end
connects to the power input of the Addonics drive.
NOTE: Not all Computers’ USB port can provide enough power to the USB
device.
Addonics Technologies – Pocket DVD Users Guide v5.0 4
Chapter 2
USB Cable Installation
Attach the USB-IDE cable’s “MC 36 Connector” to your Addonics Pocket
Drive firm and securely – you should not be able to disconnect the cable without
pressing the release notch.
USB drivers Installation
For Win98 and Win98SE
1. Make sure your computer is up and running
2. Verify that all cables are connected and there is power to the
drive.
3. Insert the USB cable to the USB Port.
4. A "New Hardware Found" message shall pops up.
5. Follow wizard and point to the location of the driver. (Follow
the steps from the Driver Disc to where you saved the driver
files)
6. Let Windows finish the installation and that’s it.
7. Double click My Computer icon and see if you have an extra
drive letter for the drive.
8. You may now access the drive.
For Windows Me, 2000 and XP
There are NO additional drivers required
Addonics Technologies – Pocket DVD Users Guide v5.0 5
Firewire Cable Installation
Attach the FIREWIRE-IDE cable’s “MC 36 Connector” to your Addonics
Pocket Drive firm and securely – you should not be able to disconnect the cable
without pressing the release notch.
Firewire Installation
For Win98SE, Me, Win2000 and XP
(Note for Win98SE only: After plugging in the cable some system might
prompt you for Win98SE CD, in case you don’t have The Win98SE CD and the
wizard prompt you for
b. NTMAP.SYS please type C:\WINDOWS\SYSTEM32\DRIVERS
c. NTMAPHLP.PDR please type C:\WINDOWS\SYSTEM\IOSUBSYS
IF the system did not prompt you for anything just follow the steps below)
1. Make sure the Firewire cable is securely attach from the back of the drive.
2. Make sure that power is attached and turned on.
3. Power on the system, on the Window Desktop, double click on the
MY COMPUTER icon.
4. Plug the Addonics 6 Pin FIREWIRE-IDE cable into your computer’s
FIREWIRE port.
5. Wait for a few seconds, your computer may blink for a moment.
6. Double Click on the “My Computer” icon if not open yet. Your Pocket
DVD will appear as a CD drive icon. You are now ready to use the
DVD Drive.
Note: for computer that has a 4-pin firewire port, you will need to get a 6 to 4
pin Firewire adapter.
Addonics Technologies – Pocket DVD Users Guide v5.0 6
CardBus / PCMCIA Interface Cable
The Addonics CardBus/PCMCIA card has an option switch can allow you
to choose using either PCMCIA mode or CardBus mode. The switch
position is as follows:
PCMCIA
CardBus
Side View
Front view
Cardbus and PCMCIA
selection switch.
CardBus mode – move the
switch to the side with the
DOT indicato
r
Factory default setting
is CardBus mode
CardBus mode supports WIN 95/98/ME/2000/XP.
For DOS, WIN 3.1x and WIN NT, the switch must be set in
PCMCIA mode.
For Power and Cable Installation please refer
to page 5
Addonics Technologies – Pocket DVD Users Guide v5.0 7
CardBus/PCMCIA driver Installation
For Windows 95, 98, 98SE and Me
(Do not run the SETUP program from the driver disk, SETUP
Is for DOS or WIN 3.1 using PCMCIA mode only)
1. Power on your system and wait for the Desktop screen.
2. Connect the CardBus/PCMCIA cable and external AC/DC adapter into
the back of your Pocket DVD.
3. Plug the CardBus / PCMCIA card end of the cable into the PCMCIA
slot on the side of your computer.
4. The system will automatically identify the new card and ask to load the
driver.
5. Insert the driver diskette in “A” drive and follow the instruction on the
screen to load “Addonics CardBus IDE Controller”. Follow wizard and
point to the location of the driver. (Follow the steps from the Driver
Disc to where you saved the driver files)
6. When installation is finished, a PCMCIA card icon will appear in the
lower right-hand of the Window’s system tray.
7. Double Click on the “My Computer” icon. Your Pocket DVD will
appear as a CD drive icon. You are now ready to use the Pocket DVD
drive.
PCMCIA Installation for Windows NT
1. Go to Start\Settings\Control Panel
2. Double Click SCSI adapter icon
3. Click on the Driver Tab
4. Click Add to add new driver
5. Follow wizard and point to the location of the driver. (Follow the steps
from the Driver Disc to where you saved the driver files)
6. Select “Addonics PCMCIA…” then click ok.
7. Windows will prompt you for driver location again, to continue
Example Type in A:\NT then click continue.
8. Click YES to restart your computer.
Note: You must insert the PCMCIA cable when system is off.
Addonics Technologies – Pocket DVD Users Guide v5.0 8
CardBus/PCMCIA Installation for Windows 2000
1. Make sure your computer is up and running
2. Verify that all cables are connected and there is power to the drive.
3. Insert the PCMCIA cable to the PCMCIA socket.
4. A "New Hardware Found" message shall pops up.
5. Select "Next" to continue installation.
6. Select "Search for a suitable driver...." button and select "Next".
7. In "select a Device Driver page", select "Have Disk" to specify
location. Follow wizard and point to the location of the driver. (Follow
the steps from the Driver Disc to where you saved the driver files)
Select "Addonics CardBus...." click YES for the Windows warning
message and let Win2000 to finish the Installation and that's it.
8. Double Click on the “My Computer” icon. Your Pocket DVD
Will appear as a CD drive icon. You are now ready to use the
DVD drive.
CardBus/PCMCIA Installation for Windows XP
Make sure that all cables are properly connected and the drive has power.
1. If you are using the Pocket drives, make sure that the power brick has a
steady green light.
2. Boot your computer to Windows.
3. Plug in the Cardbus/PCMCIA cable to the Computer's PCMCIA Socket/Port
then insert the card to the Computer.
4. Windows should now find a new hardware and ask for the driver location.
5. Follow the Wizard. Click next to Continue.
6. Follow wizard and point to the location of the driver. (Follow the steps from
the Driver Disc to where you saved the driver files) example browse to your
floppy drive and go to the A:\Win2kXp folder.
7. Select the WinXP driver then click OK, Click next to continue.
8. Click the "Continue Anyway" to proceed.
9. Let the OS install the Driver and that's it. Click Finish.
10.Click YES to restart the Computer if prompted and that's it.
Addonics Technologies – Pocket DVD Users Guide v5.0 9
Inhaltsverzeichnis
Andere Addonics Technologies DVD-Laufwerk Handbücher
Addonics Technologies
Addonics Technologies Mobile DVDR/RW Bedienungsanleitung
Addonics Technologies
Addonics Technologies ZDVRRWESU Bedienungsanleitung
Addonics Technologies
Addonics Technologies DVD R/RW Bedienungsanleitung
Addonics Technologies
Addonics Technologies AEMDVRBY Bedienungsanleitung
Addonics Technologies
Addonics Technologies ZDVRRWESU Bedienungsanleitung
Addonics Technologies
Addonics Technologies Mobile DVD/CDRW Bedienungsanleitung
